2004 Hyundai H-1 (Grand Starex) OD off

2
INSTRUMENTS AND CONTROLS
29
C320A01P-GAT Rear Room Light (Minibus)
C320A01P
C320A02P
The three positions are:
o DR (
·)
In the DR ( ·) position, the interior
courtesy light comes on when any door is opened regardless of the igni-tion key position. The light goes out when the door is closed. NOTE: If your vehicle is equipped with the delay-out interior light, the light goes out gradually within 6 sec-onds after the door is closed.
oON In the "ON" position, the light stays on at all times.
CAUTION:
Do not leave the switch in this posi- tion for an extended period time when the vehicle is not running. o OFF In the "OFF" position, the light stays off at all times even though a door is open.
!
C310A02P-GAT Interior Light (Van/Truck)
ON : The light illuminates.
OFF : The light goes out.
B490B01P

2 INSTRUMENTS AND CONTROLS
30
C330A01P-GAT (Van) DR(
·):The light illuminates when the
slide door and/or the tailgate is opened and goes out when it isclosed.
ON : The light illuminates.
OFF : The light goes out.
By depressing the main switch in theinstrument panel, driver can operatethe rear room light.
ON : The lamp illuminates.
- Direct illumination (white)
OFF : The light goes out.
DOOR : The light illuminates when theslide door and/or the tailgate is opened and goes out when it closed.
MOOD : The light illuminates. - Indirect illumination (orange)
C330A01P
SUNROOF
B470A01S-AAT SUNSHADE (Minibus) (If installed) The sunshade can be opened and closed by sliding it forward or rearward when the sunroof is closed. The sun- shade will open automatically whenthe sunroof is opened, but it must be closed manually. B460A01S-AAT SUNROOF (Minibus) (If installed) The sunroof can be operated with the ignition key in the "ON" position. B460B03P
B460B03P

2
INSTRUMENTS AND CONTROLS
31
!
! B460D01P-GAT Manual Operation of Sunroof If the sunroof does not electrically op- erate:
1. Remove the rectangular plastic
cover in the front of the roof panel.
2. Insert the hexagonal head wrench
into the socket. This wrench can be found in the tool bag at the right corner of the vehicle.
3. Turn the wrench clockwise to open or counterclockwise to close.
WARNING:
o Do not close a sunroof if anyone's hands, arms or body are betweenthe sliding glass and the sunroofsash, as this could result in an injury.
o Do not stand up or extend any portion of your body out of theopening while the vehicle is mov- ing.
CAUTION:
o Do not open the sunroof in se- verely cold temperature or when it is covered with ice or snow.
o Periodically remove any dirt that may have accumulated on theguide rails.
o After washing the car or after
there being rain, be sure to wipeoff any water that is on the sunroof before operating it. B460D01P
B460B03P-GAT OPERATING THE SUNROOF SYSTEMOpening or closing the sunroof The sunfoof can be electrically opened or closed. To open or close, press and hold the button located in the front ofthe roof panel. And release the button when the sunfoof reaches the desired position.In case of closing the rear sunroof, it stops at a half position before full clos- ing. Therefore, release the button andthen press and hold it again to close it completely. Front
B460B01P
Rear

2
INSTRUMENTS AND CONTROLS
35DRINK HOLDER
!
The front drink holder is located on the center facia panel for holding cups or cans in its holes. The drink holder canbe used by pushing it.
B450A04A-AAT Front Drink Holder (If installed)
CAUTION:
Place the drink holder in its closed position when not in use. WARNING:
Do not place anything except drinksin the drink holder. Such objectscan be thrown out, possibly injur- ing persons in the vehicle during sudden braking or in the event of anaccident.
!
B510D01P-AAT OUTSIDE REARVIEW MIRROR HEATER (If installed) The outside rearview mirror heater is actuated in connection with the rear window defroster. To heat the outside rearview mirror glass, push in the switchfor the rear window defroster. The rearview mirror glass will be heated for defrosting or defogging and will giveyou improved rear vision in inclement weather conditions. Push the switch again to turn the heater off. The out-side rearview mirror heater automati- cally turns itself off after 20 minutes. B380A01P
HSRFL2318
B450A02P-GAT
Rear Drink Holder (If installed) The rear drink holder which are used to hold a cup are located on the quarter trim.
B450A01P

