2003 SUBARU IMPREZA battery

Seat, seatbelt and SRS airbags
1-7
– CONTINUED –
1)HI – Rapid heating
2) LO – Normal heating
The indicator located on the switch comes on when the seat heater is in operation. When the vehicle ’s in-
terior is warmed enough or before you leave the ve-
hicle, be sure to turn the switch off.
CAUTION
There is a possibility that people with deli-
cate skin may suffer slight burns even at low
temperatures if he/she uses the seat heater for a long period of time. When using the
heater, always be sure to warn the persons concerned.
Do not put anything on the seat which insu-
lates against heat, such as a blanket, cushion,or similar items. This may cause the seat heat-er to overheat.
NOTE Use of the seat heater for a long period of time
while the engine is not running can cause battery discharge. When cleaning the seat, do not use benzine,
paint thinner, or any similar materials.

Seat, seatbelt and SRS airbags
1-27
– CONTINUED –
Seatbelt maintenance
To clean the seatbelts, use a mild soap and luke-
warm water. Never bleach or dye the belts because
this could seriously affect their strength. Inspect the seatbelts and attachments including the
webbing and all hardware periodically for cracks,
cuts, gashes, tears, damage, loose bolts or worn
areas. Replace the seatbelts even if only minor dam- age is found.
CAUTION
Keep the belts free of polishes, oils, chemi-
cals and particularly battery acid. Never attempt to make modifications or
changes that will prevent the seatbelt from op-
erating properly. Front seatbelt pretensioners
The driver
’s and front passenger ’s seatbelts have a
seatbelt pretensioner. The seatbelt pretensioners are designed to be activated in the event of an accident
involving a moderate to severe frontal collision.
The pretensioner sensor also serves as the frontal
SRS airbag sensor. If the sensor detects a certain
predetermined amount of force during a frontal colli-
sion, the front seatbelt is quickly drawn back in by
the retractor to take up the slack so that the belt
more effectively restrains the front seat occupant.
When a seatbelt pretensioner is activated, an oper-

2
2-1
– CONTINUED –
Keys 2-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Key number 2-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Door locks 2-3
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Locking and unlocking from the outside 2-3 . . . . . .
Locking and unlocking from the inside 2-4 . . . . . . .
Power door locking switches
(if equipped) 2-5 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Remote keyless entry system (if equipped) 2-6 Locking the doors 2-7 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Unlocking the doors 2-7 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Illuminated entry 2-8 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Sounding a panic alarm 2-8 . . . . . . . . . . . . . . . . . . . . . . . . . .
Selecting audible signal operation 2-8 . . . . . . . . . . . . .
Replacing the battery 2-8 . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Replacing lost transmitters 2-10 . . . . . . . . . . . . . . . . . . . . . .
Security system (if equipped) 2-14 . . . . . . . . . . . . . . . . . .
System operation 2-14 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Arming the system 2-15 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Disarming the system 2-16 . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Sounding a panic alarm 2-17 . . . . . . . . . . . . . . . . . . . . . . . . . .
Valet mode 2-17
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Passive arming 2-17 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Child safety locks 2-21 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Windows 2-22
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Power windows 2-22 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Trunk lid (Sedan) 2-25 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
To open and close the trunk lid from outside 2-26
To open the trunk lid from inside 2-26 . . . . . . . . . . . . . . . To cancel the trunk lid release 2-27
. . . . . . . . . . . . . . . . . .
Internal trunk lid release handle 2-27 . . . . . . . . . . . . . . . .
Rear gate (Wagon) 2-30 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Keys and doors

Keys and doors
2-6
Remote keyless entry system (if equipped)
Two transmitters are provided for your vehicle.
The remote keyless entry system has the following functions.Locking and unlocking the doors (and rear gate
on the wagon) without a key Sounding a panic alarm
Arming and disarming the security system (if your
vehicle is equipped with an optional security sys-tem). See the next section “Security system (if
equipped)” for detailed information.
This device complies with Part 15 of the FCC
Rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not causeharmful interference, and (2) this device must
accept any interference received, includinginterference that may cause undesired opera-tion.
Changes or modifications not expressly approved by the party responsible for com-
pliance could void the user ’s authority to
operate the equipment. The operable distance of the keyless entry system is
approximately 30 feet (10 meters). However, this
distance will vary depending on environmental
conditions. Range may be reduced near sources of
RF interference such as power plants and radio/tele-
vision broadcasting towers.
The remote keyless entry system does not operate
when the key is inserted in the ignition switch to pre-vent accidental lockout.
CAUTION

Do not expose the transmitter to severe
shocks, such as those experienced as a result of dropping or throwing. Do not take the transmitter apart except
when replacing the battery. Do not get the transmitter wet. If it gets wet,
wipe it dry with a cloth immediately.

