Page 19 of 300

Using the Panic Alarm
To activate the Panic mode while the ignition is OFF press
and release the PANIC button on the transmitter once.
When the Panic mode is activated, the interior lights will
illuminate, the headlamps and parking lights will flash,
and the horn will sound.
To cancel the Panic mode press and release the PANIC
button on the transmitter a second time. Panic mode will
automatically cancel after 3 minutes or if the vehicle is
started and exceeds 15 mph (24 km/h). During the Panic
Mode, the door locks and remote keyless entry systems
will function normally. Panic mode will not disarm the
security system on vehicles so equipped.
Programming Additional Transmitters
Vehicles with the keyless entry option will be shipped
from the assembly plants with two key fob transmitters
programmed only for that vehicle. A total of four fobs can
be programmed for your vehicle. Additional fobs can be
programmed to your vehicle through the use of a cur-
rently programmed fob.
NOTE:When entering program mode using that fob,
all other programmed fobs will be erased and you will
have to reprogram them for your vehicle.
Use the Following procedure to program additional key
fobs:
1. Enter your vehicle and close all doors.
2. Fasten your seat belt (Fastening the seatbelt will cancel
any chiming that may confuse you during this program-
ming procedure).
3. Place the key into the ignition.
4. Turn the ignition to the ON position (Do not start the
engine).
5. Press and hold the UNLOCK button on the key fob.
6. After holding the UNLOCK button for four seconds,
also press the PANIC button within 6 seconds.
7. Release both buttons and a single chime will be heard.
The chime is an indication that you have successfully
entered program mode. All fobs that are to be pro-
grammed must be done so within 30 seconds of when the
chime was heard.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 19
2
Page 55 of 300

UNDERSTANDING THE FEATURES OF YOUR VEHICLE
CONTENTS
mMirrors..............................58
NInside Day/Night Mirror.................58
NAutomatic Dimming MirrorÐ If Equipped....59
NOutside Mirrors.......................59
NExterior Mirrors Folding Feature...........59
NElectric Remote-Control Mirrors............60
NHeated Mirrors Ð If Equipped.............61
mSeats................................61
NSeat Adjustment.......................61
NReclining Seats........................62
N6 - Way Power Seat Adjuster Ð Driver's Side
Only...............................63NLumbar Support Adjustment Ð Power Seats
Only...............................63
NSeatback Releases Ð Bench Seat............63
NSeatback ReleasesÐBucket And Split Bench....64
NClub Cab Easy Entry System..............64
NClub Cab/Quad Cab Rear Seat.............65
mTo Open And Close The Hood.............66
mLights...............................67
NInterior Lights........................67
NBattery Saver.........................68
NHeadlamp Delay.......................68
NHeadlights, Parking Lights, Panel Lights......68
3
Page 68 of 300

also known as the9Party9mode because it allows the
doors to stay open for extended periods of time without
discharging the vehicle's battery.
The brightness of the instrument panel lighting can be
regulated by rotating the dimmer control up (brighter) or
down (dimmer). When the headlights are ON you can
supplement the brightness of the odometer, trip odom-
eter, radio and overhead console by rotating the control
up until you hear a click. This feature is termed the
ªParadeº mode and is useful when headlights are re-
quired during the day.
Club Cab/Quad Cab models may have an optional
switched dome lamp that may be operated by pressing
the lens.
Battery Saver
To protect the life of your vehicle's battery, Load Shed-
ding is provided for both the interior and exterior lights.
If the ignition is off and any door is left ajar for 15
minutes or the dimmer control is rotated upwards for 15
minutes, the interior lights will automatically turn off.If the headlamps remain on while the ignition is cycled
off, the exterior lights will automatically turn off after 5
minutes. If the headlamps are turned on and left on for 15
minutes while the ignition is off, the exterior lights will
automatically turn off.
NOTE:Battery Saver mode is cancelled if the ignition is
ON.
Headlamp Delay
To aid in your exit, your vehicle is equipped with a
headlamp delay that will leave the headlamps on for 60
seconds. This delay is initiated when the ignition is
turned OFF while the headlamp switch is on, and then
the headlamp switch is cycled off. The headlamps will
remain on for 60 seconds. Headlamp delay can be
cancelled by either turning the headlamp switch ON then
OFF or by turning the ignition ON.
Headlights, Parking Lights, Panel Lights
When the headlight switch is rotated to the first
position, the parking lights, taillights, side marker
lights, license plate light and instrument panel
lights are all turned on. The headlights will turn ON
when the switch is rotated to the second position.
68 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 256 of 300
4. Remove the bolts attaching the headlamp to the inner
fender panel.
5. Grasp the headlamp and pull firmly to disengage it
from the panel.
6. Disconnect all connectors and separate the headlamp
module from the vehicle
7. Remove the retaining ring holding the bulb to the
headlamp.
8. Pull the bulb socket from the headlamp and pull the
bulb from the socket.
NOTE:These are Halogen bulbs. Take care not to touch
the bulb with your fingers.
Parking/Turn Signal Lights
1. Remove the screw as shown and pull the parking/
turn signal housing out.2. Turn the bulb and socket assembly 1/4 turn and pull
to remove socket from housing.
3. The bulb can be removed from the socket by pulling
straight out.NOTE:Body oils from your fingers could cause exces-
sive heat buildup which reduces bulb life.
Rear Side Marker, Tail Lights, Turn Signals And
Backup Lights Ð Replacement
1. Remove the screws as illustrated. Grasp the tail light
housing and pull it rearward.
256 MAINTAINING YOUR VEHICLE