2004 CHRYSLER VOYAGER ECU

[x] Cancel search: ECU

Page 440 of 2585

CHRYSLER VOYAGER 2004  Service Manual The battery tray and support unit also includes a
engine vacuum reservoir, located in the rear of the
unit (Fig. 17). And a drainage hose, located in the
front of the unit (Fig. 17).
OPERATION
The bat

Page 459 of 2585

CHRYSLER VOYAGER 2004  Service Manual ²Battery Holddown - The battery holddown
hardware secures the battery in the battery tray in
the engine compartment. ² Battery Thermowrap - The battery thermow-
rap insulates the battery to protect

Page 471 of 2585

CHRYSLER VOYAGER 2004  Service Manual between the disconnected battery negative cable ter-
minal clamp and the battery negative terminal post.
Make sure that the doors remain closed so that the
illuminated entry system is not activated. T

Page 472 of 2585

CHRYSLER VOYAGER 2004  Service Manual WARNING: REMOVE METALLIC JEWELRY TO
AVOID INJURY BY ACCIDENTAL ARCING OF BAT-
TERY CURRENT.(1) Verify that the ignition switch and all accesso-
ries are OFF. (2) Disconnect the battery cables from the

Page 473 of 2585

CHRYSLER VOYAGER 2004  Service Manual (2) Remove the nut with washer that secures the
battery hold down bracket to the battery tray and
support unit. (3) Remove the battery hold down bracket from
the battery tray and support unit.
INSTALL

Page 475 of 2585

CHRYSLER VOYAGER 2004  Service Manual eyelet terminal connection to the engine block.
Repeat the test. If the reading is still above 0.2 volt,
replace the faulty battery negative cable.
REMOVAL
The battery cables on this model may include

Page 505 of 2585

CHRYSLER VOYAGER 2004  Service Manual (4) Reconnect the instrument panel switch bank
and test the heated seat system for proper operation.
If the system is still inoperative proceed with check-
ing remaining components.
REMOVAL
WARNING: O

Page 507 of 2585

CHRYSLER VOYAGER 2004  Service Manual (3) Connect the negative battery cable.
(4) Verify heated seat system operation.
(5) Install the appropriate seat cushion or seat
back trim cover. Make certain the seat wire harness
is correctly route