2003 RENAULT CLIO Owners Manual

1
23
QXBIUDB*T[G      3DJH 
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T5.WIN 30/10/2002 12:27-page15
5.15
REAR LIGHTS: replacing the bulbs(continued)
Third centre stop light1
The third stop light is a special strip
light. Consult your Renault Dealer if
any work needs to be carried out on
this.
Number plate lights
Release bulb holder2(using a flat
blade screwdriver for example).Unclip lens3from the bulb holder
to reach the bulb.
Bulb type: double ended tubular
bulb 5 W.

1
2
QXBIUDB*T[G      3DJH 
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T5.WIN 30/10/2002 12:27-page16
5.16
SIDE REPEATERS: replacing the bulbs
Unclip the repeater1(using a flat
blade screwdriver for example).Turn the bulb holder2a quarter turn
and remove the bulb.
Bulb type: W 5 W.

14
2
3
QXBIUDB*T[G      3DJH 
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T5.WIN 30/10/2002 12:27-page17
5.17
INTERIOR LIGHTS: replacing the bulbs
Courtesy light
Unclip cover1(using a tool such as
a flat screwdriver).Turn bulb holder2or3aquarterofa
turn.
Bulb type: W 5 Wor:festoon type
bulb 7W for a single courtesy light.
Rear lights4
Unclip the light (using a tool such as
a flat-bladed screwdriver).
Remove the bulb by turning it a
quarter of a turn.
Type of bulb: Bayonet type 5 W.

6
7
8
5
QXBIUDB*T[G      3DJH 
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T5.WIN 30/10/2002 12:27-page18
5.18
INTERIOR LIGHTS: replacing the bulbs(continued)
Door lights5
Unclip the light5(using a tool such
as a flat blade screwdriver).
Release the bulb.
Type of bulb: W 5 W.
Luggage compartment light6
Unclip light6by pressing on the
tabs on each side of the light (using
a tool such as a flat screwdriver).
Disconnect the light.Press tab7to release the lens and
reach the bulb8.
Type of bulb: double-ended tubular
bulb 7 W.

QXBIUDB*T[G      3DJH 
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T5.WIN 30/10/2002 12:27-page19
5.19
BATTERY breakdown
To avoid all risk of sparks:
- Ensure that the consumers are
disconnected before disconnecting
or reconnecting the battery.
- When charging, switch off the
charger before connecting or
disconnecting the battery.
- Do not place metal objects on the
battery to avoid creating a short
circuit between the terminals.
Connecting a battery charger
Both battery leads must be
disconnected (with the engine
switched off).
Do not disconnect the battery when
the engine is running.Follow the
instructions for use given by the
manufacturer of the battery charger
you are using.Only a well-charged and
well-maintained battery will have a
long and useful life and enable you
to start the vehicle’s engine
normally.
The battery must be kept clean and
dry.
Have the battery's charge status
checked regularly:
• especially if you use your vehicle
for short journeys or for frequent
driving in town;
• When the external temperature
drops (in winter),the charge
decreases. In winter, only use
those electrical comsumers which
are really necessary.
• Finally, you should understand
that the charge decreases
naturally as a result of certain
permanent consumers such as:
the clock, aftermarket
accessories...When a large number of accessories
are fitted to the vehicle, have them
connectedto + after ignition.Inthis
case, it is advisable to have your
vehicle fitted with a battery which
has an increased nominal capacity.
Consult your Renault Dealer.
If the vehicle is to be left stationary
for a long time, disconnect the
battery and recharge it regularly,
especially in cold weather. The
memories, radio etc. will then have
to be reprogrammed. The battery
must be stored in a dry and
ventilated area protected from frost.
Specific procedures may
be required to charge
some batteries. Consult
your Renault Dealer.
Avoid all risk of sparks which
may cause an immediate
explosion and charge the battery
in a well-ventilated area.
Risk of serious injury.

1
4A
2B
3
QXBIUDB*T[G      3DJH 
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T5.WIN 30/10/2002 12:28-page20
5.20
BATTERY: breakdown(continued)
Starting the vehicle using the
battery from another vehicle
Proceed as follows when starting
your vehicle from another vehicle's
battery:
Obtain suitable jump leads (with a
large cross section) from a Renault
Dealer or, if you already have jump
leads, ensure that they are in perfect
condition.
Both batteries must have an
identical nominal voltage: 12 volts.
The battery supplying the current
should have a capacity (amp-hours,
Ah) which is at least the same as
that of the discharged battery.
A frozen battery must be thawed out
before current is supplied to it.
Ensure that there is no risk of
contact between the two vehicles
(risk of short circuiting when the
positive terminals are connected)
and that the discharged battery is
properly connected. Switch off your
vehicle ignition.
Start the engine of the vehicle
supplying the current and run it at
average speed.Secure the positive cable (+)Ato
the (+) terminal1of the discharged
battery then to (+) terminal2of the
battery supplying the current.
Secure the negative cable (–)Bto
the (–) terminal3of the battery
supplying the current then to the (–)
terminal4of the discharged battery.Check that there is no contact
between cablesAandBand that
cableAis not touching any metal
parts on the vehicle supplying the
current.
Start the engine as you would
normally. As soon as it starts,
disconnect cablesAandBin the
reverse order (4-3-2-1).
Handle the battery with
care since it contains
sulphuric acid which
must never come into
contact with eyes or skin. If it
does, wash with plenty of water.
Keep all flames, light sources
and sparks away from the
battery: risk of explosion.
Take care when working in the
engine compartment as the
engine cooling fan may cut in at
any moment without warning.

1
2
QXBIUDB*T[G      3DJH 
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T5.WIN 30/10/2002 12:28-page21
5.21
REMOTE CONTROL LOCKING DEVICE(batteries)
Replacing the battery
Slide off the remote control cover1.
The batteries can be obtained
from your Renault Dealer.
These batteries should last about
two years. There is a delay of 1
second between locking and
unlocking actions.Replace the battery2according to
the direction marked on the cover.
Note:When replacing the battery, it
is advisable not to touch the
electronic circuit in the key cover.

1
A
32
4
3
QXBIUDB*T[G      3DJH 
nu654-6 - CLIO IIC:\Documentum\Checkout
u654-6_eng_T5.WIN 30/10/2002 12:28-page22
5.22
FUSES
CORRECT INCORRECT
Fuse box2
If electrical equipment does not
work, check the condition of the
fuses.
Lift coverAusing handle1.
To identify the fuses, refer to the
fuse allocation label4(shown on
the page opposite).
It is not advisable to use the free
fuse locations.Check the fuse in question
andreplace it,if necessary,
with a fuse which must be
ofthesameratingasthe
original fuse.
If a fuse is fitted where the rating is
too high, it may cause the electrical
circuit to overheat (risk of fire) in
the event of an item of equipment
usinganexcessiveamountof
current.Removethefuseusingtweezers3.
Slide the fuse sideways to remove it
from the tweezers.
A sensible precaution:
Obtain an emergency kit
containing spare bulbs and fuses
from your RENAULT Dealer.