Page 127 of 181

When parking on a slope, direct your wheelstowards the pavementand apply the handbrake.
Always engage first gear, as aprecaution. Only apply the handbrake when
the vehicle is stationary.
Operating abnormality Any operating abnormality is indicat- ed by flashing of the Snow warninglight on the instrument panel. In this situation the gearbox operates in downgrade mode (locked in 3rd
gear). You may feel a substantialknock when changing from Pto R
and from Nto R(this will not cause
any damage to the gearbox). Do not exceed 60 mph (100 km/h), keeping within the limit of localspeed restrictions.
Contact a PEUGEOT dealer as soon as possible. MANUAL GEARBOX Reverse*
To change to reverse gear, lift the ring under the gear lever knob andpush the gear lever to the left then tothe front. Reverse gear can only be engaged when the vehicle is stationary withthe engine idling. HANDBRAKE Applying When parking, pull the handbrake to immobilise your vehicle. Releasing Pull the handle and press the button to release the handbrake.
CHRONOTACHOGRAPH Refer to the document enclosed in the pocket.
YOUR BOXER IN DETAIL
124
If the battery is flat and the lever is in position
P, it will
be impossible to changeto another position.
ABS ANTI-LOCK BRAKING SYSTEM
The ABS with Electronic Brake Force Distribution (EBFD) increases thestability and manoeuvrability of yourvehicle, particularly on poor or slip-pery road surfaces. Note: when changing wheels (tyres
and rims), make sure that these are approved. The anti-lock braking system comes into operation automatically whenthere is a risk of wheel lock.
* According to engine. Lighting of this warning light indicates that the handbrakeis still applied or has not
been released correctly.
17-11-2003
Page 128 of 181

When parking on a slope, direct your wheelstowards the pavementand apply the handbrake.
Always engage first gear, as aprecaution. Only apply the handbrake when
the vehicle is stationary.
Operating abnormality Any operating abnormality is indicat- ed by flashing of the Snow warninglight on the instrument panel. In this situation the gearbox operates in downgrade mode (locked in 3rd
gear). You may feel a substantialknock when changing from Pto R
and from Nto R(this will not cause
any damage to the gearbox). Do not exceed 60 mph (100 km/h), keeping within the limit of localspeed restrictions.
Contact a PEUGEOT dealer as soon as possible. MANUAL GEARBOX Reverse*
To change to reverse gear, lift the ring under the gear lever knob andpush the gear lever to the left then tothe front. Reverse gear can only be engaged when the vehicle is stationary withthe engine idling. HANDBRAKE Applying When parking, pull the handbrake to immobilise your vehicle. Releasing Pull the handle and press the button to release the handbrake.
CHRONOTACHOGRAPH Refer to the document enclosed in the pocket.
YOUR BOXER IN DETAIL
124
If the battery is flat and the lever is in position
P, it will
be impossible to changeto another position.
ABS ANTI-LOCK BRAKING SYSTEM
The ABS with Electronic Brake Force Distribution (EBFD) increases thestability and manoeuvrability of yourvehicle, particularly on poor or slip-pery road surfaces. Note: when changing wheels (tyres
and rims), make sure that these are approved. The anti-lock braking system comes into operation automatically whenthere is a risk of wheel lock.
* According to engine. Lighting of this warning light indicates that the handbrakeis still applied or has not
been released correctly.
17-11-2003
Page 129 of 181

When parking on a slope, direct your wheelstowards the pavementand apply the handbrake.
Always engage first gear, as aprecaution. Only apply the handbrake when
the vehicle is stationary.
Operating abnormality Any operating abnormality is indicat- ed by flashing of the Snow warninglight on the instrument panel. In this situation the gearbox operates in downgrade mode (locked in 3rd
gear). You may feel a substantialknock when changing from Pto R
and from Nto R(this will not cause
any damage to the gearbox). Do not exceed 60 mph (100 km/h), keeping within the limit of localspeed restrictions.
Contact a PEUGEOT dealer as soon as possible. MANUAL GEARBOX Reverse*
To change to reverse gear, lift the ring under the gear lever knob andpush the gear lever to the left then tothe front. Reverse gear can only be engaged when the vehicle is stationary withthe engine idling. HANDBRAKE Applying When parking, pull the handbrake to immobilise your vehicle. Releasing Pull the handle and press the button to release the handbrake.
CHRONOTACHOGRAPH Refer to the document enclosed in the pocket.
YOUR BOXER IN DETAIL
124
If the battery is flat and the lever is in position
P, it will
be impossible to changeto another position.
ABS ANTI-LOCK BRAKING SYSTEM
The ABS with Electronic Brake Force Distribution (EBFD) increases thestability and manoeuvrability of yourvehicle, particularly on poor or slip-pery road surfaces. Note: when changing wheels (tyres
and rims), make sure that these are approved. The anti-lock braking system comes into operation automatically whenthere is a risk of wheel lock.
* According to engine. Lighting of this warning light indicates that the handbrakeis still applied or has not
been released correctly.
17-11-2003
Page 133 of 181

