2004 DACIA SUPERNOVA lights

80
BATTERY - FRONT HEADLIGHTS
80 - 7
HEADLAMPS ADJUSTMENT
MEETING LIGHTS ADJUSTMENT (LOW BEAM) This is performed by acting upon the V screw
(vertically p lane adjustment) or H (horizontally
p lane adjustment). By screwin g, t he lighting beam
is ”lowering” and by unscrewing is “ascending”.
Check if the lighted area i s centered on the
vertical axis and if the optical separation at 15°
coincide with the headlamp lighting. An error
of 1 cm is admissible.
A lighting beam displaced towards left has
the aspect shown in ( pict.a) and a lighting beam
displaced towards right has the aspect shown
in (pict.b).
RO AD LIGHTS ADJUSTMENT (LONG BEAM)
Check the position to coincide with the
adjustment performed for low beam a nd with
the lighting beam distributed between the two
vertical lines on the panel. When checking the long beam, the lighting
center of the ellipse, must be located on the
cross marking the screen center.
If a m ajor de viation c ompared with t he low be am i s noticed, i t is re commended t he bul b
replacement, this one being in most of the cases, responsible for such defect.
pict.a
pict.b
vnx.su

80
BATTERY - FRONT HEADLIGHTS
80 - 8
HEADLAMPS ADJUSTMENT
FOG LAMPS ADJUSTMENT
The fog lamps adjustment is to be performed in the following conditions:
- the vehicle to be placed on a horizontal surface;
- the vehicle has not passengers inside the cockpit or weights in the trunk;
- the tires a re pressurized a t the manufacturer prescribed pressure.
Further on, proceed as follows:
Bring the vehicle at the working place.
Position the adjustment device (headlamp adjustment device – E) in front of an optical center
of a fog lamp.
Switch on the fog lamps.
Rotate the adjustment screw of the fog lamp (D), so that an adjustment of 2 % is obtained and
the separation between the lighted area and the dark one from the adjustment device is located
under the marked line (G).
This adjustment is performed in the same way as for the meeting lights adjustment.
Bring the adjustment device in front of the optical center of the second fog lamp.
Perform the fog lamp adjustment.
Switch off the fog lamps.
G
E
vnx.su

REAR AND INTERIOR LIGHTING
81
81 - 2
BULBS
Hugh/low beam lights Two phases bulb R2-12V-40/45 W
He adl a mp swith flange holder P45t41
Parking lights Bulb 12V-4W with holder BA 9s
Front turning lamp Bulb 12V-21W (colored) with holder BAU 15s
Fog lamps Halogen bulb H3, 12V-55W with holder Pk22s
Rear Parking, stop lights Bulb 12V-21/5W with holder BAY 15d
lamps Turning and reverse driving Bulb 12V-21W with holder BA15s
Rear fog lamps Bulb 12V-21W with holder BA 15s
Lamps: side signaling, trunk lighting Bulb 12V-5W with holder W2,1x9,5
License plate, ceiling, document compartment Bulb SOFIT 10 x 35 type AS02; 12 V-5W
lamps with holder Sv 8,5
Lamp STOP-S3 on the ceiling Bulb 12V-21W type C21W with holder Sv 8,5
Instrument panel Bulb 12V-1,2W holderW 2 x 4,6d BULBS
vnx.su

REAR AND INTERIOR LIGHTING
81
81 - 4
FOG LAMPS NOT WORKING
F 10 fuse is burnt; replace the fuse.
The relay is supplied.
Ground wire broken. Check the fuse F 10.
F
10 fuse is good.
Check the supply of the R1 relay.
The relay is supplied.
Check the lamps supply. The relay i s not supplied. Is there + 12 V
at pole 4 of the fog lamps contact ?
Disconnected wiresor defect contact. Lights switch
device
defect or F05 fuse burnt.
Lamps are not supplied .Check the fog lamps control relay.
Relay defect.
Replace the relay. Relay good. Lamps supplying
wire
broken or disconnected.
Yes No
DIAGNOSTIC
vnx.su

