2004 BMW MOTORRAD K 1200 R reset

Operation338
Residual range The residual range is not dis-
played until the fuel level drops
to reserve. It is calculated on
the basis of your style of riding
and the amount of fuel left in
the tank.
If the motorcycle is resting on
its side stand the level in the
tank cannot be measured cor-
rectly, so this estimate of
residual operating range will
be inaccurate.The Tripmaster registers that
you have refuelled when
approximately 3 litres have
been added.
Resetting the trip meter• Switch on the ignition.
• Select the desired tripmeter.
• Press Tripmaster button
1
for longer than 2 seconds.
» The tripmeter is reset to
zero.Emergency off switch
(kill switch)The emergency off switch is a
kill switch for switching off the
engine quickly. Operating the kill switch
when riding can cause
the rear wheel to lock, provok-
ing a fall.
Do not operate the kill switch
when riding. c
• Turn kill switch 1 to the left or
right to position B.
» The engine electronics con-
trol unit switches the engine
off.
» The engine cannot be started while the switch is in
this position.

6119
Maintenance
• Disconnect the battery's negative lead 2 first.
• Then disconnect positive lead 3.
•Slacken screws 4 and pull
the retainer to the rear.
• Lift the battery up and out; work it slightly back and forth
if it is difficult to remove.
Installing battery
The types of screw used
are listed, complete with
tightening torques, on
(
b
128). c
If it is not standing firmly,
the motorcycle could
topple in the course of the
operations described below.
Make sure that the motorcycle
is steady on its stand. c
• Switch off the ignition.
• Place the battery in the bat- tery compartment, positive
terminal on the right in the
direction of travel.
• Slip the clip over the battery and hand-tighten the
screws. •Connect the positive
lead first and hand-tighten
the screw.
• Then connect the negative lead and hand-tighten the
screw.
• Install the cover of the bat-
tery compartment and hand-
tighten the screw.
• Switch on the ignition.
• Fully open the throttle once or twice.
» The engine management system records the throttle-
valve position.
Remember to reset the
clock after reconnecting
the battery. c

Indexi158
LuggageSafety information, 54
Strapping, 45MMotorcycle equipment, 5
Multifunction display, 16NNeutral, telltale light, 20PParking light, 42
Bulb, 17
Replacing bulb, 112
Parking your motorcycle, 71
Power socket,9,80,139
Pre-ride check, 57RRear light, replacing bulb, 113
Rear wheel stand, 108
Replacement keys, 36
Resetting the tripmeter, 38
Residual braking function, 77
Residual range, 38 Restoring to use, 125
Rev. counter, 16
Rider’s equipment, 6
Running in
Brake pads, 64
General information, 63
SSafety check before a journey, 56
Safety instructions, 54
Seat Installing, 44
Lock, 9
Removing, 44
Sensor for instrument cluster lighting, 16
Shifting gear, 65
Side stand Extending, 67
Position on starting, 60
Retracting, 69
Spark plugs, technical data, 138 Speed
Safety information, 54
Technical data, 141
Speedometer, 16
Spray guard, 120
Starter, 15
Starting, 60
Symbols, 4
TTechnical data Dimensions and weights, 140
Electrical system, 138
Engine, 131
Frame and suspension, 133
Fuel and lubricants, 136
Information, 5
Power transmission, 132
Riding specifications, 141
Threaded fasteners, 128
Wheels, 135
Telltale lights, 16, 20
Threaded fasteners, 128