Page 68 of 273

2
INSTRUMENTS AND CONTROLS
3
1. Malfunction indicator light (MIL) (If installed) 
2. Oil pressure warning light 
3. Brake warning and parking brake indicator light 
4. Seat belt warning light (If installed)
5. Immobilizer warning light (If installed) 
6. Turn-signal indicator lights 
7. Automatic transmission position indicator light (Automatic transmission only)
8. POWER/HOLD mode indicator light
(Automatic transmission only)
9. High-beam indicator light 
10. ABS Service reminder indicator light (SRI) (If installed) 
11. SRS (Airbag) service reminder indicator light (If installed) 12. Overdrive off indicator light
(Automatic transmission only)
13. Diesel preheat indicator light (Diesel only)
14. Tachometer (If installed) 
15. Low fuel level warning light 
16. Fuel filter warning light (Diesel only)
17. Charging system warning light 
18. Coolant Temperature gauge 
19. Odometer/Trip odometer
20. Fuel gauge 
21. 4WD LOW/Hl indicator light 
22. Trip odometer reset switch
23. Speedmeter 
24. Door-ajar warning light  
     
        
        Page 70 of 273
2
INSTRUMENTS AND CONTROLS
5
1. Fuel gauge 
2. Coolant Temperature gauge 
3. Malfunction indicator light (MIL) (If installed) 
4. Oil pressure warning light
5. Brake warning and parking brake indicator light 
6. Seat belt warning light (If installed) 
7. Immobilizer warning light (If installed)
8. Automatic transmission position indicator light (Automatic transmission only)
9. POWER/HOLD mode indicator light
(Automatic transmission only)
10. High-beam indicator light
11. ABS Service reminder indicator light (SRI) (If installed) 12. SRS (Airbag) service reminder indicator light
(If installed)
13. Overdrive off indicator light (Automatic transmission only)
14. Speedmeter
15. Diesel pre-heat indicator light (Diesel only)
16. Low fuel level warning light 
17. Fuel filter warning light (Diesel only) 
18. Charging system warning light
19. Turn-signal indicator lights 
20. Odometer/Trip odometer 
21. 4WD LOW/Hl indicator light
22. Trip odometer reset switch 
23. Door-ajar warning light  
     
        
        Page 72 of 273
2
INSTRUMENTS AND CONTROLS
7
1. Coolant Temperature gauge 
2. Tachometer (If installed) 
3. Turn-signal indicator lights 
4. Speedmeter
5. Odometer 
6. Fuel gauge 
7. Low fuel level warning light
8. ABS Service reminder indicator light (SRI) (If installed) 
9. Malfunction indicator light (MIL) (If installed) 
10. Fuel filter warning light (Diesel only)
11. Charging system warning light 12. Brake warning and parking brake indicator light 
13. SRS (Airbag) service reminder indicator light
(If installed)
14. Diesel pre-heat indicator light (Diesel only)
15. Door-ajar warning light 
16. High-beam indicator light
17. Tripmeter reset switch 
18. Tripmeter 
19. Oil pressure warning light 
20. Immobilizer warning light (If installed)  
     
        
        Page 125 of 273

2 INSTRUMENTS AND CONTROLS
60
B260D03O-AAT 
1. Playing CD 
o Insert the CD with the label facingupward.
o Insert the CD to start CD playback, during radio operation.
o When a disc is in the CD deck, if you press the CD button, the CD player will begin playing even if the radio is being used.
o The CD player can be used when the ignition switch is in either the"ON" or "ACC" position.
2. FF/REW  (     /     ) If you want to fast forward or reverse through the compact disc track, push and hold in the FF (    ) or REW (     ) button.When you release the button, the com- pact disc player will resume playing. 3. TRACK UP/DOWN 
o The desired track on the disc cur-
rently being played can be selected using the track number.
o Press          once to skip forward to
the beginning of the next track.Press           once to skip back to the beginning of the track.
4. SCAN Button 
o Press the SCAN button to playback the first 10 seconds of each track.
o Press the SCAN button again within 10 sec. When you have reached the desired track.
5. REPEAT Button 
o To repeat the track you are cur- rently listening to, press the RPT button.  To cancel , press again.
o If you do not release RPT operation
when the track ends, it will automati-cally be replayed. This process will be continued until you  push the button again. 6. EJECT Button When the EJECT button         is pressed with a CD loaded, the CD will eject. NOTE: 
o To assure proper operation of
the unit, keep the vehicle interior temperature within a normal range by using the vehicle's air conditioning or heating system.
o When replacing the fuse, replace it with a fuse having the correctcapacity.
o The preset station frequencies are all erased when the car bat-tery is disconnected. Therefore,all data will have to be set again if this should occur.
o Do not add any oil to the rotating parts. Keep magnets, screwdriv-ers and other metallic objects away from the tape mechanismand head.
o This equipment is designed to
be used only in a 12 volt DCbattery system with negative ground.  
     
        
        Page 133 of 273

2 INSTRUMENTS AND CONTROLS
68
H290F02O-GAT 
1. CD Select Button 
o Insert the CD with the label facingupward.
o Insert the CD to start CD playback, during radio operation or cassette tape playing.
o When a disc is in the CD deck, if you
press the CD button the CD playerwill begin playing even if the radio or cassette player is being used.
o The CD player can be used when the ignition switch is in either the"ON" or "ACC" position.
2. FF/REW  (     /     ) If you want to fast forward or reverse through the compact disc track, push and hold in the FF (      ) or REW (     ) button.When you release the button, the com- pact disc player will resume playing. 3. TRACK UP/DOWN 
o The desired track on the disc cur-
rently being played can be selected using the track number.
o Press           button once to skip for- ward to the beginning of the nexttrack. Press            button once to skipback to the beginning of the track.
4. REPEAT  Button 
o To repeat the track you are cur- rently listening to, press the RPT button.  To cancel , press again.
o If you do not release RPT operation when the track ends, it will automati- cally be replayed.This process will be continued until you  push the button again.
5. EQUALIZER Button Press the EQ button to select the CLASSIC, JAZZ, ROCK and DEFEAT MODE for the desired tone quality.Each press of the button changes the display as follows; 6. CD EJECT Button When the            button is pressed with a CD loaded, the CD will eject. 
7. SCAN Button (If installed) 
o Press the SCAN button to playback
the first 10 seconds of each track.
o Press the SCAN button again within
10 sec. for the desired track.
NOTE: 
o To assure proper operation of the unit, keep the vehicle interior temperature within a normal range by using the vehicle's airconditioning or heating system.
o When replacing the fuse, replace
it with a fuse having the correctcapacity.
o The preset station frequencies
are all erased when the car bat-tery is disconnected. Therefore, all data will have to be set again if this should occur.
o Do not add any oil to the rotating parts. Keep magnets, screwdriv-ers and other metallic objectsaway from the tape mechanism and head.
CLASSIC 
  JAZZ    ROCK    DEFEAT