2004 DODGE RAM 1500 GAS hood release

Each heated seat switch has two settings (HI and LOW).
Press the switch once to obtain the desired heating
position and press a second time in the same direction to
turn the heated seats OFF. If you do not purposefully
turn the switch OFF, the heating element in the seat will
remain activated until the ignition is turned off. The
indicators on the switch will illuminate when the heated
seats are in the (HI or LOW) position. Flashing telltale
lights on the switch indicate that the Heated Seat system
needs servicing.TO OPEN AND CLOSE THE HOOD
To open the hood, two latches must be released. First pull
the hood release lever located below the steering wheel at
the base of the instrument panel. Once the hood is
released you must reach into the opening beneath the
center of the grille and push up the latch to release the
safety catch before raising the hood.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 97
3

Steering Linkage Ð Inspection
Whenever the vehicle is hoisted, all steering linkage
joints should be inspected for evidence of damage. If
seals are damaged, parts should be replaced to prevent
leakage or contamination of the grease. Lubricate the
steering linkage regularly according to the ªMaintenance
Scheduleº in this manual.
Half-shaft Constant Velocity Joints
All four- wheel- drive 1500 models are equipped with
four constant velocity joints. Periodic lubrication of these
joints is not required. However, the joint boots should be
inspected for external leakage or damage periodically. If
external leakage or damage is evident, the joint boot and
grease should be replaced immediately. Continued op-
eration could result in failure of the joint due to water
and dirt contamination of the grease. This would require
complete replacement of the joint assembly. Refer to the
Service Manual for the detailed replacement procedure.
Body Lubrication
Locks and all body pivot points, including such items as
seat tracks, doors, tailgate and hood hinges, should be
lubricated periodically to assure quiet, easy operation
and to protect against rust and wear. Prior to the appli-
cation of any lubricant, the parts concerned should be
wiped clean to remove dust and grit; after lubricating
excess oil and grease should be removed. Particular
attention should also be given to hood latching compo-
nents to insure proper function. When performing other
underhood services, the hood latch, release mechanism
and safety catch should be cleaned and lubricated.
The external lock cylinders should be lubricated twice a
year, preferably in the fall and spring. Apply a small
amount of a high quality lubricant such as MopartLock
Cylinder Lubricant directly into the lock cylinder.
MAINTAINING YOUR VEHICLE 341
7

Fuel, Flexible.............See Flexible Fuel Vehicles
Fueling............................... 259
Fuses................................ 365
Garage Door Opener..................... 120
GasCap .............................. 260
Gasoline.............................. 256
Gasoline, Reformulated................... 257
Gauges............................... 147
Coolant Temperature.................... 146
Fuel................................ 150
Oil Pressure.......................... 145
Speedometer......................... 145
Tachometer.......................... 144
Voltmeter............................ 144
Gear Ranges......................208,214,216
Glass Cleaning.......................... 364
GVWR............................... 267Hands-Free Phone........................ 79
Hazard Warning Flasher................... 294
Head Restraints.......................... 93
Headlights..........................101,366
High Beam........................... 104
High Beam/Low Beam Select Switch........ 104
Lights On Reminder.................... 102
Passing............................. 104
Switch.............................. 101
Heated Mirrors....................78,191,195
Heated Seats............................ 96
Heater............................... 187
High Beam/Low Beam Select Switch.......... 104
Hitches
Trailer Towing........................ 274
Hoisting.............................. 312
Homelink Transmitter.................... 120
Hood Release........................... 97
Hoses................................ 347
INDEX 419
10