2004 HONDA ACCORD COUPE homelink

The heating and air conditioning
systems in your Honda provide a
comf ortable driving environment in
all weather conditions.
The standard audio system has
many f eatures. This section de-
scribes those f eatures and how to
use them.
Your Honda has an anti-thef t audio
system that requires a code number
to enable it.
Navigation Systems are available on
U.S. models only.
The security system helps to dis-
courage vandalism and thef t of your
Honda.............
Vents, Heating, and A/C . 108
..........................
Using the A/C . 113
To Cool or Heat
.......................
Automatically . 115
.........
Dual Temperature Control . 117
.............
Climate Control Sensors . 119
.........................
Playing the Radio . 120
...........................
Radio Reception . 126
Playing the XM
Satellite
.........................................
Radio . 128
.................................
Playing a CD . 134
..................................
CD Changer . 137
...................
Protecting Your CDs . 142
........
CD Player Error Messages . 143
....
CD Changer Error Messages . 144
..............................
Playing a Tape . 146
............
Steering Wheel Controls . 152
................
Radio Thef t Protection . 153
.........................
Setting the Clock . 154
...........................
Security System . 155
..............................
Cruise Control . 156
HomeLink Universal
...............................
Transceiver . 159
On all models except f or 4-cylinder LX
model
Comf ort and Convenience Features
Comf ort and Convenience Feat ures107
——y

y
(%
y

y

µ
The HomeLink
Universal
Transceiver built into your vehicle
canbeprogrammedtooperateupto
three remote controlled devices
around your home, such as garage
doors, lighting, or home security
systems.
If you are training HomeLink to
operate a garage door or gate, you
should unplug the motor f or that
device during training. Repeatedly
pressing the remote control button
could burn out the motor.
The HomeLink transceiver stores
the code in a permanent memory.
There should be no need to retrain
the transmitter if your vehicle’s
battery goes dead or is disconnected.
If your garage door opener was
manuf actured bef ore April 1982, you
may not be able to program
HomeLink to operate it. They do not have the saf ety f eature
that causes the motor to stop and
reverse if an obstacle is detected
during closing, increasing the risk of
injury.
For quick and accurate training,
make sure the remote control
transmitter for the device (garage
door, automatic gate, security
system, etc.) has a fresh battery.
If you just
received your vehicle and have not
trained any of the buttons in
HomeLink bef ore, you should erase
any previously learned codes bef ore
training the first button.
Todothis,pressandholdthetwo
outside buttons on the HomeLink
transceiver for about 20 seconds, or
until the red light f lashes. Release
the buttons, then proceed to Step 1.
If you are training the second or
third buttons, go directly to Step 1.
HomeLink
is a registered
trademark of Johnson Controls .
Always ref er to the operating
instructions and saf ety inf ormation
that came with your garage door
opener or other equipment you
intend to operate with the HomeLink
Universal Transceiver. If you do not
have this inf ormation, you should
contact the manuf acturer of the
equipment.
CONT INUED
On EX-V6 model
HomeL ink Universal T ransceiver
Comf ort and Convenience Feat ures
General Inf ormation T raining HomeL ink
Important Saf ety Precautions
Bef ore you begin
159
TM
——y

y
(%
y
y

Press and hold the remote control
button and one of the HomeLink
buttons at the same time.
Unplug the garage door opener
motor f rom the house current. The remote control
you are training f rom may stop trans-
mitting after two seconds. This is not
enough f or HomeLink to learn the
code. Release and press the button
on the remote control every two
seconds until HomeLink has learned
the code.
The red light in HomeLink should
begin f lashing. It will f lash slowly
at first, then rapidly.
When the red light f lashes rapidly,
release both buttons. HomeLink
should have learned the code from
the remote control. Plug in the garage door opener
motor, then test the HomeLink
transceiver button by pushing it. If
the button does not work, repeat
the procedure to train it again. If it
still does not work, you may have a
variable or rolling code garage
door opener. See if you do by
pressing and holding the
HomeLink transceiver button you
just trained. If the red light blinks
f or two seconds then stays on, you
have a rolling code garage door
opener. Go to ‘‘Training with a
Rolling Code System’’ (see page
)
Repeat these steps to train the
other two HomeLink buttons to
operate any other remotely
controlled devices around your
home (lighting, automatic gate,
security system, etc.).
Holdtheendof thegaragedoor
opener remote control 2 to 5
inches f rom the HomeLink
transceiver. Make sure you are not
blocking your view of the red light
in HomeLink.
2. 3. 4.
1.
5.6. 7.
161
Canadian Owners:
Comf ort and Convenience Feat ures
HomeL ink Universal T ransceiver
160
——y
y
(%
y
y

