17-11-2003
PEUGEOT SERVICING25
A, B AND C SERVICE LEVELS AND THE INTERMEDIATE VISIT
: All driving conditions : Arduous conditions * According to country.
1st Level
Operations Description of operation serviceA B C Intermediate
DRAIN/REFILLÐ Engine oil Ð Bleed fuel filter (diesel) Ð Oil filter Ð Fuel filter* (petrol) REPLACEÐ Fuel filter element (diesel) Ð Air filter element Ð Spark plugs (petrol) Ð Engine oil (check + top-up) Ð Battery (check + top-up) if cap is removable LEVELÐ Screen wash (check + top-up) Ð Coolant (check + top-up) Ð Brake fluid (check + top-up) Ð Power steering fluid (check + top up according to specification) Ð Operation of lights and indicators Ð Condition of glass, headlamp and light lenses and mirrors Ð Horn Ð Windscreen washer jets Ð Condition of wiper blades Ð Condition and tension of the ancillary drive belts Ð Handbrake and clutch Ð Condition of hydraulic circuits (hoses and covers) CHECKÐ Condition of rubber boots and gaiters Ð Brake pads Ð Play in hubs, link rods, ball joints, flexible mountings Ð Shock absorbers Ð Rear drum brake lining wear Ð Condition and pressure of tyres (including spare wheel) Ð Emission control check as per current legislation (petrol) Ð Smoke opacity (diesel) Ð Passenger compartment filter (according to specification) Ð Visual check of the whole vehicle
SERVICE*Ð Courtesy vehicle
ROAD TEST
17-11-2003
PRACTICAL INFORMATION
136
CHANGING A WHEEL Parking the vehicle
Whenever possible, park the vehicle on level, stable and non-slippery ground.
Apply the handbrake, switch offthe ignition and engage first orreverse gear (position Pfor the
automatic gearbox).
Tools The following tools are in a holder under the front passenger seat: 1 -Jack.
2 - Ratchet spanner.
3 - Spare wheel carrier access socket.
4 - Wheelbrace.
5 - Screwdriver (for removal of the grille when changing bulbs).
Access to the spare wheel The spare wheel is located in a carrier underneath the vehicle at
the rear. The two carrier support bolts are located near the outer edge of the
rear floor.
Unclip the covers on the bolts.
Slacken these two bolts using a ratchet spanner 2and the socket
3 .
Lift the carrier to release theretaining hook using the wheel-brace 4.