81
REAR AND INTERIOR LIGHTING
81 - 5
BRAKE STOP LIGHTS NOT WORKING
Check F 01 fuse.
F 01 fuse burnt ; replace it.Fuse is good.
Bridge across the brake stop contact.
Stop lamps are lighting. Replace the contact. Stop lamps are not lighting.
Check the contact supplying.
Wire is broken: replace the wire.Contact is supplied. Lamps supply
wi re is disconnected or broken.
DIAGNOSTIC
vnx.su

81
REAR AND INTERIOR LIGHTING
81 - 7
A.
FOR VEHICLES MANUFACTURED TILL 01.06.2001
The fuses are protecting the following electric circuits:
FUSE
NUMBER FUSE
TYPE
PROTECTED CIRCUIT
Clock, radio, STOP contact, climate blower relay control
Reverse driving contact
UCE decoder, speed transducer, instrument panel supply, diagnostic
socket, AC starting button, UCE anti intrusion
Turning and hazard lights
Front/rear parking lights, lighting: switches, instrument panel, climate
control, documents compartment, cigarette lighter, ashtray, radio
Cigarette lighter, instrument panel (anti-starting indicator), front right
ceiling lamp, UCE anti intrusion, anti intrusion indic
ator, diagnostic socket
Windscreen wiper-washing switch, windscreen wiper timer
Rear window defrosting
Climate blower
Left fo g lamp
F01
F02
F03
F04
F05
F06
F07
F08
F09
F10 15A
5A
15A
7,5A
5A
15A
15A
20A
15A
5A
COCKPIT FUSE BOX
vnx.su

81
REAR AND INTERIOR LIGHTING
B. FOR VEHICLES MANUFACTURED AFTER 01.06.2001
AND VEHICLES RESPECTING EURO 2000 POLLUTION NORM
The fuses are protecting the following electric circuits:
FUSE
NUMBER FUSE
TYPE
PROTECTED CIRCUIT
Clock, radio, STOP contact, climate blower relay control
Reverse driving contact
UCE decoder, speed transducer, instrument panel supply, diagnostic
socket, AC starting button, UCE anti intrusion.
Turning and hazard lights
Front/rear parking lights, lighting: switches, instrument panel, climate
control, documents compartment, cigarette lighter, ashtray, radio.
Cigarette lighter, clock, instrum
ent panel (anti-starting indic ator), front right
ceiling la mp, UCE anti intrusion, anti intrusion indicator, diagnostic socket.
UCE decoder, FLASH relay, anti starting bushing
Rear window defrosting
Climate blower
Left fo g lamp
F01
F02
F03
F04
F05
F06
F07
F08
F09
F10 15A
5A
15A
7,5A
5A
15A
15A
20A
15A
5A
81 - 9
COCKPIT FUSE BOX
vnx.su

82A
HORN - ENGINE IMMOBILISER
82A - 4
NOTE :
The vehicles equipped with this anti starting system, have a type of decoder, and those
provided also with RF remote control for locking/ unlocking doors have another type
of decoder.
The identification of the two types of E.C.U. de coder i s realised by the inscriptions on
the labels as fol lows: -code P8200032783H and the inscription TRANS-PLAF for the vehicles without
RF remote control ;
-code P82000 32776H and the inscription TRF-TRANS-CAR for the vehicles
with RF remote control.
ANTI STARTING INDICATOR
It is located on the instrument panel (picture 8, position A) and has the following functions: - signals the activation of the anti starting system
- signals the case of non identifying the key head
- signals the entrance in the operation mode “resynchronisation” of the remote controls,
RF with E.C.U. decoder, for the vehicles which use the RF remote control.
pict.7
pict.8
A
GENERALITIES
The dome ceiling lighting is activated subject to the position of the switch
(picture 7, position 1):
- position A the ceiling lights permanently
- position B the ceiling turned off
- position C dome ceiling lighting; this will light for 5 seconds after a front door closing or
after the command of unlocking the doors with the RF remote control. This delay turns out in the
moment of setting the contact.
vnx.su