2004 CHRYSLER PT CRUISER oil viscosity

ENGINE BREAK-IN RECOMMENDATIONS
A long break-in period is not required for the engine in
your new vehicle.
Drive moderately during the first 300 miles (500 km).
After the initial 60 miles (100 km), speeds up to 50 or 55
mph (80 or 90 km/h) are desirable.
While cruising, brief full-throttle acceleration, within the
limits of local traffic laws, contributes to a good break-in.
Wide open throttle acceleration in low gear can be
detrimental and should be avoided.
The engine oil installed in the engine at the factory is a
high quality energy conserving type lubricant. Oil
changes should be consistent with anticipated climate
conditions under which vehicle operations will occur.
The recommended viscosity and quality grades are
shown in Section 7 of this manual. NON-DETERGENT
OR STRAIGHT MINERAL OILS MUST NEVER BE
USED.A new engine may consume some oil during its first few
thousand miles (kilometers) of operation. This should be
considered as a normal part of the break-in and not
interpreted as an indication of difficulty.
SAFETY TIPS
Exhaust Gas
WARNING!
Exhaust gases can injure or kill. They contain carbon
monoxide (CO) which is colorless and odorless.
Breathing it can make you unconscious and can
eventually poison you. To avoid breathing (CO)
follow the safety tips below.
Do not run the engine in a closed garage or in confined
areas any longer than needed to move your vehicle in or
out of the area.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 59
2

American Petroleum Institute (API) Engine Oil
Identification Symbol
This symbol means that the oil has
been certified by the American
Petroleum Institute (API). The
manufacturer only recommends
API Certified engine oils.
Engine Oil Viscosity (SAE Grade)
The proper SAE viscosity grade of engine oil should be
selected based on the following recommendation and be
within the operating temperature shown in the engine oil
viscosity chart.²SAE 5W-30engine oil is preferred. SAE 5W-30 engine
oils improve low temperature starting and helps ve-
hicle fuel economy.
Lubricants which do not have both, the engine oil certi-
fication mark and the correct SAE viscosity grade num-
ber should not be used.
254 MAINTAINING YOUR VEHICLE

Synthetic Engine Oils
There are a number of engine oils being promoted as
either synthetic or semi-synthetic. If you chose to use
such a product, useonlythose oils that are American
Petroleum Institute (API) Certified and SAE viscosity
standard. Follow the service schedule that describes your
driving type.
Materials Added To Engine Oils
The manufacture strongly recommends against the addi-
tion of any additives (other than leak detection dyes) to
the engine oil. Engine oil is an engineered product and
it's performance may be impaired by supplemental ad-
ditives.
Disposing of Used Engine Oil
Care should be taken in disposing of used engine oil from
your vehicle. Used oil, indiscriminately discarded, can
present a problem to the environment. Contact yourdealer, service station, or governmental agency for advice
on how and where used oil can be safely discarded in
your area.
Engine Oil Filter
The engine oil filter should be replaced at every engine
oil change.
Engine Oil Filter Selection
All of this manufacturers engines have a full-flow type
disposable oil filter. Use a filter of this type for replace-
ment. The quality of replacement filters varies consider-
ably. Only high quality filters should be used to assure
most efficient service. Mopar Engine Oil Filters are high
quality oil filters and are recommended.
MAINTAINING YOUR VEHICLE 255
7

RECOMMENDED FLUIDS, LUBRICANTS AND GENUINE PARTS
Engine
Component Fluids, Lubricants and Genuine Parts
Engine Coolant MopartAntifreeze/Coolant 5 Year/100,000 Mile Formula HOAT (Hybrid Or-
ganic Additive Technology)
Engine Oil Use API Certified SAE 5W-30 Engine Oil. Refer to oil viscosity chart for cor-
rect SAE grade meeting DaimlerChrysler Material Standard MS-6395.
Engine Oil Filter Non TurboÐMopar 4105409 or equiv. TurboÐMopar 4781452AA or equiv.
Spark Plugs Refer to the Vehicle Emission Control Information label in the engine com-
partment.
Fuel Selection 91 Octane for High Output 2.4L Turbo and 87 Octane for 2.4L Standard
Turbo and 2.4L Standard Non Turbo Engines.
MAINTAINING YOUR VEHICLE 291
7

Exhaust Gas Caution.................... 220
Fuel Requirements..................... 216
Jump Starting......................... 235
Oil ...........................251,290,291
Oil Change Interval.................... 252
Oil Filter............................ 291
Oil Selection.......................... 253
Oil Synthetic......................... 255
Overheating.......................... 228
Temperature Gauge..................... 130
Timing Belt.......................... 258
Engine Oil Viscosity Chart................. 254
Exhaust Gas Caution..............28,59,220,264
Exhaust System......................... 264
Filler Location Fuel...................... 135
Filters
Air Cleaner.......................... 258
Engine Fuel.......................... 258Engine Oil........................255,291
Flashers.............................. 228
Hazard Warning....................... 228
Flat Tire Stowage........................ 235
Flooded Engine Starting................... 181
Fluid, Brake........................... 292
Fluid Capacities......................... 290
Fluid Leaks............................. 61
Fluid Level Checks
Automatic Transaxle.................... 273
Fog Light Service........................ 288
Fog Lights...........................97,135
Folding Rear Seat........................ 86
Freeing A Stuck Vehicle................... 239
Fuel..............................216,291
Adding............................. 221
Additives............................ 219
Capacity............................ 290
Clean Air............................ 217
330 INDEX

Odometer............................. 133
Trip .............................133,135
Oil, Engine.........................251,290
Capacity............................ 290
Change Interval....................... 252
Checking............................ 251
Disposal............................ 255
Filter............................... 255
Identification Logo..................... 254
Materials Added to..................... 255
Quality............................. 254
Recommendation...................253,290
Synthetic............................ 255
Viscosity............................ 254
Oil Pressure Light....................... 129
Onboard Diagnostic System..............248,249
Operator Manuals......................... 4
Outside Air Intake....................... 172
Overdrive............................. 186Overhead Console....................... 104
Overhead Travel Information Center.......... 104
Overheating, Engine...................... 228
Owner's Manual.......................4,322
Paint Care............................. 276
Panel Rear Shelf......................... 114
Panic Alarm............................ 23
Parking Brake.......................... 192
Passing Light........................... 97
Pets.................................. 58
Phone, Cellular.......................... 70
Phone, Hands-Free....................... 70
Placard, Tire and Loading Information......... 202
Power
Distribution Center..................... 282
Door Locks........................... 19
Outlet.............................. 110
Steering..........................196,261
INDEX 335
10