2004 CADILLAC ESCALADE ESV spare tire

7. Make sure the tire is stored securely. Push, pull
and then try to rotate or turn the tire. If the tire
moves, use the wheel wrench to tighten the cable.
Reinstall the spare tire lock (if equipped).
To store the tools, follow these procedures:For Escalade, do the following:
1. Put the tool kit and the jack tools in the tool bag
and place in the retaining clip above the jack.
2. Tighten down with the wing nut.
3. Then, assemble wheel blocks and jack together
with the wing nut and retaining hook.
4. Position behind the jack storage cover in the left
rear side panel and tighten, adjusting clockwise
until the jack is secured tight in the mounting
bracket. Be sure to position the holes in the base of
the jack onto the pin in the mounting bracket.
For Escalade ESV, do the following:
1. Return the tool kit and jack tools to the tool bag.
2. Assemble wheel blocks and jack together with the
wing nut and retaining hook.
3. Position under the jack storage tray in the left rear
side panel below the wheelbase and tighten,
adjusting clockwise until the jack is secured tight in
the mounting bracket. Be sure to position the
holes in the base of the jack onto the pin in the
mounting bracket.
4. Use the retaining clip to fasten the tool kit on the stud
in the storage compartment in the rear left trim panel
and turn the wing nut clockwise to secure.
5. Return the storage tray. (A) Push and Pull (B) Rotate or Turn
5-99

Secondary Latch System
Your vehicle has an underbody mounted tire hoist
assembly equipped with a secondary latch system. It’s
designed to stop the spare tire from suddenly falling
off your vehicle. For the secondary latch to work,
the spare must be installed with the valve stem pointing
down. See “Storing a Flat or Spare Tire, Jack and
Tools” earlier in this section.
{CAUTION:
Before beginning this procedure read all the
instructions. Failure to read and follow the
instructions could damage the hoist assembly
and you and others could get hurt. Read and
follow the instructions listed below.To release the spare tire from the secondary latch do
the following:
1. Check under the vehicle to see if the cable end is
visible.
2. If the cable is not visible proceed to Step 6.
If it is visible, rst try to tighten the cable by turning
the wheel wrench clockwise until you hear two
clicks or feel it skip twice. You cannot overtighten
the cable.
3. Loosen the cable by turning the wrench
counterclockwise three or four turns.
5-101

4. Repeat this procedure at least two times. If the
spare tire lowers to the ground, continue with
Step 5 of “Removing the Spare Tire and Tools”
earlier in this section.
5. Turn the wrench counterclockwise until
approximately six inches (15 cm) of cable is
exposed.
6. Stand the wheel blocks
on their shortest ends,
with the backs
facing each other.7. Place the bottom edge of the jack on the wheel
blocks, separating them so that the jack is
balanced securely.
5-102

8. Attach the jack handle, extension, and wheel
wrench to the jack and place it (with the wheel
blocks) under the vehicle towards the front of the
rear bumper. Position the center lift point of the jack
under the center of the spare tire.
9. Turn the wrench clockwise to raise the jack until it
lifts the end tting.
10. Continue raising the jack until the spare tire stops
moving upward and is held rmly in place. The
secondary latch has released and the spare tire is
balancing on the jack.11. Lower the jack by turning the wheel wrench
counterclockwise. Keep lowering the jack until the
spare tire slides off the jack or is hanging by
the cable.
{CAUTION:
Someone standing too close during the
procedure could be injured by the jack. If the
spare tire does not slide off the jack
completely, make sure no one is behind you or
on either side of you as you pull the jack out
from the spare.
12. Disconnect the jack handle from the jack and
carefully remove the jack. Use one hand to push
against the spare while rmly pulling the jack out
from under the spare tire with the other hand.
If the spare tire is hanging from the cable, insert the
hoist handle, extension and wheel wrench into
the hoist shaft hole in the bumper and turn
the wheel wrench counterclockwise to lower the
spare the rest of the way.
5-103

13. Tilt the retainer at the
end of the cable and
pull it through the
wheel opening. Pull the
tire out from under
the vehicle.
14. If the cable is hanging under the vehicle, turn the
wheel wrench clockwise to raise the cable back up.
Have the hoist assembly inspected as soon as you can.
You will not be able to store a spare or at tire using
the hoist assembly until it has been replaced.
To continue changing the at tire, see “Removing the
Flat Tire and Installing the Spare Tire” earlier in
this section.Spare Tire
Your vehicle, when new, had a fully inated spare tire.
A spare tire may lose air over time, so check its ination
pressure regularly. SeeInation - Tire Pressure on
page 5-74andLoading Your Vehicle on page 4-50for
information regarding proper tire ination and loading
your vehicle. For instruction on how to remove, install or
store a spare tire, seeChanging a Flat Tire on page 5-86.
After installing the spare tire on your vehicle, you should
stop as soon as possible and make sure the spare is
correctly inated. Have the damaged or at road
tire repaired or replaced as soon as you can and
installed back onto your vehicle. This way, a spare tire
will be available in case you need it again.
Your vehicle may have a different size spare tire than
the road tires— those originally installed on your vehicle.
This spare tires was developed for use on your
vehicle, so it’s all right to drive on it.
If your vehicle has a spare tire that does not match your
vehicle’s original road tires and wheels in size and
type, do not include the spare in the tire rotation.
5-104

