2004 Acura RL CD changer

Indication
If you see an error indication in the
display while operating the CD
changer, f ind the cause in the chart
to the right. If you cannot clear the
error indication, take the vehicle to
your Acura dealer. Solution
Cause
Press the CD eject button and pull out the CDs,
check f or error indication. Insert the CD again.
If the code does not disappear or the CD cannot
be pulled out, consult your Acura dealer.
Will disappear when the temperature returns to
normal.
Mechanical Error.
High temperature.
CD Changer Error Indications
Audio System
Comf ort and Convenience Feat ures150

Î
Î
Your Acura’s audio system provides
clear reception on both AM and FM
bands, while the preset buttons allow
you to easily select your f avorite
stations.
The cassette system f eatures Dolby
noise reduction, automatic sensing of
chromium-dioxide (CrO ) tape, and
auto-reverse f or continuous play.
The in-dash CD changer holds up to
six discs. You operate the CD
changer with the same controls used
f or the radio. See page f or CD
changer operation.The anti-thef t f eature will disable the
system if it is disconnected f rom the
vehicle’s battery. To get the system
working again, you must enter a
code number (see page ).
164
180
2
Dolby noise reduction manuf actured under
license from Dolby Laboratories Licensing Corpo-
ration. ‘‘DOLBY’’ and the double-D symbol are trademarks of Dolby Laboratories
Licensing Corporation.
Audio System
Comf ort and Convenience Feat ures
A M/FM/Cassette/CD Changer/
Satellite Digital Radio Audio
SystemU.S. 3.5 RL wit h Navigat ion Syst em
151

Û
The ignition switch must be in
ACCESSORY (I) or ON (II).
Make sure the tape opening on the
cassette is facing to the right, then
insert the cassette most of the way
into the slot. The system will pull it
in the rest of the way, and begin to
play.
The tape direction indicator will light
to show you which side of the
cassette is playing. The indicates
thesideyouinsertedfacingupward
is now playing. If you want to play
the other side, press the PROG
button. If you turn the system of f while a
tape is playing, either with the PWR/
VOL knob or by turning of f the
ignition, the cassette will remain in
the drive. When you turn the system
back on, the tape will begin playing
where it lef t of f .
Dolby noise reduction turns on when
you insert a cassette. The indi-
cator will light in the display. If the
tape was not recorded with Dolby
noise reduction, turn it of f by
pressing the button.
Noise reduction remains of f until you
turn it on by pressing the button
again.
You can remove the cassette with
the ignition switch in any position,
even if the audio system is turned of f . When the system reaches the end of
the tape, it will automatically reverse
direction and play the other side. If
you want to remove the cassette
f rom the drive, press the TAPE
EJECT button. To switch to the radio or CD
changer while listening to a tape,
press the AM/FM or CD/TAPE but-
ton. To change back to the cassette
player, press the CD/TAPE button.
Operating the Cassette Player
Audio System
Comf ort and Convenience Feat ures159

Your Acura’s audio system has an in-
dash CD changer that holds up to six
discs, providing several hours of
continuous entertainment. You
operate this CD changer with the
same controls used f or the radio and
cassette player.
To load CDs or operate the CD
changer, the ignition switch must be
in ACCESSORY (I) or ON (II).
Load and play only standard round
discs. Odd-shaped CDs may jam in
the drive or cause other problems.
Avoid using CDs that have adhesive-
type labels. The edges can curl up
and cause the CD to jam in the drive.
You cannot load and play 3-inch
(8-cm)discsinthissystem. Operating the CD Changer
Audio System
Comf ort and Convenience Feat ures164
CD SLOT
PWR/VOL
KNOB RDM BUTTONRPT BUTTON CD/TAPE BUTTON
SKIP BUTTONS
LOAD
BUTTON
CD EJECT
BUTTON DISC
INDICATOR

