2003 YAMAHA YZF-R6 lock

PERIODIC MAINTENANCE AND MINOR REPAIR
6-40
6
EAU04981
Replacing the fuses The main fuse and fuse box 1 are locat-
ed under the rider seat. (See page 3-19
for rider seat removal and installation
procedures.)Fuse box 2 is located under panel B.
(See page 6-7 for panel removal and
installation procedures.)If a fuse is blown, replace it as follows.
1. Turn the key to “OFF” and turn off
the electrical circuit in question.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage.1. Spare main fuse
2. Main fuse
3. Fuse box 1
4. Electronic fuel injection fuse
5. Turn signal light, taillight, license plate light,
auxiliary light and hazard fuse
6. Spare fuse
1. Fuse box 2
2. Headlight fuse
3. Radiator fan fuse
4. Ignition fuse
5. Signaling system fuse
6. Odometer, clock and immobilizer system fuse
(backup fuse)
7. Spare fuse (× 2)
Specified fuses:
Main fuse: 40 A
Fuse box 1:
Electronic fuel injection
fuse: 15 A
Turn signal light,
taillight, license plate
light, auxiliary light and
hazard fuse: 10 A
Fuse box 2:
Headlight fuse: 20 A
Signaling system fuse: 15 A
Radiator fan fuse: 15 A
Ignition fuse: 15 A
Odometer, clock and
immobilizer system fuse
(backup fuse): 10 A
U5SLE0.book Page 40 Wednesday, September 11, 2002 11:46 AM

PERIODIC MAINTENANCE AND MINOR REPAIR
6-41
6
EC000103
CAUTION:_ Do not use a fuse of a higher amper-
age rating than recommended to
avoid causing extensive damage to
the electrical system and possibly a
fire. _3. Turn the key to “ON” and turn on
the electrical circuit in question to
check if the device operates.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
EAU04954
Replacing a headlight bulb This motorcycle is equipped with
quartz bulb headlights. If a headlight
bulb burns out, replace it as follows.
1. Remove panel B (if replacing the
left headlight bulb) or panel A (if
replacing the right headlight bulb).
(See page 6-7 for panel removal
and installation procedures.)
2. Remove the headlight bulb cover
by turning it counterclockwise.3. Disconnect the headlight coupler.1. Headlight bulb cover
1. Headlight coupler
U5SLE0.book Page 41 Wednesday, September 11, 2002 11:46 AM

PERIODIC MAINTENANCE AND MINOR REPAIR
6-43
66. Connect the headlight coupler.
7. Install the headlight bulb cover by
turning it clockwise.
8. Install the panel.
9. Have a Yamaha dealer adjust the
headlight beam if necessary.
EAU04982
Replacing an auxiliary light
bulb This motorcycle is equipped with two
auxiliary lights. If an auxiliary light bulb
burns out, replace it as follows.
1. Remove the auxiliary light bulb
cover by removing the quick fas-
tener.NOTE:_ Remove the quick fastener by pushing
the center pin in with a screwdriver,
then pulling the fastener out. _
2. Remove the socket (together with
the bulb) by pulling it out.
3. Remove the defective bulb by pull-
ing it out.
4. Insert a new bulb into the socket.
5. Install the socket (together with
the bulb) by pushing it in.
6. Install the auxiliary light bulb cover
by installing the quick fastener.
1. Auxiliary light bulb cover
2. Quick fastener
1. Auxiliary light bulb
2. Auxiliary light bulb socket
U5SLE0.book Page 43 Wednesday, September 11, 2002 11:46 AM

PERIODIC MAINTENANCE AND MINOR REPAIR
6-44
6
NOTE:_ To install the quick fastener, push the
center pin out so that it will protrude
from the fastener head, insert the fas-
tener into the auxiliary light bulb cover,
and then push the protruding pin in until
it is flush with the fastener head. _
EAU03730
Tail/brake light This motorcycle is equipped with an
LED type of tail/brake light.
If the tail/brake light does not come on,
have a Yamaha dealer check it.
EAU03497
Replacing a turn signal light
bulb 1. Remove the turn signal light lens
by removing the screw.
2. Remove the defective bulb by
pushing it in and turning it
counterclockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screw.
ECA00065
CAUTION:@ Do not overtighten the screw, other-
wise the lens may break. @
1. Quick fastener
2. Pin
After removal
Before installation
1. Screw
U5SLE0.book Page 44 Wednesday, September 11, 2002 11:46 AM

PERIODIC MAINTENANCE AND MINOR REPAIR
6-49
6
EAU04947
Rear wheel To remove the rear wheel
EW000122
WARNING
_

It is advisable to have a Yamaha
dealer service the wheel.


Securely support the motor-
cycle so that there is no danger
of it falling over.
_1. Loosen the axle nut.2. Lift the rear wheel off the ground
according to the procedure on
page 6-46.
3. Remove the axle nut.
4. Loosen the locknut on each side of
the swingarm.
5. Turn the drive chain slack adjust-
ing bolts fully in direction
a.
6. Push the wheel forward, and then
remove the drive chain from the
rear sprocket.
NOTE:_ The drive chain does not need to be
disassembled in order to remove and
install the rear wheel. _
1. Axle nut
2. Drive chain slack adjusting bolt
3. Locknut
4. Brake caliper
5. Brake caliper bracketU5SLE0.book Page 49 Wednesday, September 11, 2002 11:46 AM

PERIODIC MAINTENANCE AND MINOR REPAIR
6-53
6Engine overheating
EW000070
WARNING
@

Do not remove the radiator cap when the engine and radiator are hot. Scalding hot fluid and steam may be
blown out under pressure, which could cause serious injury. Be sure to wait until the engine has cooled.


