2004 DODGE STRATUS COUPE bulb

Adjustment of headlight aim
The alignment of the headlights should be checked by an
authorized dealer.
Front turn signal and parking lights
Turn the light socket (A) counterclockwise and pull it out
and remove the light bulb.
Front fog lights (if so equipped)
1. Insert a screwdriver as shown in the illustration and
remove the screws.
N10F0820
N10X1630
EMERGENCIES 297
8

2. Slide the light unit outward to remove it. Turn the
light socket counterclockwise and pull it out.3. Pull both clips (A) away from the center as shown and
remove the bulb from the socket by pulling out.
N10X1460N10X1700
298 EMERGENCIES

4. When mounting the light unit, align the pins (A) on
the light unit with the holes in the body.
CAUTION!
²Never hold the halogen light bulb with a bare
hand, dirty glove, etc. The oil from your hand
could cause the bulb to break the next time the fog
lights are operated.
If the glass surface is dirty, it should be cleaned
with alcohol and installed after drying thor-
oughly.
N10X1740
N10X1770
EMERGENCIES 299
8

Front side marker lights
Turn the light socket counterclockwise and pull it out and
remove the light bulb.
Rear combination lights
1. Turn the trim cover clip (A) counterclockwise and
remove the trim cover clip. Partially remove the trim
cover in the trunk.
N10D0170N20I0170
300 EMERGENCIES

2. Remove the light case mounting nuts. Disconnect the
connector.3. Slide the light unit outward to remove it. Remove each
bulb socket assembly by turning it counterclockwise.
Remove the bulb from the socket by turning it counter-
clockwise while pressing it inward.
N20I0160N20I0290
A - Stop and tail light
B - Rear turn signal and tail
light
C - Rear side marker light
EMERGENCIES 301
8

High-mounted stop light
Remove the socket assembly and bulb together by turn-
ing it counterclockwise.
Remove the bulb from the socket by pulling out.
License plate light
Remove the lens mounting screws, remove the socket
assembly and the bulb together by turning it counter-
clockwise. And remove the bulb by pulling out.
N10V0710N10J0310
302 EMERGENCIES

Back up lights
1. Remove the light mounting screw and pull the entire
light bracket out.2. Push the connector (A) to disconnect and remove the
light bulb.
N11H0140
N11H0150
EMERGENCIES 303
8

3. Remove the entire socket and bulb assembly (B) by
turning it counterclockwise.4. When mounting the light unit, align the pin (C) on the
light unit with the hole in the body.
N11H0160N11H0170
304 EMERGENCIES