2004 DODGE VIPER maintenance

[x] Cancel search: maintenance

Page 148 of 236

DODGE VIPER 2004 ZB / 2.G Owners Manual NOTE:Intentional tampering with emissions control
systems can result in civil penalties being assessed
against you.
WARNING!
You can be badly injured working on or around a
motor vehicle. Do only that

Page 149 of 236

DODGE VIPER 2004 ZB / 2.G Owners Manual The best time to check the oil level is approximately 5
minutes after a fully warmed up engine is turned off or
before starting the engine after it has sat overnight.
Checking the oil while the vehicl

Page 150 of 236

DODGE VIPER 2004 ZB / 2.G Owners Manual ²Trailer towing
²Off-road or desert driving
²If equipped for and operating with E±85 (ethanol) fuel
If none of these apply to you, then change your engine oil
every 6,000 miles (10 000 km) or 6 mo

Page 152 of 236

DODGE VIPER 2004 ZB / 2.G Owners Manual present a problem to the environment. Contact your
dealer, service station, or governmental agency for advice
on how and where used oil can be safely discarded in
your area.
Engine Oil Filter
The engi

Page 153 of 236

DODGE VIPER 2004 ZB / 2.G Owners Manual Catalytic Converter
The catalytic converter requires the use of unleaded fuel
only. Leaded gasoline will destroy the effectiveness of the
catalyst as an emission control device.
Under normal operating

Page 155 of 236

DODGE VIPER 2004 ZB / 2.G Owners Manual Manual for the proper procedure to be followed for
checking ignition cable resistance. Cracked, damaged, or
faulty cables should be replaced.
Because of the plastic body shell on your Viper, ignition

Page 156 of 236

DODGE VIPER 2004 ZB / 2.G Owners Manual Maintenance-Free Battery
The top of the MAINTENANCE-FREE battery is perma-
nently sealed. You will never have to add water, nor is
periodic maintenance required.
The battery is in a compartment inside

Page 161 of 236

DODGE VIPER 2004 ZB / 2.G Owners Manual Power Steering (Pump and Reservoir)
WARNING!
Fluid level should be checked with the engine off to
prevent injury from moving parts. Do not overfill.
Use only the manufacturers recommended fluid.
Refe