2004 Acura TL ignition

This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to ON (II).
If itcomesonandstaysonatany
other time, or it does not come on
when you turn the ignition switch to
ON (II), there is a problem with the
VSA system. Take your vehicle to a
dealer to have it checked. Without
VSA, your vehicle still has normal
driving ability, but will not have VSA
traction and stability enhancement.
See page f or more inf ormation
on the VSA system.This indicator has three f unctions.
Itcomesonasareminderthatyou
have turned of f the Vehicle
Stability Assist (VSA) system.
It flashes when VSA is active (see
page ).
It comes on along with the VSA
system indicator if there is a
problem with the VSA system.
This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to ON (II). See page f or more inf ormation on the
VSA system. This indicator comes on when you
turn on the Cruise Control System
by pressing the Master Button (see
page ).
This indicator comes on when you
set the cruise control. See page
f or inf ormation on operating the
cruise control.
1.
2.
3.
142
142
190 190
190
Vehicle Stability Assist
(VSA ) System Indicator
VSA A ctivation Indicator
Cruise Main Indicator
Cruise Control Indicator
Instrument Panel Indicators
Inst rument s and Cont rols54

The lef t or right turn signal light
blinks when you signal a lane change
or turn. If the indicators do not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is
burned out (see page ). Replace
the bulb as soon as possible, since
other drivers cannot see that you are
signaling.
When you press the Hazard Warning
button, both turn signals blink. All
turn signals on the outside of the
vehicle should f lash.This indicator reminds you that the
exterior lights are on. It comes on
when the light switch is in either the
or position. If you turn the
ignition switch to ACCESSORY (I)
or LOCK (0) without turning of f the
light switch, this indicator will
remain on. A reminder chime will
also sound when you open the driver’s
door.
This indicator comes on when you
turn the ignition switch to ON (II)
with the headlight switch off and the
parking brake set. It should go of f if
youturnontheheadlightsorrelease
the parking brake. If it comes on at
any other time, it means there is a
problem with the DRL.
This indicator comes on with the
high beam headlights. See page
f or inf ormation on the headlight
controls.
214
74
Canadian models only
Instrument Panel Indicators
Inst rument s and Cont rols
Turn Signal and
Hazard Warning
Indicators ‘‘Daytime Running
Lights’’ Indicator
Lights On Indicator
High Beam Indicator
55

This indicator also blinks several
times when you turn the ignition
switch f rom ON (II) to ACCESSORY
(I) or LOCK (0). This indicator comes on f or a f ew
seconds when you turn the ignition
switch to ON (II). It then will go of f
if you have inserted a properly-coded
ignition key. If it is not a properly-
coded key, the indicator will blink
and the engine will not start (see
page ).This indicator is in the f uel gauge. It
comesonasareminderthatyou
must ref uel soon.This indicator comes on when you
turn on the fog lights. See page
f or inf ormation on f og light
operation.
81 75
U.S. models only
Immobilizer System
Indicator
L ow Fuel Indicator
Fog L ight Indicator
Instrument Panel Indicators
Inst rument s and Cont rols56
LOW FUEL INDICATOR

This shows the temperature of the
engine’s coolant. During normal
operation, the pointer should rise to
about the middle of the gauge. In
severe driving conditions, the pointer
may rise to the upper zone. If it
reaches the red (Hot) mark, pull
safely to the side of the road. Turn to
page f or instructions and
precautions on checking the engine’s
cooling system.
This shows how much f uel you have.
It may show slightly more or less
than the actual amount. The needle
returns to the bottom after you turn
of f the ignition.240
Gauges
Inst rument s and Cont rols
Temperature Gauge
Fuel Gauge
57
FUEL GAUGE
TEMPERATURE GAUGE
SPEEDOMETER
TACHOMETER
Avoid driving with an extremely low
f uel level. Running out of f uel could
cause the engine to misf ire, damaging
the catalytic converter.

¼»
With the ignition switch in the ON
(II) position, the basic display
changes, as shown in the illustration,
each time you press the side of
the INFO button. If you press the
side of the INFO button, the display
returns to the previous message.
On Canadian models, the language in
the multi inf ormation display can be
set to English or French. To change
the language see page .
71
Multi-Inf ormation Display
Inst rument s and Cont rols59
(CANADIAN MODELS ONLY)

If you start driving without releasing
the parking brake, the multi-
inf ormation display interrupts the
current display and shows
‘‘RELEASE PARKING BRAKE!’’.
This message continues, and a
chime sounds, until you release the
parking brake or the vehicle speed
slows down to less than 0.5 mph (0.8
km/h).If the f uel f ill cap is missing or not
tightened properly, you will see
‘‘CHECK FUEL CAP’’. Make sure
the f uel cap is installed and tightened
properly to at least 3 clicks.The CHECK FUEL CAP message
should go of f af ter tightening the
f uel cap, turning the ignition switch
of f and on, then driving over 30 mph
f or at least 45 seconds. Due to
dif f erent driving conditions, it may
take a few drive trips to make the
message go of f .
If a loose or missing f uel cap was not
the cause of the CHECK FUEL CAP
message coming on, the message
will turn off and the Malfunction
Indicator Lamp will come on. If this
happens, have your vehicle checked
by an Acura dealer as soon as
possible.
Multi-Inf ormation Display
Inst rument s and Cont rols
Release Parking Brake
Check Fuel Cap
61

The odometer shows the total dis-
tance your vehicle has been driven.
It measures miles in U.S. models and
kilometers in Canadian models.
It is illegal under U.S. f ederal law and
Canadian provincial regulations to
disconnect, reset, or alter the
odometer with the intent to change
the number of miles or kilometers
indicated.This meter show the number of
miles (U.S.) or kilometers (Canada)
driven since you last reset it. There
are two trip meters: Trip A and Trip
B. When you first turn the ignition
switch to ON (II), Trip A is displayed.
Switch between Trip A and Trip B by
pressing the Select/Reset button
repeatedly. Each trip meter works
independently, so you can keep track
of two dif f erent distances.
If the f luid level in the windshield
washer reservoir gets low, the multi-
inf ormation display shows the above
message.
On Canadian models
Multi-Inf ormation Display
L ow Windshield Washer Fluid
Level
Odometer
T rip Meter
Inst rument s and Cont rols62
ODOMETER
TRIP METER

This shows the remaining lif e of the
engine oil. It shows 100% af ter the
engine oil is replaced and the display
is reset. The engine oil lif e is
calculated based on engine operating
conditions and accumulated engine
revolutions.When the engine oil lif e reaches 15
percent, the display shows
‘‘SERVICE DUE SOON’’ and the
code f or the maintenance items to be
perf ormed.
When the engine oil lif e reaches 5
percent, the display shows
‘‘SERVICE DUE NOW’’ along with
the same maintenance items.Have your dealer do the indicated
maintenance as soon as you see this
message, and have them reset the
display af ter completing the service.
If you do not perf orm the indicated
maintenance or do not reset the
display, the message changes to
‘‘SERVICE PAST DUE’’ when the
engine oil lif e becomes 0 percent.
These messages appear on the multi-
inf ormation display each time you
turn the ignition switch to ON (II).
For details on engine oil lif e and
maintenance messages, ref er to page
.
Also ref er to page f or important
maintenance saf ety precautions. 195
194
Multi-Inf ormation Display
Inst rument s and Cont rols
Engine Oil L if e Maintenance Messages
64