2
INSTRUMENTS AND CONTROLS
41
B670B01A-AAT Fan Speed Control (Blower Control) This is used to turn the blower fan on or off and to select the fan speed.This blower fan speed, and therefore the volume of air delivered from the system, may be controlled manuallyby setting the blower control between the "1" and "4" positions.
Defrost-Level
Air is discharged through the wind-shield defroster nozzle and side venti- lator.If the "Defrost" mode is selected, the A/C will turn on automatically and "Fresh" mode will be activated to im-prove windshield defrosting. HSRFL674B670C01A-AAT AIR INTAKE CONTROL This is used to select fresh outside air or recirculating inside air.
Fresh Recirculation
With the mode selected, air enters the vehicle from outside and is heatedor cooled according to the other func- tions selected. With the mode selected, air fromwithin the passenger compartment is drawn through the heating system and heated or cooled according to the otherfunctions selected. NOTE: It should be noted that prolonged operation of the heating system in mode will give rise to misting
of the windshield and side win-dows and the air within the passen- ger compartment will become stale. In addition prolonged use of the airconditioning with the mode se- lected may result in the air within the passenger compartment becom-ing excessively dry.

2 INSTRUMENTS AND CONTROLS
44AIR CONDITIONING SYSTEM
C680A01P-GAT (If installed) Cooling To use the air conditioner to cool inte- rior:
o Set the side vent control to "OFF",
to shut off outside air entry.
o Turn on the fan control switch.
o Turn on the air conditioner switch by pushing in on the switch. The air conditioner indicator light should come on at the same time.
o Set the air intake control to the "Fresh" position.
o Set the temperature control to the
"Cool" position. ("Cool" provides maximum cooling. The temperature may be moder- ated by moving the control toward"Warm".)
o Adjust the fan control to the desired
speed. For greater cooling, turn thefan control to one of the higher speeds or temporarily select the "Recirc" position on the air intakecontrol.
C680A01P C680A02P
Rotary and push button type
Lever type Rotary and push button type
Lever type
C690A01P-GAT Dehumidified heating
C690A01P
C690A02P

2
INSTRUMENTS AND CONTROLS
45REAR HEATER AND AIR CONDITIONER
C710A01P-GAT (If installed) The rear heater can be operated with the ignition switch at the "ON" positionby depressing the main switch in the instrument panel.
C700A01P-GAT Operation Tips
o If the interior of the vehicle is hot
when you first get in, open the win- dows for a few minutes to expel the hot air.
o When you are using the air condi- tioning system, keep all windowsclosed to keep hot air out.
o When you must drive slowly, as in heavy traffic, shift to a lower gear.This increases engine speed, which in turn increases the speed of theair conditioning compressor.
o When driving up long grades, turn
occasionally the air conditioner offto avoid the possibility of the engine overheating.
o During winter months or in periods when the air conditioner is not usedregularly, turn on the air conditioner switch occasionally for a few min-utes. This will help circulate the lubricants and keep your system in peak operating condition.
For dehumidified heating:
o Turn on the fan control switch.
o Turn on the air conditioner switch by
pushing in on the switch. The air conditioner indicator light should come on at the same time.
o Set the air intake control to the "Fresh".
o Set the air flow control to the "Face".
o Adjust the fan control to the desired
speed. For more rapid action, set the fan at one of the higher speeds.
o Adjust the temperature control to provide the desired amount ofwarmth.

2 INSTRUMENTS AND CONTROLS
46
C720A01P-GAT Main switch for the rear heater The main switch for the rear heater is installed in the instrument panel. The main switch should be used toswitch the power of the rear heater "ON" and "OFF". The power is switched "ON" when thebutton is pressed, and the lamp within the switch is illuminated. Illumination will stop and the power will be switched"OFF" when the button is pressed once again. C720A01PC730A02P-GAT Control panel
Rotary type
Lever type C730A02P
C730A02P-1
1 2
3
12
3
1. Temperature controllerRotary type- Select the desired tem-
perature by turn the knob left or right.
Lever type - Select the desired tem-
perature by sliding thelever left or right.
Red - High temperaute (heating)
Blue - Ambi ent temperature
(ventilating)
2. Mode selector lever Air flow can be switched in three modes. Three symbols are used to repre- sent Floor level, Bi-level and Facelevel.
3. Blower controller The blower can be operated (when the ignition key and main switch for the rear heater is at the "ON" posi-tion) at three speeds to regulate the amount of air forced through the vehicle.The blower speed will increase as the switch is moved to the right.