2004 Hyundai H-1 (Grand Starex) length

1
BEFORE DRIVING YOUR VEHICLE
39
!
To adjust the height of seat belt an- chor, lower or raise the height adjusterinto an appropriate position. To raise the height adjuster, pull it up. To lower it, push it down while pressing theheight adjuster button. Release the button to lock the anchor into position. Try sliding the releasebutton to make sure that it has locked into the position. B180A01A-GAT Driver's and Passenger's 3-Point System with EmergencyLocking Retractor (If installed) To Fasten Your Belt To fasten your seat belt, pull it out of the retractor and insert the metal tabinto the buckle. There will be an au- dible "click" when the tab locks into the buckle.
B180A02A-GAT Driver's and Passenger's 3-Point System with Webbing ClampLocking Retractor (If installed) To Fasten Your Belt To fasten your seat belt, pull it out of the retractor and insert the metal tab into the buckle. There will be an au-dible "click" when the tab locks into the buckle. The seat belt automatically adjusts tothe proper length only after the lap belt is adjusted manually so that it fits snugly around your hips. If you leanforward in a slow, easy motion, the belt will extend and let you move around. If there is a sudden stop or impact, how-
B180A01Lever, the belt will lock into position. Itwill also lock if you try to lean forwardtoo quickly.
B180A01L
WARNING:
o The height adjuster must be in the locked position whenever thevehicle is moving.
o The misadjustment of height of the shoulder belt could reducethe effectiveness of the seat beltin a crash.

1BEFORE DRIVING YOUR VEHICLE
40
B200A01S-GAT Adjusting Your Seat Belt
B200A01L
You should place the belt as low as possible on your hips, not on yourwaist. If the belt is located too high on your body, you could slide under it in case of accident or a sudden stop.This could result of death, serious in- jury or property damage. Both arms should not be under or over the belt.Rather, one should be over and the other under, as shown in the illustra- tion.Never wear the seat belt under the arm nearest the door. B210A01A-AAT To Release the Seat Belt
The seat belt is released by pressing the release button in the locking buckle.When it is released, the belt should automatically draw back into the re- tractor. If this does not happen, checkthe belt to be sure it is not twisted, then try again. B210A01L
The seat belt automatically adjusts to the proper length only after the lap beltis adjusted manually so that it fits snugly around your hips. If you lean forward in a slow, easy motion, the beltwill extend and let you move around. If there is a sudden stop or impact, how- ever, the belt will lock into position. Itwill also lock if you try to lean forward too quickly. Check to make sure that the belt is properly locked and that thebelt is not twisted.

1BEFORE DRIVING YOUR VEHICLE
44
!
B230G01P-GAT Installation on Outboard Rear Seats To install a child restraint system in the outboard rear seats, extend the shoul- der/lap belt from its retractor. Install the child restraint system, buckle theseat belt and allow the seat belt to take up any slack. Make sure that the lap portion of the belt is tight around thechild restraint system and the shoulder portion of the belt is positioned so that it cannot interfere with the child's heador neck. After installation of the child restraint system, try to move it in all directions to be sure the child restraintsystem is securely installed. If you need to tighten the belt, pullmore webbing toward the retractor.When you unbuckle the seat belt and allow it to retract, the retractor will automatically revert back to its normalseated passenger emergency locking usage condition. NOTE:
o Before installing the child re-
straint system, read the instruc- tions supplied by the child re- straint system manufacturer.
o If the seat belt does not operate as described, have the systemchecked immediately by yourauthorized Hyundai dealer.
WARNING:
Do not install any child restraintsystem in the front passenger seat.Should an accident occur and cause the passenger side airbag to de- ploy, it could severely injure or killan infant or child seated in an infant or child seat. Therefore, install a child restraint system only in therear seat of your vehicle.
B230G01L-1
Use the center seat belt for the rearseat to secure the child restraint sys-tem as illustrated. After installation of the child restraint system, rock the child seat back and forth, and side toside to ensure that it is properly se- cured by the seat belt. If the child seat moves, readjust thelength of the seat belt. Always refer to the child restraint system manufacturer's recommendation be-fore installing the child restraint sys- tem in your vehicle.

9 VEHICLE SPECIFICATIONS
2
2WD
1,885(74)
SHORT
3
VAN
4,695(184)
1,820(71)1,900(74)
2,810(110)
1,570(61)1,545(60)
Front Rear
J010A03P-GAT MEASUREMENT J010A02P-GAT MEASUREMENT
J020A02P-GATFUEL TANK CAPACITYmm (in.)
MINIBUS, VAN
Overall length Overall widthOverall height Wheel base Wheel tread
ITEMS FUEL TANK CAPACITYMINIBUS, VAN 65L TRUCK
70LLONG(1ton)
STANDARD
5085 (200)1820 (71)
3080 (121)
1570 (62) 1408 (55) EXTRA LONG (1.25 ton)
STANDARD
5415 (213)1820 (71)
3280 (129)
1570 (62)1408 (55)TRUCK
Overall length Overall width Wheel base Wheel tread
Front Rear
SUPER
mm(in.)
12

9

1,970(77)
6
VAN
3
VAN
5,035(198)

1,980(77)
3,080(121)

9
4,695(184)
1,885(74)
1,570(61)1,545(60)
4WD
4,825(189)

1,995(78)
1,565(61)1,560(61)
6
VAN
LONG
7