µµ
For security purposes, newer garage
door opening systems use a ‘‘rolling’’
or variable code. Inf ormation f rom
the remote control and the garage
door opener are needed bef ore
HomeLink can operate the garage
door opener.
The ‘‘Training HomeLink’’
procedure trains HomeLink to the
proper garage door opener code.
The f ollowing procedure
synchronizes HomeLink to the
garage door opener so they send and
receive the correct codes.
Make sure you have properly
completed the ‘‘Training
HomeLink’’ procedure. Press the Training button on the
garage door opener unit until the
light next to the button comes on,
then release it. The light may blink,
or come on and stay on. You then
have approximately 30 seconds to
complete the f ollowing steps.Press and hold the button on
HomeLink f or 3 4 seconds.
Press and hold the HomeLink
button again f or 3 4 seconds.
This should turn of f the training
light on the garage door opener
unit. (Some systems may require
youtopressthebuttonuptothree
times.)
Press the HomeLink button again.
It should operate the garage door.
Find the ‘‘Training’’ button on your
garage door opener unit. The
location will vary, depending on
the manufacturer. 6.
2. 4. 5.
1. 3.
T raining With a Rolling Code
System
HomeL ink Universal T ransceiver
Comf ort and Convenience Feat ures161
TRAINING BUTTON
——y
y
(%
y
y

Toerasethecodesstoredinallthree
buttons, press and hold the two
outside buttons until the red light
begins to f lash, then release the
buttons.
Youshoulderaseallthreecodes
bef ore selling the vehicle.
Totrainanalreadyprogrammed
transceiver button with a new device,
you do not have to erase all the
memory. Train the selected button
over the existing memory code
f ollowing the steps under. If you have problems with training
the HomeLink Universal Transceiver,
or would like inf ormation on home
products that can be operated by the
transmitter, call (800) 355-3515. On
the Internet, go to www.homelink.
com.
As required by the FCC:
This device complies with Part 15 of theFCC rules. Operation is subject to thef ollowing two conditions: (1) This devicemay not cause harmf ul interf erence, and(2) this device must accept anyinterf erence received, including
interf erence that may cause undesiredoperation.
Changes or modif ications not expresslyapproved by the party responsible f or
compliance could void the user’sauthority to operate the equipment.
This device complies with IndustryCanada Standard RSS-210.Operation is subject to the f ollowing twoconditions: (1) this device may not cause
interf erence, and (2) this device mustaccept any interf erence that may causeundesired operation of the device.
HomeL ink Universal T ransceiver
Comf ort and Convenience Feat ures
Erasing Codes Customer Assistance
Retraining a Button
T raining
HomeL ink
162
——y
y
(%
y
y

.................................................
Fuel . 164
......................
Fill Door and Cap . 165
...........................................
Gauge . 67
................
Octane Requirement . 164
...............................
Oxygenated . 164
........................
Tank, Ref ueling . 165
.....................
Fuses, Checking the . 275
...............
Gas Mileage, Improving . 170
..........................................
Gasohol . 164
.........................................
Gasoline . 164
...........................................
Gauge . 67
................
Octane Requirement . 164
........................
Tank, Ref ueling . 165
................
Gas Station Procedures . 165
Gauges
...
Engine Coolant Temperature . 67
...............................................
Fuel . 67
Gearshif t Lever Positions ..........
Automatic Transmission . 183
5-speed Manual
.........................
Transmission . 180
6-speed Manual .........................
Transmission . 180 ........................................
Glove Box . 99
Gross Vehicle Weight Rating
.....................................
(GVWR) . 195 ... Identif ication Number, Vehicle . 282
Ignition
..............................................
Keys . 75
...........................................
Switch . 77
............
Timing Control System . 294
........................
Immobilizer System . 76
.........
Important Safety Precautions . 6
.........................................
Indicators . 58
.......
ABS (Auti-lock Brake) . 60, 189
Brake (Parking and Brake
............................
System) . 59, 271
................
Charging System . 58, 269
.............................
Cruise Control . 63
DRL (Daytime Running
......................................
Lights) . 63
...................................
High Beam . 63
........
Key (Immobilizer System) . 61
......................................
Low Fuel . 62
................
Low Oil Pressure . 58, 268
...........................
Side Airbag Of f . 59
...............................................
SRS . 59
Turn Signal and Hazard
...................................
Warning . 61
..............................
Washer Level . 63
.............
Halogen Headlight Bulbs . 233
..............
Hazard Warning Flashers . 72
........................................
Headlights . 70
........................................
Aiming . 233
..............
Automatic Lighting Off . 71
............
Daytime Running Lights . 71
............
Low Beams, Turning on . 70
.........................
Reminder Chime . 70
........
Replacing Halogen Bulbs . 233
...................................
Turning on . 70
..............................
Head Restraints . 88
.....................
Heating and Cooling . 108
.................................
Heated Mirror . 96
.....................................
Heater, Seat . 90
.............
High Altitude, Starting at . 179
HomeLink Universal
................................
Transceiver . 159
....................................
Hood Latch . 232
.......................
Hood, Opening the . 166
...........................
Hydraulic Clutch . 231
Index
G H
I
IV
——y
y
(%
y

y