2003 SUBARU FORESTER lights

9-10
In case of emergency
Do not jump start unless cables in suitable con-
dition are available.
A running engine can be dangerous. Keep
your fingers, hands, clothing, hair and tools
away from the cooling fan, belts and any other
moving engine parts. Removing rings, watches
andtiesisadvisable.
When your vehicle does not start due to a run down
(discharged) battery, the vehicle may be jump started
by connecting your battery to another battery (called
the booster battery) with jumper cables.
Jump starting is dangerous if it done incorrectly. If you
are unsure about the proper procedure for jump start-
ing, consult a competent mechanic. Howtojumpstart
1. Make sure the booster battery is 12 volts and the
negative terminal is grounded.
2. If the booster battery is in another vehicle, do not let
the two vehicles touch.
3. Turn off all unnecessary lights and accessories.
4. Connect the jumper cables exactly in the sequence
illustrated.

11 - 2
Maintenance and service
Tire inspection ................................................. 11-38
Tire pressures and wear ................................. 11-38
Wheel balance .................................................. 11-41
Wear indicators ................................................ 11-41
Tire rotation ...................................................... 11-42
Tire replacement .............................................. 11-43
Wheel replacement .......................................... 11-43
Aluminum wheels (If equipped) ................. 11-44
Windshield washer fluid ............................. 11-45
Replacement of windshield wiper blades . 11-46
Battery .......................................................... 11-49
Fuses ............................................................ 11-50
Main fuse ...................................................... 11-53
Installation of accessories ......................... 11-53
Replacing bulbs ........................................... 11-54 Headlight .......................................................... 11-55
Front turn signal, side marker light and
parking lights ................................................... 11-57
Front fog light .................................................. 11-61
Rear combination lights .................................. 11-61
License plate light ........................................... 11-62
Dome light, map light and cargo area light ... 11-63
High mount stop light ..................................... 11-64

11 - 5 2
Maintenance and service
A) Good
B) Blown
If any lights, accessories or other electrical controls do
not operate, inspect the corresponding fuse. If a fuse
has blown, replace it.
1. Turn the ignition switch to the “LOCK” position and
turn off all electrical accessories.
2. Remove the cover.
3. Determine which fuse may be blown. The back side
of each fuse box cover and the “Fuses and circuits”
section in chapter 12 in this manual show the circuit for
each fuse. 1) Fuse puller
4. Pull out the fuse with the fuse puller.
5. Inspect the fuse. If it has blown, replace it with a
spare fuse of the same rating.
6. If the same fuse blows again, this indicates that its
system has a problem. Contact your SUBARU dealer
for repairs.
AB
HSB067BB
1
HSB068BB

11 -5 3
Maintenance and service
–CONTINUED –
Main fuse
Main fuse box
The main fuses are designed to melt during an over-
load to prevent damage to the wiring harness and
electrical equipment. Check the main fuses if any elec-
trical component fails to operate (except the starter
motor) and other fuses are good. A melted main fuse
must be replaced. Use only replacements with the
same specified rating as the melted main fuse. If a
main fuse blows after it is replaced, have the electrical
system checked by your nearest SUBARU dealer.Installation of accessories
Always consult your SUBARU dealer before installing
fog lights or any other electrical equipment in your ve-
hicle. Such accessories may cause the electronic sys-
tem to malfunction if they are incorrectly installed or if
they are not suited for the vehicle.
HSB065BA

11 -5 7
Maintenance and service
–CONTINUED –
Front turn signal, side marker light and
parking lights
1) Front turn signal light
2) Parking light
3) Front side marker light
The headlight assembly must be removed before the
parking light and front turn signal light bulbs can be re-
placed. When the headlight assembly has been re-
moved and then reinstalled, it may become necessary
to make a headlight aiming adjustment. It may be dif-
ficult to replace the bulbs. Have your SUBARU dealer
replace the bulbs if necessary.
:Clip
: Hook
1
3 2
HSB073BB
HSB074BA

11 -6 1
Maintenance and service
–CONTINUED –
7. Pull the bulb out of the socket. Install a new bulb.
8. Set the bulb socket into the headlight assembly and
turn it clockwise until it locks.
9. Reinstall all the removed parts by following the re-
moval sequence in reverse. Front fog light
It may be difficult to replace the bulbs. Have your
SUBARU dealer replace the bulbs if necessary. Rear combination lights
1. Remove the upper and lower screws. Then, slide
the rear combination lamp assembly to the rear and remove it from the vehicle.
HSB080BA
HSB085BA

12-8
Specifications

Fuse panel located in the engine com- partment
A) FWD socket
B) Main fuse
A 12
3 B
4
5 6
78
91011
12
HSC002BB
Fuse panelFuse ratingCircuit
120A
Radiator cooling fan (Main)
220ARadiator cooling fan (Sub)
330AABS motor
420ARear window defogger
515AHazard warning flasher
Horn
615ATurn signal lights
710AAutomatic
transmission control
unit
810AAlternator
915AHeadlight (right side)
1015AHeadlight (left side)
1120ALighting switch
1215AClock
Interior light

14-4
Index
Stopping .................................................... 7-11
Exterior care ................................................... 10-2 F
Flat tires ................................................. 9-3, 9-5
Floor mat ........................................................ 6-15
Fluid level Automatic transmission ............................. 11-24
Brake ......................................................... 11-30
Clutch (MT vehicles) .................................. 11-31
Power steering ........................................... 11-29
Fog light switch ............................................... 3-21
Front differential gear oi l (AT vehicles) ........... 11-26
Front seatbelt pretensioners ........................... 1-27
Front seats ..................................................... 1-2 Fore and aft adjustment ............................. 1-3
Reclining .................................................... 1-4
Front-wheel drive warning light (AT vehicles) . 3-15
Fuel ................................................................ 7-2
Economy hints ........................................... 8-2
Filler lid and cap ........................................ 7-4
Gauge ........................................................ 3-7
Requirements ............................................ 7-2
Fuses ............................................................. 11-50
Fuses and circuits .......................................... 12-6 G
GAWR ............................................................. 8-16
Glove box ........................................................ 6-5
Gross axle weight rating .................................. 8-16
Gross vehicle weight rating ............................. 8-16
GVWR ............................................................. 8-16 H
Hazard warning flasher ................................... 3-5
Headlights ....................................................... 3-17
Headrest adjustment ....................................... 1-10
Headlight flasher ............................................. 3-18
Heater operation ............................................. 4-6
High beam indicator light ................................. 3-15
Hill holder ................................................ 7-29, 11-35
Horn ................................................................ 3-34 I
Ignition switch .................................................. 3-2
Illuminated entry .............................................. 2-8
Illumination brightness control ......................... 3-20
Indicator light ................................................... 3-9
Inside mirror .................................................... 3-29
Interior lights .................................................... 6-2