Keys and doors
2-8
Illuminated entry
The interior (dome) light and ignition switch light (for turbo models) will illuminate when the “UNLOCK/
DISARM” button is pressed. These lights stay illumi-
nated for approximately 30 seconds if any of the
doors (or the rear gate on the wagon) is not opened. If the “LOCK/ARM” button is pressed before 30 se-
conds have elapsed, these lights will go out. Also,
these lights will go out if the key is inserted in the
ignition switch. The interior light must be set to the
middle position in order for this function to operate.
Sounding a panic alarm
To activate the alarm, keep the “LOCK/ARM” button
pressed for more than two seconds .
To deactivate it, press the “LOCK/ARM” button or
“UNLOCK/DISARM” button. Unless a button on the
remote is pressed, the alarm will be deactivated
after approximately 30 seconds.
Selecting audible signal operation
Using the horn, the system will give you an audible
signal when the doors lock and unlock. If desired,
you may turn the audible signal off.
To turn the audible signal off, unlock the door by
pressing the “UNLOCK/DISARM” button and then
simultaneously depress “LOCK/ARM” and
“UNLOCK/DISARM” buttons for more than two se-
conds. The horn will sound two times to inform you
that the audible signal has been turned off.
To turn the audible signal on, unlock the door by
pressing the “UNLOCK/DISARM” button and then
simultaneously depress “LOCK/ARM” and
“UNLOCK/DISARM” buttons for more than two se-
conds. The horn will sound one time to inform you
that the audible signal has been turned on.
Replacing the battery
When the transmitter battery begins to get weak,
transmitter range will begin to decrease and the
LED will not illuminate. Replace the battery as soonas possible.

Keys and doors
2-9
– CONTINUED –
To replace the battery:
1. Remove the two screws on the back of the trans-
mitter case by using a phillips screwdriver.
2. Separate the case.
3. Remove the old battery from the holder.
1) Positive (+) side facing up
4. Replace with a new battery (Type CR2032 or
equivalent) making sure to install the new batterywith the positive (+) side facing up.
5. Install the back half of the transmitter case.
6. Reinstall the two screws on the back of the trans-
mitter case. After the battery is replaced, the transmitter must be synchronized with the keyless entry system ’s
control unit. Press either the “LOCK/ARM” or
“UNLOCK/DISARM” button
six times to synchro-
nize the unit.

Keys and doors
2-10
CAUTION
Do not let dust, oil or water get on or in the
transmitter when replacing the battery. Be careful not to damage the printed circuit
board in the transmitter when replacing the
battery.
Replacing lost transmitters
If you lose a transmitter or want to purchase addi-
tional transmitters (up to four can be programmed),
you should re-program all of your transmitters for
security reasons. It is recommended that you have
your dealer program all of your transmitters into yoursystem.
Programming the transmitters
The keyless entry system is equipped with a special
code learning feature that allows you to programnew transmitter codes into the system or to delete
old ones. The system can learn up to four uniquetransmitter codes. The four transmitter codes may
be the same or different. To enter the programming mode:
1. Press “UNLOCK/DISARM”
button to disarm the
security system. (If your vehicle is equipped with the
optional security system.)

Keys and doors
2-16
To arm the system using power door locking switches
1. Close all windows.
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood (and the trunk
lid) are locked.
5. Close the doors (and the rear gate on the wagon) but leave only the driver ’s door or the front passen-
ger’ s door open.
6. Push the front side ( “LOCK” side) of the power
door locking switch to set the door locks.
7. Close the door. The horn will sound one time, the parking lights will flash one time and the indicator
light will start flashing slowly (approximately once
every two seconds) to inform you that the system
has armed.
NOTE The system can be armed even if the engine hood and/or the windows are opened. Always
make sure that they are fully closed before arm- ing the system. Disarming the system
Briefly press the “UNLOCK/DISARM” button (for less
than two seconds) on the remote transmitter. The
driver’ s door will unlock, the horn will sound two
times, the parking lights will flash two times and the
indicator light will go off.
To unlock all other doors (and the rear gate on the
wagon), briefly press the “UNLOCK/DISARM” button
a second time.
Emergency disarming
If you cannot disarm the system using the transmit-
ter (i.e. the transmitter is lost, broken or the transmit-
ter battery is too weak), you can disarm the system
without using the transmitter.