2004 Acura TSX light

The appropriate light comes on in
this display if the trunk or any door
is not closed tightly.
All the lights in the monitor display
come on f or a f ew seconds when you
turn the ignition switch to ON (II).The lef t or right turn signal light
blinks when you signal a lane change
or turn. If the light does not blink or
blinks rapidly, it usually means one
of the turn signal bulbs is burned out
(see page ). Replace the bulb as
soon as possible, since other drivers
cannot see that you are signaling.
This indicator has three f unctions:
Itcomesonasareminderthatyou
have turned of f the Vehicle
Stability Assist (VSA) system.
It flashes when VSA is active (see
page ).
It comes on along with the VSA
system indicator if there is a
problem with the VSA system.
This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to ON (II). See page f or more inf ormation on the
VSA system. Whenyouturnonthehazard
warning switch, both turn signal
lights blink, and all turn signals on
the outside of the car should f lash.
1.
2.
3.
216
216 284
Indicator L ights
Inst rument s and Cont rols
Turn Signal and
Hazard Warning
Indicators
VSA A ctivation Indicator Door and T runk Open Monitor
62

This indicator reminds you that the
exterior lights are on. It comes on
when the light switch is in either theor position. If you turn the
ignition switch to ACCESSORY (I)
or LOCK (0) without turning of f the
light switch, this indicator will
remain on. A reminder chime will
also sound when you open the driver’s
door.
This indicator is located in the f uel
gauge. It comes on as a reminder
that you must ref uel soon.This indicator lights when the
security system is set. See page
f or complete inf ormation on the
security system. 173
Indicator L ights
Inst rument s and Cont rols
Lights On Indicator Low Fuel Indicator
Security System Indicator
63
SECURITY SYSTEM INDICATOR
LOW FUEL INDICATOR

This indicator comes on f or a f ew
seconds when you turn the ignition
switch ON (II). It will then go of f if
you have inserted a properly-coded
ignition key. If it is not a properly-
coded key, the indicator will blink
and the engine will not start (see
page ).
This indicator also blinks several
times when you turn the ignition
switch f rom ON (II) to ACCESSORY
(I) or LOCK (0).
This light comes on when the
washer f luid level is low. Add washer
f luid when you see this light come on
(see page ).
This indicator lights when you turn
the ignition switch to ON (II) with
the headlight switch of f and the
parking brake set. It should go of f if
youturnontheheadlightsorrelease
the parking brake. If it comes on at
any other time, it means there is a
problem with the DRL. There may
also be a problem with the high
beam headlights.
This light comes on with the high
beam headlights. See page for
inf ormation on the headlight
controls.
On Canadian models, this indicator
comes on with reduced brightness
when the Daytime Running Lights
(DRL) are on (see page ). This indicator comes on when you
turn on the Cruise Control System
by pressing the Master Button. (see
page .)
This lights when you set the cruise
control. See page f or inf ormation
on operating the cruise control.
70
72 174
174 79
255
Canadian models only
Canadian models only
Immobilizer System
Indicator
Washer Level Indicator
‘‘Daytime Running
Lights’’ Indicator
High Beam Indicator
Cruise Main Indicator
Cruise Control Indicator
Indicator L ights
Inst rument s and Cont rols64

µ
This shows how much f uel you have.
It is most accurate when the car is on
level ground. It may show slightly
more or less than the actual amount
whenyouaredrivingoncurvyor
hilly roads.
This indicator reminds you that it is
time to take your car in for
scheduled maintenance per the
Normal Conditions maintenance
schedule. The indicator light does
not ref lect severe maintenance
intervals.Ref er to the Maintenance Schedules
f or Normal and Severe Driving
Conditions on pages
.
For the f irst 8,000 miles (12,800 km)
after the Maintenance Required
Indicator is reset, it will come on f or
two seconds when you turn the
ignition switch to ON (II).
The needle returns to the bottom
after you turn off the ignition. The
gauge shows the f uel level reading
immediately af ter you turn the
ignition switch to ON (II). 234 238
CONT INUED
Gauges
Inst rument s and Cont rols
Maintenance Required Indicator
Fuel Gauge
67
MAINTENANCE REQUIRED
INDICATOR
Avoid driving with an extremely low
f uel level. Running out of f uel could
cause the engine to misf ire, damaging
the catalytic converter.