To load a single CD:Press and release the LOAD
button.
The CD Loaded indicator f or an
empty position will start to blink
the green disc indicator will come
on, and LOAD will appear in the
display. Insert the disc into the CD
slot about halfway, the drive will
pull it in the rest of the way.
The system will load the CD, and
begin playing it.
When LOAD appears again in the
display, insert the next disc into
the CD slot. Do no try to insert a
disc until LOAD appears. You
could damage the audio unit.
Repeat this until all six positions
are loaded. The system will then
begin playing the last CD loaded.
If you are not loading CDs into all six
positions, press the LOAD button
again after the last CD has loaded.
The system will begin playing the
last CD loaded.
If you stop loading CDs bef ore all six
positions are f illed, and you do not
press the LOAD button, the system
will wait f or ten seconds, then stop
the load operation and begin playing
the last CD loaded.
Insert the disc into the CD slot
about half way, the drive will pull it
in the rest of the way. The disc
indicator turns red and blinks as
the CD is loaded. On the right side of the display,
the CD Loaded indicator f or an
empty position will begin blinking
and the green disc indicator will
come on. Press and hold the LOAD button
until you hear a beep and see
‘‘LOAD’’ in the display, then
release the button.
To load multiple CDs in one
operation: For best results use only high quality
CD-R discs labeled f or audio use.
TheCDplayercanonlyplayclosed
CD-R recordings. CD-RW discs will
not work in this unit.
1.
2.
3. 4.
5.
1.
2.
3.
CONT INUED
Audio System
Comf ort and Convenience Feat ures
L oading CDs in t he Changer
165

µµ
µ
Ó
Ó
ÓÓ
´
µ
´µ
When that disc ends, the next disc in
the CD changer is loaded and played.
Af ter the last disc f inishes, the
system returns to disc 1.
To select a dif f erent disc, press the
appropriate Preset button (1 6). If
youselectanemptypositioninthe
CD changer, the system will go into
the loading sequence (see page ).
You can use the SKIP buttons while
a disc is playing to select passages
and change tracks. To activate the Repeat
f eature, press and release the RPT
button. You will see RPT in the
display as a reminder. The system
continuously replays the current
track. Press the RPT button again to
turn it off. Pressing either of the
SKIP buttons also turns off the
repeat feature.
This feature,
when activated, plays the tracks
within a CD in random order, rather
than in the order they are recorded
on the CD. To activate Random Play,
press the RDM button. You will see
RDM in the display. The system will
then select and play tracks randomly.
This continues until you deactivate
RandomPlaybypressingtheRDM
button again, or you select a
dif f erent CD with a preset button.
To move rapidly within a track, press
and hold the appropriate SKIP
button. You will hear a beep and the
system will continue to move. Press
the button to move forward, or
the button to move backward.
Release the button when the system
reaches the point you want.
Each time you press the button
and release it, the system skips
f orward to the beginning of the next
track. Press and release the
buttontoskipbackwardtothe
beginning of the current track. Press
and release it again to skip to the
beginning of the previous track.
Select the CD changer by pressing
the CD/TAPE button. You will see
‘‘CD’’ in the display. The system will
begin playing the last selected disc in
theCDchanger.Youwillseethe
disc and track numbers displayed.
165
CONT INUED
Operat ionREPEAT
RANDOM PLAY
Audio System
Comf ort and Convenience Feat ures167

If you do not remove the disc f rom
the slot, the system will reload the
disc af ter ten seconds and begin
playing it. To remove the disc that is currently
playing, press the CD eject button.
You will see ‘‘EJCT’’ in the display.
When you remove the disc f rom the
slot, the system automatically begins
the Load sequence so you can load
another CD in that position. If you do
not load another CD, af ter ten
seconds the system begins playing
the next disc in the changer. If the
changer is empty, the system selects
the previous mode (AM, FM, or
Tape).
To remove a different CD from the
changer,firstselectitwiththe
appropriate preset button. When that
CD begins playing, press the CD
eject button.
CONT INUED
Removing CDs f rom t he Changer
Audio System
Comf ort and Convenience Feat ures169
CD EJECT BUTTON CD SLOTCD/TAPE BUTTON

If you press the CD eject button
while listening to the radio or tape,
or with the audio system turned of f ,
the disc that was last selected is
ejected. Af ter that disc is ejected,
pressing the CD eject button again
will eject the next disc in the
numerical order. By doing this six
times, you can remove all the CDs
f rom the changer.
In any mode, if you press the CD
eject button and hold it until you
hear a beep, the system will eject all
of the discs in the changer.
You can also eject discs when the
ignition switch is of f . The disc that
was last selected is ejected f irst. You
can eject up to six discs, one at a
time.
Audio System
Comf ort and Convenience Feat ures170