Page 28 of 273

1BEFORE DRIVING YOUR VEHICLE
14
B150B01P-GAT (Truck) (If installed) The central door locking system is located on the driver's door lock but-ton. It is operated by depressing the door lock button. If the front door is open when the button is depressed,the door will lock when closed. NOTE: When the front door lock button is depressed, the front doors will lock. When the front door lock button is pulled up, the front doors will un-lock.
B150A01P-GAT CENTRAL DOOR LOCKS (Minibus/Van) (If installed)
The central door locking system is located on the driver's door lock but-ton. It is operated by depressing the door lock button. If the rear door is open when the button is depressed,the door will remain locked when closed. If the front door is open when the button is depressed, the door willlock when closed. NOTE: When the front door lock button is depressed, the front and slide doorswill lock. When the front door lock button is pulled up, the front and slide doors will unlock.The operation of the tailgate door locking is identical to the central door locking system.
B130B02P
Lock
Unlock
B130B01P
Page 34 of 273
1BEFORE DRIVING YOUR VEHICLE
20
1. Pull the tail gate open cover.
2. Insert the finger into the tail gate
opening hole, and pull upward the lock rod (thin rod), and press down the outside handle rod (thick rod) toopen the tailgate.
When the tail gate is locked
lock rod outside handlerod
B190B04P
B190B02P-GAT Operation from inside the vehicle (Van)
1. When the tail gate is unlocked, pull the tail gate open cover. B190B01P
B190B02P 2. Insert the finger into the tail gate
opening hole, and press down the outside handle rod to open the tailgate. B190B03P
Page 95 of 273
2 INSTRUMENTS AND CONTROLS
30
C330A01P-GAT (Van) DR(
·):The light illuminates when the
slide door and/or the tailgate is opened and goes out when it isclosed.
ON : The light illuminates.
OFF : The light goes out.
By depressing the main switch in theinstrument panel, driver can operatethe rear room light.
ON : The lamp illuminates.
- Direct illumination (white)
OFF : The light goes out.
DOOR : The light illuminates when theslide door and/or the tailgate is opened and goes out when it closed.
MOOD : The light illuminates. - Indirect illumination (orange)
C330A01P
SUNROOF
B470A01S-AAT SUNSHADE (Minibus) (If installed) The sunshade can be opened and closed by sliding it forward or rearward when the sunroof is closed. The sun- shade will open automatically whenthe sunroof is opened, but it must be closed manually. B460A01S-AAT SUNROOF (Minibus) (If installed) The sunroof can be operated with the ignition key in the "ON" position. B460B03P
B460B03P
Page 169 of 273

3
STARTING AND OPERATING
29
D180C01P-GAT Battery The capacity of the battery is reduced at low temperatutes.This is an inevitable result of its chemi- cal and physical properties. This is why a very cold battery, particularlyone that is not fully charged anyway, will only deliver a fraction of the starter current which is normally available.It is recommended that you have the battery checked by an authorized HYUNDAI dealer before the start ofcold weather and, if necessary, have it charged. This not only ensures reliable starting,but a battery which is kept fully charged also has a longer life. C160G02A-AAT To Keep Locks from Freezing To keep the locks from freezing, squirt an approved de-icer fluid or glycerineinto the key opening. If a lock is cov- ered with ice, squirt it with an approved de-icing fluid to remove the ice. If thelock is frozen internally, you may be able to thaw it out by using a heated key. Handle the heated key with careto avoid burning your fingers. NOTE: The proper temperature for using the immobilizer key is from -40°C to 80°C. If you heat the immobilizer key over 80°C to open the frozenlock, it may cause damage to the transponder in its head.
D180G01P-GAT Door locks To prevent the door locks from freez- ing up, the lock cylinders should be masked with tape, etc., when washingthe vehicle in cold weather to prevent the entrance of water.
D180D01P-GAT Washer fluid To ensure proper operation of the wind- shield or rear window at low tempera-tures, anti-freeze should be added to the washer fluid at a rate of one part antifreeze to one part water. D180E01P-GAT Wiper blades Before operating the wipers, check the wiper blades to confirm that they arenot frozen to the windshield or tailgate. If the blades are frozen to the wind- shield or tailgate, do not operate thewipers until the ice has melted and the blades are freed. D180F01P-GAT Ventilation slots The ventilation slots in the headlight housing on the assistant seat side should be brushed clear after a heavysnowfall so that the operation of the heating and ventilation systems will not be impaired.
Page 176 of 273
44IN CASE OF EMERGENCY
4
E050B02P-GAT To reinstall the spare tire Installation is the reverse order of dis- assembly.
CAUTION:
The spare tire should always besecurely in position.If a flat tire is changed, put the flat tire in the spare tire mounting posi- tion, and use the wheel nut wrenchto secure it firmly.
!
To remove the spare tire:
1. Open the tailgate
2. Remove the plastic cover.
HSRFL052
HSRFL053
3. Use the wheel nut wrench to loosen the holder mounting bolt. HSRFL054
HSRFL055
4. Lift up the hanger and separate it from the holder, and then lower the hanger and remove the spare tire.