2003 SUBARU FORESTER ECU

9-15
In case of emergency
–CONTINUED –
Use only specified towing hooks and tie-
down hooks. Never use su spension parts or
other body parts for towing or tie-down purpos-
es. Never use the tie-down hook on the under-
side of the vehicle closest to the muffler for
towing purposes.
Using a flat-bed truck
This is the best way to transport your vehicle. Use the following procedures to ensure safe transportation.
1. Shift the selector lever into the “P” position for au-
tomatic transmission vehicles or “1st” for manual
transmission vehicles.
2. Pull up the parking brake lever firmly.
3. Secure the vehicle onto the carrier properly with
safety chains. Each of safety chain should be equally
tightened and care must be taken not to pull the chains
so tightly that the suspension bottoms out.
Towing with all wheels on the ground
1. Check the transmission and differential oil levels
and add oil to bring it to the upper level if necessary.
HS9020AA
HS9021AA

11 - 6
Maintenance and service
2. Release the secondary hood release located under
the front grille by moving the lever toward the left.
Lift up the hood, release the hood prop from its retain-
er and put the end of the hood prop into the slot in the
hood.
To close the hood:
1. Lift the hood slightly and remove the hood prop
from the slot in the hood and return the prop to its re-
tainer.
2. Lower the hood until it approaches about
12 in. (30
cm) from the closed position and let it drop.
After closing the hood, be sure the hood is securely
locked.
If this does not close the hood, release it from a slightly
HSB015BAHSB016BA

11-11
Maintenance and service
–CONTINUED –
1) Drain plug
5. Drain out the engine oil by removing the drain plug
while the engine is still warm. The used oil should be
drained into an appropriate container and disposed of
properly.
Be careful not to burn yourself with hot engine
oil.
6. Wipe the seating surface of the drain plug with a
clean cloth and tighten it securely with a new sealing washer after the oil has completely drained out.
1) Oil filter
7. Remove the oil filter with an oil filter wrench.
8. Before installing a new oil filter, apply a thin coat of
engine oil to the seal.
9. Clean the rubber seal seating area of the lower
crank case and install the oil filter by hand turning. Be
careful not to twist or damage the seal.
10.Tighten it approximately two-thirds of a turn after
the seal makes contact with the lower crank case.
Never over tighten the oil filter because that can
1
HSB020BB
HSB020CB
1

11 - 1 6
Maintenance and service
1) Rubber gaskets
3. After refilling the reserve tank and the radiator, re-
install the caps and check that the rubber gaskets in-
side the radiator cap are in the proper position.
Be careful not to spill engine coolant when
adding it. If coolant touches the exhaust pipe, it
may cause a bad smell, smoke, and/or a fire. Do not splash the engine coolant over paint-
ed parts. The alcohol contain ed in the engine
coolant may damage the paint surface.
Changing the coolant
1) Drain plug
Change the engine coolant using the following proce-
dures according to the maintenance schedule.
1. Remove the under cover.
2. Place a proper container under the drain plug and
loosen the drain plug.
3. Loosen the radiator cap to drain the coolant from
the radiator. Then drain the coolant from the reserve
tank. Tighten the drain plug securely.
1
HSB026BB
1HSB027BB

11 -1 9
Maintenance and service
–CONTINUED –
Air cleaner element
The air cleaner element functions as a filter screen.
When the element is perforated or removed, engine
wear will be excessive and engine life shortened.
The air cleaner element is a viscous type. It is unnec-
essary to clean or wash the element.
Do not operate the engine with the air cleaner
element removed. The air cleaner element not
only filters intake air but also stops flames if the
engine backfires. If the air cleaner element is
not installed when the engine backfires, you
could be burned.
Replacing the air cleaner element
Replace the air cleaner element according to the
maintenance schedule in the “Warranty and Mainte-
nance Booklet”. Under extremely dusty conditions, re-
place it more frequently. It is recommended that you
always use genuine SUBARU parts.
0
1) Bolt
1. Remove the bolt securing the rear air cleaner ele-
ment case.
2. Unsnap the three clamps holding the rear air clean-
er element case.
1
HSB030BB

14-6
Index
P
Parking brake ......................................... 7-27, 11-37
Stroke ........................................................ 11-37
Parking light switch ......................................... 3-21
Parking your vehicle ....................................... 7-27
Periodic inspections ....................................... 8-5Power Door locking switches ................................ 2-5
Steering ..................................................... 7-20
Steering fluid level ..................................... 11-29
Windows .................................................... 2-21
R
Rear Combination lights ..................................... 11-61
Differential gear oil level ............................ 11-27
Gate ................................................... 2-24, 9-17
Seats ......................................................... 1-9
Viscous limited slip differential (LSD) ........ 7-20
Rear Window Defogger switch ......................................... 3-27
Wiper and washer switch ........................... 3-25
Remote keyless entry system ........................ 2-6
Replacing Air cleaner element .................................... 11-19
Battery (remote keyless entry) ................... 2-9
Bulbs ......................................................... 11-54 Transmitters ............................................... 2-10
Rocking the vehicle ......................................... 8-13
Roof rail and crossbar ..................................... 8-17 S
Seatbelts ......................................................... 1-12
Seatbelt Maintenance ............................................... 1-26
Pretensioners ............................................. 1-27
Safety tips ................................................... 1-12
Warning light and chime ............................. 3-9
Seats
Fabric ......................................................... 10-5
Heater ......................................................... 1-8
Seat height adjustment (driver’s side) ............. 1-5
Security system ............................................... 2-14
Selector lever (AT vehicles) ............................ 7-15
Self-leveling rear suspension .......................... 7-34
Shift lock release ............................................. 7-18
Shift position indicator ..................................... 3-15
Shopping bag hook ......................................... 6-18
Snow tires ....................................................... 8-12
Snowy and icy roads ....................................... 8-11
Spark plugs ..................................................... 11-20
Specifications .................................................. 12-2
Speedometer ................................................... 3-5
SRS airbags .................................................... 1-39