5-2
OPERATION AND IMPORTANT RIDING POINTS
5
EAU00433
Starting off
Starting off
NOTE:
Before starting off, allow the engine
to warm up.
1. While pulling the rear brake lever
with your left hand and holding
the grab bar with your right hand,
push the scooter off the center-
stand.
2. Sit astride the seat, and then
adjust the rear view mirrors.
3. Switch the turn signal on.4. Check for oncoming traffic, and
then slowly turn the throttle grip
(on the right) in order to take off.
5. Switch the turn signal off.
EAU00434
Acceleration and
deceleration
Acceleration and deceleration
The speed can be adjusted by open-
ing and closing the throttle. To
increase the speed, turn the throttle
grip in direction a. To reduce the
speed, turn the throttle grip in direc-
tion b.
1
1. Grab bar
ab
5GJ-28199-E2 9/9/02 9:15 AM Page 39
6-8
PERIODIC MAINTENANCE AND MINOR REPAIR
6 Cowling A
To remove the cowling
1. Remove the rear view mirrors by
removing the nuts.
2. Remove the cowling screws.
To install the cowling
1. Place the cowling in the original
position, and then install the
screws.
2. Install the rear view mirrors by
installing the nuts.
21
2
1. Screw (×2)
2. Nut (×4)
Cowling B
To remove the cowling
1. Remove panels C and E.
2. Remove the cowling screws and
bolts.
3. Unhook the cowling from the
holder at the bottom.
4. Unhook the front of the cowling
by pushing it up, and then pull
the cowling out.
1
2
1. Bolt (×2)
2. Screw (×2)
Panel F
To remove the panel
Remove the panel screws.
To install the panel
1. Place the panel in the original
position, and then install the
screws.
1
1. Screw (×2)
5GJ-28199-E2 9/9/02 9:15 AM Page 51
