2004 BMW MOTORRAD K 1200 S turn signal

Status indicators220
Overview
The following table lists the possible warnings and pages with additional information.

Light Symbol Meaning Explanations
Ignition key not authorised. (
b 22)
Low-beam headlight, high-beam
headlight, parking light or turn signal
lamp defective. (b 24)
Defective lamp. (b 24)
yellow Fuel reserve reached. (b 22)
yellow Fault in engine electronics. (b 23)
yellowRear light or brake light lamp
defective. (b 24)
red Coolant temperature too high. (b 22)
red Engine oil pressure too low. (b 23)

Operation332
In-key securityAn electronic component is inte-
grated into each of your keys.
The motorcycle’s electronics
exchange certain continuously
changing signals with the elec-
tronics in the key; these signals
are specific to your motorcycle
and they are transmitted via the
ring antenna in the ignition lock.
The ignition is not enabled for
starting until the key has been
recognised as authorised for
your motorcycle.
A spare key attached to
the same ring as the igni-
tion key used to start the engine
could "upset" the electronics, in
which case the enabling signal
for starting is not issued. The
"EWS" warning is displayed in
the multifunction display. Always store the spare key sep-
arately from the ignition key.c
Replacement and extra
keysYou can only obtain replace-
ment/extra keys through an
authorised BMW motorcycle
dealer. The keys are part of an
integrated security system, so
the dealer is under an obligation
to check the legitimacy of all
applications for replacement/
extra keys.
If you want to have a lost key
barred, you have to bring with
you all the keys that belong to
the motorcycle. A key that has
been barred can subsequently
be cleared and reactivated for
use.
Hazard warning flashersSwitching on the hazard
warning flashers• Switch on the ignition.
• Press the hazard warning
flashers button 1.
» Hazard warning flashers in
operation.
» Left/right turn indicator tell-
tale lights flash.
• Switch off the ignition.
» The hazard warning flashers
continues to operate.

6109
Maintenance
• Remove the bolt 1.
• Pull the lamp housing
towards the rear from the
brackets 2.• Remove the bulb holder 3
from the lamp housing by
turning it anticlockwise.
• Press the bulb into the fitting
and remove it by turning
anticlockwise.
Assemble in reverse order.
• To hold the new bulb, use a
clean, dry cloth.
Replacing the front turn
signal lamp
During the work de-
scribed below, a motor-
cycle that has been parked
unsafely can fall over.
Make sure that the motorcycle
is parked securely.c
• If necessary, switch off the
ignition.
• Remove the bolt 1.