2004 HONDA CR-V drive

[x] Cancel search: drive

Page 75 of 256

HONDA CR-V 2004 RD4-RD7 / 2.G Owners Manual µµµ
µ You can insert or
remove the key only in this position.
To turn the key, the shift lever must
be in Park, and you must push the
key in slightly. Use this position
only to start the engin

Page 76 of 256

HONDA CR-V 2004 RD4-RD7 / 2.G Owners Manual The childproof door locks are
designed to prevent children seated
in the rear f rom accidentally opening
the rear doors. Each rear door has a
lock lever near the edge. With the
lever in the LOCK posit

Page 77 of 256

HONDA CR-V 2004 RD4-RD7 / 2.G Owners Manual CONT INUED
Use the valet or master key in the
tailgate to:.Pullthe
handle to open it. ..Youcan
also open it by pressing the hatch
glass release button on the driver’s
door. The rear wiper will not o

Page 78 of 256

HONDA CR-V 2004 RD4-RD7 / 2.G Owners Manual µ
µ µ
µ
See page for information on
cargo loading. Keep the tailgate and
the hatch glass closed at all times
while driving to avoid damaging the
tailgate and the hatch glass, and to
prevent ex

Page 80 of 256

HONDA CR-V 2004 RD4-RD7 / 2.G Owners Manual Do not use the seat heaters when the
engine is of f or when idling f or a
long period of time. They can drain
the battery, making your vehicle
hard to start.
Because of the sensors f or the side
airba

Page 82 of 256

HONDA CR-V 2004 RD4-RD7 / 2.G Owners Manual To adjust the height of the driver’s
seat, turn the dial on the outside of
the seat bottom.
To change the angle of the rear seat-
back, pull up on the release lever on
the outside of the seat-back.

Page 90 of 256

HONDA CR-V 2004 RD4-RD7 / 2.G Owners Manual µµ
Turn the ignition switch to ON (II)
toraiseorloweranywindow.To
open the window, push the switch
downandholdit.Releasetheswitch
when you want to stop the window.
Pull back on the switch and hold

Page 91 of 256

HONDA CR-V 2004 RD4-RD7 / 2.G Owners Manual If your vehicle’s battery is
disconnected or goes dead, or the
driver’s window f use is removed, the
AUTO f unction will be disabled. The
power window system needs to be
reset af ter reconnecting