2003 PEUGEOT BOXER DAG ECU

17-11-2003
REAR DOORS Opening the doors from outside
To open, pull the rear right door handle towards you and open the rear leftdoor by pulling the lever on theinside.
YOUR BOXER IN DETAIL
110
FRONT DOORS AND SLIDING SIDE DOOR Opening the doors from outside (front and side doors) Opening the doors from inside (front doors) The front door opening controls per- mit complete unlocking of the vehicle. Locking/Unlocking from the inside Front door
To lock, lower button
A.
The closing control of one of the front doors permits complete locking ofthe vehicle.
To unlock and open, lift button Aand
pull the handle towards you. The opening control of one of the front doors permits complete unlockingof the vehicle. Sliding side door The side door opening/closing control only controls the door concerned. Side door child lock This prevents opening of the side door from the inside.  Turn the control a quarter turn
using the ignition key.
Note: the sliding side door can be
secured in the fully open position. Torelease it, pull the handle towards
you and slide the door.

17-11-2003
REAR DOORS Opening the doors from outside
To open, pull the rear right door handle towards you and open the rear leftdoor by pulling the lever on theinside.
YOUR BOXER IN DETAIL
110
FRONT DOORS AND SLIDING SIDE DOOR Opening the doors from outside (front and side doors) Opening the doors from inside (front doors) The front door opening controls per- mit complete unlocking of the vehicle. Locking/Unlocking from the inside Front door
To lock, lower button
A.
The closing control of one of the front doors permits complete locking ofthe vehicle.
To unlock and open, lift button Aand
pull the handle towards you. The opening control of one of the front doors permits complete unlockingof the vehicle. Sliding side door The side door opening/closing control only controls the door concerned. Side door child lock This prevents opening of the side door from the inside.  Turn the control a quarter turn
using the ignition key.
Note: the sliding side door can be
secured in the fully open position. Torelease it, pull the handle towards
you and slide the door.

17-11-2003
OPENING THE BONNET From inside: pull the handle on the
left-hand side under the fascia. From outside: lift the catch Aand
raise the bonnet. Bonnet strut Secure the strut to hold the bonnet open. Before closing the bonnet, replace the strut in its housing.
To close Lower the bonnet and release it at the end of its travel. Check that thebonnet is properly locked. FILLING WITH FUEL Low fuel level
When the minimum fuel level in the tank is reached, thiswarning light comes on.
You have approximately
8 litres of fuel left.
The engine must be switched offwhen filling with fuel. 
Open the fuel filler flap by pressingthe front of it.
 Insert the key then turn it to theleft.
 Remove the cap and hang it onthe hook located on the inside ofthe flap.
An indication on the cap reminds youwhich type of fuel to use. When you fill your tank, do not con-
tinue after the third cut-off of the
pump. This could cause your vehicleto malfunction. The capacity of the tank is appro- ximately 70 litres.  After filling the tank, lock the cap and close the fuel filler flap.
The key cannot be removed from thelock until the cap has been replacedon the fuel tank.
YOUR BOXER IN DETAIL
112

17-11-2003
YOUR BOXER IN DETAIL121
INTERIOR FITTINGS
1. FITTINGS IN THE DOORS A. Armrest.
B. Bottle holder.
C. Storage compartment.
2. GRAB HANDLE This is installed for the front centre passenger.
3. SUN VISORS The sun visors are fitted with pockets for storing docu- ments.
4. WRITING TABLE (Folding) The table is located in the centre of the instrumentpanel. Lift the table Dat the clip Fto open it.
The clip Fcan be used to secure documents.
To fold the table D, press the middle of the bar Eand
fold the table.Note: the writing table is fixed if your vehicle is fitted
with a passenger air bag.
5. GLOVE BOX This is fitted with a lock.
To open the glove box, lift the handle. 6. LIGHTER
7. ASHTRAY
Pull the cover to open the ashtray.
To empty, after opening, remove it pulling upwards.
8. 12 VOLT ACCESSORIES SOCKET This is located at the bottom of the centre console.
9. STORAGE TRAY UNDER THE DRIVER AND PASSENGER SEAT
10. TABLE (2 seat bench seat) The table is located in the seat back of the 2 seat bench seat. Pull the handle at the top of the seat back to fold the table. It is fitted with:Ð a document clip,
Ð a pen holder,Ð two can holders.

17-11-2003
PRACTICAL INFORMATION
138
CHANGING A BULB Front lights Removing a headlamp unit:
Ð Open the bonnet,
Ð Unscrew the bolts
Afrom the grille
to gain access to the unit 1,
Ð Unscrew the nuts Busing a wrench
and pull the unit 1outwards,
Ð Unclip the two strips C,
Ð Unclip the rubber protector D,
Ð Disconnect the connector. Note: handle the bulbs with a dry
cloth. 1 - Dipped beam headlamps
(H7-60 W),
 Press and release the spring G,
 Extract the bulb holder Hto
change the bulb.
2 - Main beam headlamps (H1-60 W),
 Press and release the spring E,
 Extract the bulb holder Fto
change the bulb.
3 - Front fog lamps (H1-60 W).  Contact a PEUGEOT dealer.When fitting the new bulb, ensure that the direction notches are posi-tioned correctly and the securing clip
is fixed properly. Carry out the operations in the reverse order to refit. The headlamp units are fitted with polycarbonate glass with a protec-tive coating. Do not clean them
with a dry or abrasive cloth, norwith a detergent or solvent prod-uct. Use a sponge and soapy water.