Owner Checks and Services
These owner checks and services should be performed
at the intervals specied to help ensure the safety,
dependability and emission control performance of your
vehicle. Your GM Goodwrench dealer can assist you
with these checks and services.
Be sure any necessary repairs are completed at once.
Whenever any uids or lubricants are added to your
vehicle, make sure they are the proper ones, as shown
inRecommended Fluids and Lubricants on page 6-13.
At Each Fuel Fill
It is important to perform these underhood checks at
each fuel ll.
Engine Oil Level Check
Check the engine oil level and add the proper oil if
necessary. SeeEngine Oil on page 5-14for further
details.
Notice:It is important to check your oil regularly
and keep it at the proper level. Failure to keep your
engine oil at the proper level can cause damage
to your engine not covered by your warranty.
Engine Coolant Level Check
Check the engine coolant level and add
DEX-COOL®coolant mixture if necessary. SeeEngine
Coolant on page 5-24for further details.
Windshield Washer Fluid Level Check
Check the windshield washer uid level in the windshield
washer tank and add the proper uid if necessary.
At Least Once a Month
Tire Ination Check
Visually inspect your tires and make sure tires are
inated to the correct pressures. Do not forget to check
your spare tire. SeeTires on page 5-65for further
details. Check to make sure the spare tire is stored
securely. Push, pull and then try to rotate or turn
the spare tire. If it moves, tighten it. SeeChanging a
Flat Tire on page 5-86.
6-10

Removing the Flat Tire and Installing the
Spare Tire..................................................5-91
Removing the Spare Tire and Tools...................5-87
REPLACE LIFTGATE FUSE.............................3-67
Replacement Bulbs.........................................5-63
Replacing Brake System Parts..........................5-42
Replacing the 50/50 Split Bench Seat................1-19
Replacing the Bench Seat................................1-26
Reporting Safety Defects
Canadian Government..................................7-12
General Motors...........................................7-12
United States Government............................7-12
Reprogramming a Single HomeLink
®Button.......2-42
Resetting Defaults...........................................2-42
Restraint System Check
Checking Your Restraint Systems...................1-95
Replacing Restraint System Parts After
a Crash..................................................1-96
Restraint Systems
Checking....................................................1-95
Replacing Parts...........................................1-96
Resynchronization............................................. 2-7
Retained Accessory Power (RAP)......................2-19
Returning the Seat to an Upright Position...........1-24
Returning the Seatbacks to an Upright Position......1-29
Returning the Seats to an Upright Position.........1-14
Returning the Seat(s) to an Upright Position.......1-16
Right Front Passenger Position, Safety Belts......1-44RIGHT REAR DOOR AJAR..............................3-67
Road Sensing Suspension................................. 4-9
Roadside
Service........................................................ 7-6
Roadside Service Availability.............................. 7-7
Roadside Service for the Hearing or Speech
Impaired...................................................... 7-8
Rocking Your Vehicle To Get It Out...................4-47
Routing, Engine Drive Belt...............................6-16
Running Your Engine While You Are Parked.......2-30S
Safety Belt
Reminder Light............................................3-36
Safety Belts
Care of....................................................5-108
Center Passenger Position............................1-44
Driver Position............................................1-36
How to Wear Safety Belts Properly................1-35
Questions and Answers About Safety Belts........1-34
Rear Safety Belt Comfort Guides for Children
and Small Adults......................................1-49
Rear Seat Passengers.................................1-46
Right Front Passenger Position......................1-44
Safety Belt Extender....................................1-52
Safety Belt Use During Pregnancy.................1-43
Safety Belts Are for Everyone.......................1-30
13

Safety Chains.................................................4-63
Safety Warnings and Symbols.............................. iii
Scanning the Terrain.......................................4-21
Scheduled Maintenance..................................... 6-5
Seats
50/50 Split Bench Seat.................................1-14
60/40 Split Bench Seat.................................1-12
Bench Seat................................................1-21
Bucket Seats, Rear......................................1-27
Head Restraints............................................ 1-8
Heated and Cooled Seats......................1-6, 1-11
Heated Seats............................................... 1-5
Heated Seats, Rear.....................................1-11
Memory.....................................................2-48
Power Lumbar.............................................. 1-4
Power Seats................................................. 1-3
Rear Seat Operation...................................... 1-9
Reclining Seatbacks...................................... 1-7
Second Row..................................................1-73
Second Row – Lap-Shoulder Belt......................1-44
Secondary Latch System................................5-101
Securing a Child Restraint
Center Rear Seat Position............................1-73
Designed for the LATCH System...................1-70
Rear Outside Seat Position...........................1-70
Right Front Seat Position..............................1-75
Security Light.................................................3-48Select Button.................................................3-61
Service........................................................... 5-3
Adding Equipment to the Outside of Your
Vehicle..................................................... 5-5
Doing Your Own Work................................... 5-4
Engine Soon Light.......................................3-45
Publications Ordering Information...................7-13
SERVICE 4WD...............................................3-64
SERVICE AIR BAG.........................................3-63
SERVICE BRAKE SYSTEM.............................3-64
Service Bulletins.............................................7-13
Service Manuals.............................................7-13
SERVICE RIDE CONTROL..............................3-64
SERVICE STABILITY......................................3-68
SERVICE TIRE MONITOR...............................3-69
Setting Preset PTYs (RDS Only).......................3-76
Setting Preset Stations....................................3-73
Setting the Time.............................................3-70
Setting the Tone (Bass/Treble)..........................3-73
Sheet Metal Damage.....................................5-111
Shifting Into Park (P).......................................2-26
Shifting Out of Park (P)...................................2-29
Skidding........................................................4-17
Some Other Rainy Weather Tips.......................4-36
Spare Tire....................................................5-104
Specications, Capacities...............................5-124
Speedometer..................................................3-36
14