Between 8,000 miles (12,800 km)
and 10,000 miles (16,000 km), this
indicator will light f or two seconds
when you first turn the ignition
switch to ON (II), and then flash for
ten seconds.
If you exceed 10,000 miles (16,000
km) without having the scheduled
maintenance perf ormed, this
indicator will remain on as a constant
reminder.Your dealer will reset this indicator
af ter completing the scheduled
maintenance. If this maintenance is
done by someone other than your
Acura dealer, reset the indicator as
f ollows.
Turn of f the engine.
Press and hold the Select/Reset
knob in the instrument panel, then
turn the ignition switch to ON (II).
Hold the knob f or about ten sec-
onds until the indicator resets.
1.
2.
3.
Gauges
Inst rument s and Cont rols68
SELECT/RESET KNOB

Î
Î
The steering wheel adjustment lever
on the underside of the steering
column allows you to tilt and
telescope the steering wheel. The controls under the lef t air vent
are f or the moonroof and the VSA
System.To use the horn, press the pad
around the ‘‘A’’ logo.
Thetwoleversonthesteering
column contain controls f or the
driving f eatures you use most of ten.
The lef t lever controls the turn
signals, headlights, and high beams.
The right lever controls the
windshield washers and wipers.
Inst rument s and Cont rols
Controls Near the Steering Wheel
69
TILT/TELESCOPIC
ADJUSTMENT
HORN
REMOTE AUDIO
CONTROLS
CRUISE
CONTROLS
WINDSHIELD
WIPERS/WASHERS
HAZARD
WARNING
LIGHTS
REAR WINDOW
DEFOGGER
MOONROOF
SWITCH HEADLIGHTS/
TURN SIGNALS
(P.
70/ 73)
(P. 171)
(P. 101)
VEHICLE STABILITY
ASSIST SYSTEM
OFF SWITCH
(P.217) (P.
76) (P.
75, 76)
(P.
75)
(P.
73, 75)
(P. 174)

To change f rom low beams to high
beams, push the turn signal lever
f orward until you hear a click. The
blue high beam indicator will light
(see page ). To return to low
beams, pull the turn signal lever
back.
The rotating switch on the lef t lever
controls the lights. Turning this
switch to the ‘‘ ’’ position turns
on the parking lights, taillights, and
rear license plate light. Turning the
switch to the ‘‘ ’’ position turns
on the headlights. When the light switch is in either of
these positions, the Lights On
indicator comes on as a reminder.
If you leave the lights on with the
key removed f rom the ignition
switch, you will hear a reminder
chime when you open the driver’s
door.
64
Controls Near the Steering Wheel
Inst rument s and Cont rols
Headlights
70

The Automatic Lighting Of f f eature
turns of f the headlights, parking
lights, taillights, and license plate
light within 15 seconds of removing
the key from the ignition switch and
closing the driver’s door.The lights will turn on again when
you unlock or open the driver’s door.
If you unlock the door, but do not
open it within 15 seconds, the lights
will go of f . With the driver’s door
open, you will hear a lights-on
reminder chime.
The high beams will stay on f or as
long as you hold the lever back, no
matter what position the headlight
switch is in. To f lash the high beams, pull the
turn signal lever back lightly, then
release it. The high beams will come
on and go off. This feature activates if you leave
the headlight switch in the ‘‘ ’’
or ‘‘ ’’ position, remove the key,
then open and close the driver’s door.
If you remove the key f rom the
ignition switch with the headlight
switch on, but do not open the door
and get out, the lights will turn of f
af ter ten minutes.
Controls Near the Steering Wheel
Inst rument s and Cont rols
Automatic Lighting Of f Feature
71