2003 PONTIAC GRAND AM clock

2.
3.
4.
5.
Lift the headlamp assembly forward, out of the
mounting bracket.
Turn the bulb assembly retainer counterclockwise
one-sixth of a turn and pull out the bulb assembly.
Unclip the bulb assembly from the wiring harness.
After replacing the bulb, reverse Steps
1 through 4
to reinstall the bulb assembly and headlamp
assembly.
Front Turn Signal and Parking
Lamps
1. Remove the headlamp assembly. Refer to the
removal procedure earlier in this section.
2. Turn the bulb assembly retainer and pull out
the bulb.
3. Unclip the bulb assembly from the wiring harness.
4. When replacing the bulb, be sure to properly
align the bulb with the locating feature in the
assembly.
5. Reverse Steps 1 through 3 to reinstall the bulb
assembly.
Center High-Mounted Stoplamp
(CHMSL)
1,
2,
3.
4
Open the trunk lid and locate the center
high-mounted stoplamp on the inside of the lid.
Remove the three screws.
Gently remove and replace the bulb(s).
Reverse Steps
1 and 2 to reassemble the lamp
assembly.
5-50

Removing the Spare Tire and Tools
The equipment you’ll need is in the trunk.
1. Pull the carpeting from
the floor of the trunk.
I Turn the center retainer
nut on the compact spare
tire cover
counterclockwise to
remove it.
2. Lift and remove the cover. See Compact Spare
Tire on page
5-71 later in this section for more
information about the compact spare.
3. Turn the wing nut
counterclockwise and
remove
it. Then lift off the
spacer and remove the
compact spare tire.
4. Remove the jack and wheel wrench from the trunk.
Your vehicle’s jack and wheel wrench are stored in
a foam tray. Remove the band around the jack.
5-63

Raising your vehicle with the jack improperly
positioned can damage the vehicle and even
make the vehicle fall.
To help avoid personal
injury and vehicle damage, be sure to fit the
jack
lift head into the proper location before
raising the vehicle.
4. Raise the vehicle by turning the wheel wrench
clockwise. Raise the vehicle far enough
off the
ground
so there is enough room for the compact
spare tire
to fit underneath the wheel well.
5. Remove all of the wheel nuts.
6. Remove the flat tire.
7. Remove any rust or dirt
from the wheel
bolts,
mounting surfaces
and spare wheel.
5-66

c
10. Lower the vehicle by turning the wheel wrench
counterclockwise. Lower the jack completely.
11. Tighten the wheel nuts
firmly in a crisscross
sequence, as shown.
E
Incorrect wheel nuts or improperly tightened
wheel nuts can cause the wheel to come loose
and even come
off. This could lead to an
accident. Be sure to use
the correct wheel
nuts. If you have to replace them, be sure to
get new
GM original equipment wheel nuts.
Stop somewhere as soon as you can and have
the nuts tightened with a torque wrench to the proper torque specification. See ”Capacities
and Specifications” in the Index for wheel nut
torque specification.
Notice: Improperly tightened wheel nuts can lead
to brake pulsation and rotor damage.
To avoid
expensive brake repairs, evenly tighten the wheel
nuts in the proper sequence and to the proper
torque specification. See “Capacities and
Specifications”
in the index for the wheel nut torque
specification.
Notice: Wheel covers won’t fit on your compact
spare. If you try to put a wheel cover on your
compact spare, you could damage the cover or
the spare.
5-68