2004 DAEWOO LACETTI service

BODY REPAIR MANUAL
(NUBIRA/LACETTI)
ISSUED BY
SERVICE ENGINEERING TEAM
GM DAEWOO AUTO & TECHNOLOGY CO., LTD.
199–1 CHONG CHON–DONG, PU PYUNG–GU,
INCHON, KOREA
TELEPHONE : 82–32–520–2737,2064
FACSIMILE : 82–32–520–4808

9–14 SEALING, CAULKING AND DEADNER NUBIRA/LACETTI
2. DEADNER
2–1. GENERAL DESCRIPTION
.
Deadner is properly designed and applied for reduce the
vibration and noise. Also, it plays in maintaining the
structural rigidity of the panel.
.
2–2. REPAIR PROCEDURE
.
1. Remove the related parts.
S Seats, carpet.
S Trims, others.
.
2. Removal of the damaged deadner.
S Peel off the damaged deadner with a steel spatula, care-
fully.
.
3. Clean and dry.
S Before applying the deadner, thoroughly clean and dry
the areas to be applied.
.
4. Prelocation the new deadner on the panels to be ap-
plied.
.
Note : Avoid the parts mounting holes and service holes.
.
5. Adhension of deadner.
S Heat the surface of deadner with a torch or heating gun
until it adheres itself.
S Push and adhere to the panel with a rubber spatula.
.
Note : In order to take full advantage of the deadner, its
face must adhere and contact the panels perfectly.
.
CAUTION : Be careful not to burn the composite
parts when beating.
Fig. 13
6. Install the related parts.
S Install in the reverse order in which they were removed.
Fig. 14

10–4 RUST PREVENTIONNUBIRA/LACETTI
Precautions:
.
1. Before applying an anti–rust agent, thoroughly clean
the areas to be coated with a steam cleaner, etc., and
let dry.
.
Note : Waxoyl may be applied to wet surface.
.
2. Spray an anti–rust agent sufficiently until the excess
amount oozes out when filling, the doors, etc. Wipe the
excess agent with a clean rag dampened with light oil.
.
3. Do not spray an anti–rust agent to the brake hoses,
brake wheel cylinders, brake drums, exhaust muffler
and its related parts, emission control devices in the en-
gine compartment, ball joint covers, etc. Wipe up spilled
agent at once.
.4. Heat an anti–rust agent to room temperature[36.5
C
(97.7
F)] by submerging the container in hot water
when outside temperature is below 10
C(50
F).
.
5. Ventilate when spraying an anti–rust agent since it
contains a small amount of organic solvent. Keep
sparks, flames and cigarettes away.
.
CAUTION : The remaining agent will harden in the
passages of the spray gun, making them unservice-
able.