17-11-2003
YOUR BOXER IN DETAIL127
REAR PARKING ASSISTANCE This system consists of proximity
sensors, located in the rear bumper,and a special speaker fitted in thefascia. This detects any obstacle (person, vehicle, tree, gate, etc.) behind the
vehicle. However, it may not detectobstacles located just below the
bumper. An object, such as a stake, a road- works cone or any other similarobject may be detected at the begin-ning of the manoeuvre, but may nolonger be detected when the vehicleis close to it. Note:
this function will be disarmed
automatically when the vehicle is
towing a trailer.
In bad or wintry weather, ensure that the sensors are not covered with
mud, frost or snow. Activation The system is activated as soon as reverse gear is engaged; an audiblebleep shows that it is active. The proximity information is given by an audible signal, which becomesmore rapid as the vehicle approachesthe obstacle. When the distance between the rear of the vehicle and the obstacle is lessthan approximately twenty centime-tres, the audible signal becomes con-tinuous.Deactivation
Change to neutral, the system is again inactive.
Detection zone
If there is an operating fault, the audible signalwill be a short bleep fol-lowed by a long bleepwhen changing to reverse
gear.
Page 143 of 181

17-11-2003
Only use products recom-
mended by PEUGEOT.
To ensure best perform- ance from components as
important as the power steering andthe braking system, PEUGEOTselects and offers quite specificproducts.
CHECKS Battery
At the start of winter, have your bat-
tery checked by a PEUGEOT dealer. Air filter and passenger compartment filter Have the filter elements replaced
regularly. If you drive in dusty con-
ditions, change them twice asoften. Brake pads Brake pad wear depends on the style of driving, in particular for vehi-cles which are used in town, overshort distances. It may be necessary to check the thickness of the pads, even betweenservices. Handbrake Where the handbrake travel is too great or there is a reduction in theperformance of the system, thehandbrake should be adjusted, evenbetween services. Have the system checked by a
PEUGEOT dealer. Oil filter
Change the filter regularly, in accor- dance with the servicing schedule.
Fuel supply cut-off In a serious collision, a system pre- vents fuel from reaching the engine.
To re-establish the fuel supply, press the switch on the angle of the front
left-hand suspension assembly,under the bonnet.
PRACTICAL INFORMATION 135
Page 148 of 181
17-11-2003
Rear lights
1 - Brake lights (P 21 W).
2 - Reversing lights (P 21 W).
3 - Direction indicators (PY 21 W).
4 - Fog lamps/Side lights (P 21/4 W).
Unscrew the two bolts Aand
release the unit,
Disconnect the connector B,
Unscrew the two bolts Cat the
rear of the unit,
Change the faulty bulb.
PRACTICAL INFORMATION
140
Number plate lights (C 5 W) Insert a thin screwdriver into one of the external holes of the lens.
Push it outwards to unclip it.
Remove the lens.
Unscrew the bolt and release theassembly towards the right to
extract the bulb holder.
Change the faulty bulb.
Chassis cab lights (W 5 W) Unscrew the four bolts to gain access to the bulbs.
Third brake light (W 5 W)
Unscrew the 2 fixing screws.
Release the lamp unit by push- ing it outwards.
Disconnect the connector.
Squeeze the two tabs to release
the bulb holder.
Change the faulty bulb.
When refitting, ensure that thelamp unit seal has been put back
in place correctly.
Page 157 of 181
17-11-2003
TOWING YOUR VEHICLE
Without lifting (4 wheels on the ground)
You must always use a tow bar. The towing eyes are located at the front and the rear under the vehicle's bumpers. Lifting (2 wheels only on the ground) It is preferable to raise the vehicle with a professional lifting device.Special features of the automatic gearbox When towing with four wheels on the ground, the following rules must beobeyed:
Ð lever in position
N,
Ð tow the vehicle at less than 30 mph (50 km/h) over a maximum dis- tance of 30 miles (50 km).
PRACTICAL INFORMATION
148
When towing with the engine switched off, thereis no braking or steeringassistance.
Page 158 of 181

17-11-2003
TOWING A TRAILER,
CARAVAN, BOAT etc.
Only use original PEUGEOT tow bars that have been tested andapproved from the design stage ofyour vehicle. The tow bar must be fitted by a
PEUGEOT dealer.
Your vehicle is primarily designed for transporting people and luggage butit may also be used for towing a
trailer. Driving with a trailer subjects the towing vehicle to more significantstress and its driver must be particu-larly careful. Air density decreases with altitude, thus reducing engine performance.
Above 1 000 metres, the maximum
towing load must be reduced by 10 %
and so on for every 1 000 metres ofaltitude.Driving advice Distribution of loads:
Distribute the
load in the trailer so that the heaviest items are as close as possible to theaxle and the nose weight approachesthe maximum permitted withoutexceeding it. Cooling: Towing a trailer on a slope
increases the temperature of the coolant. As the fan is electrically controlled, its cooling capacity is not dependenton the engine speed.
On the contrary, use a high gear to lower the engine speed and reduceyour speed. The maximum towing load on a long slope depends on the gradient andthe outside temperature. In all cases, pay attention to the coolant temperature. If the warning light comes on, stop
the vehicle and switch off the engineas soon as possible. Tyres:
Check the tyre pressures
of the towing vehicle and of the
trailer, observing the recommendedpressures. Braking: Towing increases the
braking distance. Lights: Check the electrical signal-
ling on the trailer.Side wind: Take into acount the
increased sensitivity to side wind.
PRACTICAL INFORMATION 149