After removing the radiator cap retaining bolt, place a thick rag, like a towel, over the radiator cap, and then
slowly rotate the cap counterclockwise to the detent to allow any residual pressure to escape. When the hiss-
ing sound has stopped, press down on the cap while turning it counterclockwise, and then remove the cap.
@aNOTE:@ If coolant is not available, tap water can be temporarily used instead, provided that it is changed to the recommended coolant
as soon as possible. @
Wait until the
engine has cooled.
Check the coolant level in the
reservoir and radiator.
The coolant level
is OK.The coolant level is low.
Check the cooling system
for leakage.
Have a Yamaha dealer checkand repair the cooling system.Add coolant. (See NOTE.)
Start the engine. If the engine overheats again,
have a
Yamaha dealer check
and repair the cooling system.
There is
leakage.
There is
no leakage.
U5SLE0.book Page 53 Wednesday, September 11, 2002 11:46 AM

SPECIFICATIONS
8-4
8
Battery
Model GT9B-4
Voltage, capacity 12 V, 8 Ah
Headlight typeHalogen bulb
Bulb voltage, wattage × quantity
Headlight 12 V, 55 W × 2
Tail/brake light LED
Turn signal light 12 V, 10 W × 4
Auxiliary light 12 V, 5 W × 2
License plate light 12 V, 5 W × 1
Meter lighting LED
Neutral indicator light LED
High beam indicator light LED
Turn signal indicator light LED
Fuel level warning light LED
Oil level warning light LED
Coolant temperature warning
light LED
Engine trouble warning light LED
Shift timing indicator light LED
Immobilizer system
indicator light LEDFuses
Main fuse 40 A
Headlight fuse 20 A
Signaling system fuse 15 A
Radiator fan fuse 15 A
Ignition fuse 15 A
Electronic fuel injection fuse 15 A
Turn signal light, taillight,
license plate light, auxiliary
light and hazard fuse 10 A
Odometer, clock and
immobilizer system fuse
(backup fuse) 10 A
U5SLE0.book Page 4 Wednesday, September 11, 2002 11:46 AM

10-INDEXAAir filter element, checking ..................... 6-19
Air intake duct ........................................ 6-22
Anti-theft alarm ...................................... 3-13
Auxiliary light bulb, replacing .................. 6-43BBattery ................................................... 6-38
Brake and clutch levers, checking and
lubricating ............................................ 6-35
Brake and shift pedals, checking and
lubricating ............................................ 6-35
Brake fluid, changing ............................. 6-32
Brake fluid level, checking...................... 6-31
Brake lever............................................. 3-16
Brake light switch (rear), adjusting ......... 6-29
Brake pads, checking............................. 6-30
Brake pedal............................................ 3-16
Brake pedal position, adjusting .............. 6-29CCables, checking and lubricating............ 6-34
Care.........................................................7-1
Catalytic converter ................................. 3-19
Clutch lever ............................................ 3-15
Clutch lever free play, adjusting ............. 6-27
Conversion table ......................................8-5
Coolant .................................................. 6-13
Changing .......................................... 6-15
Checking .......................................... 6-13
Coolant temperature warning light............3-6
Cowlings and panels, removing and
installing ................................................6-5
DDimmer switch ....................................... 3-13
Drive chain, lubricating .......................... 6-33
Drive chain slack ................................... 6-32
Adjusting .......................................... 6-33
Checking .......................................... 6-32EEngine break-in ....................................... 5-3
Engine idling speed ............................... 6-23
Engine oil and oil filter cartridge ............... 6-9
Engine stop switch................................. 3-14
Engine trouble warning light .................... 3-5FFront fork, adjusting ............................... 3-23
Front fork, checking ............................... 6-37
Fuel ....................................................... 3-17
Fuel consumption, tips for reducing ......... 5-3
Fuel level warning light ............................ 3-4
Fuel tank breather hose ......................... 3-18
Fuel tank cap ......................................... 3-17
Fuses, replacing .................................... 6-40HHandlebar switches ............................... 3-13
Hazard switch ........................................ 3-14
Headlight bulb, replacing ....................... 6-41
Helmet holders ...................................... 3-21
High beam indicator light ......................... 3-5
Horn switch ........................................... 3-14
IIdentification numbers ..............................9-1
Ignition circuit cut-off system ..................3-28
Immobilizer system..................................3-1
Immobilizer system indicator light.............3-6
Indicator and warning lights......................3-4KKey identification number .........................9-1LLicense plate light bulb, replacing...........6-45
Luggage strap holders ...........................3-27MMain switch/steering lock .........................3-2
Model label ..............................................9-2
Multi-function display................................3-8NNeutral indicator light ...............................3-5OOil level warning light ...............................3-5PParking.....................................................5-4
Part locations ...........................................2-1
Pass switch ............................................3-13
Periodic maintenance and
lubrication chart .....................................6-2
Pre-operation check list ............................4-1
U5SLE0.book Page 1 Wednesday, September 11, 2002 11:46 AM