2003 Peugeot 406 lock

17-02-2003
BOOT Simultaneous locking or unlocking of the boot and the doors
Turn the key a quarter turn from Ato B.
The boot is then controlled by theremote control or the driver's doorlock. Locking the boot only
Turn the key a quarter of a turn from A to C. The boot is then locked,
whatever the action of the remotecontrol or the driver's door lock.
To return to simultaneous operation with the doors: turn the key fromA to B.
YOUR 406 IN DETAIL
109
SUNROOF
¥ To tilt Press part Aof the switch. To close,
press part Bof the switch until the
sunroof is completely closed.
¥ To open Press part Bof the switch. To close,
press part Aof the switch until the
sunroof is completely closed.
Always remove the key from the ignition whenleaving the vehicle, evenfor a short time.
In the event of contact whenoperating the windows, youmust reverse the movement of
the window. To do this, press theswitch concerned. When the driver operates the passenger window switches, hemust ensure that no one is pre-venting correct closing of the
window. The driver must ensure that pas- sengers use the electric win-
dows correctly. Be aware of children when operating the windows.

17-02-2003
OPENING THE BONNET From inside:pull the handle on the
left-hand side under the fascia.From outside: lift the catch and
raise the bonnet. Bonnet struts These open the bonnet and hold it open.
To close Lower the bonnet and release it at the end of its travel. Check that thebonnet is properly locked. FILLING WITH FUEL Fill with fuel with the engine switched
off.
To open the fuel filler flap, firmly pull the handle on the floor on the outsideof the driver's seat. If you are filling up your tank, do not
continue after the 3rd cut-off of thepump; this could cause your vehicleto malfunction. The capacity of the tank is approxi- mately 15.4 gallons (70 litres).
A filler cap hook is provided on the inside of the fuel filler flap.
YOUR 406 IN DETAIL
110
Opening the tailgate of the 7 seater estate from inside Slide button
Aand press.
To lock the interior control, turn the key to the left.

17-02-2003
PETROL/LPG TWIN FUEL VERSION
168
Filling the LPG tank
(Capacity, approximately 46 litres)
Ð switch off the ignition,
Ð unscrew the cap protecting thefiller opening,
Ð lock the filler nozzle onto the opening (if necessary, screw the appropriate adapter*, located inthe insulated compartment, ontothe filler opening first),
Ð push the button on the pump,
Ð once filling has stopped automati- cally, unlock the filler nozzle,
Ð screw the protective cap back onto the filler opening.
* according to destination. Petrol gauge When the low petrol level indicator comes on, fill the tank without delayas the engine can only start usingpetrol. Furthermore, a low petrollevel may result in fuel circuit faults.
Gas gauge If the outside temperature is high, the gas level indicated by the fuelgauge may be slightly higher thanthe actual level. Safety advice The safety valve must be closed before any main-
tenance or repair work is carried
out on your vehicle. To close it,switch off the ignition. Ensure that there is no risk that the loads carried may damagethe tank.
Testing the tank Decree of 18/01/43 and applica-
tion of article 3 of the A.M. of
24/11/82. The maximum interval between successive tests is eight years.
However, the test must be repeat-ed whenever the vehicle is sold, ifthis sale takes place more than5 years following the last test. It is imperative that any work on the LPG feed system is carried
out by a PEUGEOT dealer.

17-02-2003
AUTOMATIC SWITCHING ON OF THE LIGHTS Side lights and dipped beam head- lamps switch on automatically if the
light is poor, or during continuousoperation of the windscreen wipers.
They switch off as soon as the lightbecomes bright enough or the wind-screen wipers stop. This function is active when the vehicle
is supplied to the customer.
To disarm or activate the function: Place the key in the accessories position (1st notch),
 Press the end of the lights stalkfor more than two seconds.
Note: In foggy weather, the bright-
ness sensor can detect sufficientlight. Because of this, the lights do
not come on automatically. Do not cover the brightness sen-
sor connected to the rain sensor,located in the windscreen behind
the mirror. It is used for automaticswitching on of the lights. Operating check Activation Activation of this function is accom- panied by an audible signal and themessage
"Automatic lighting of
the headlamps activated" on the
multifunction display. Note: Always operate the lighting
controls manually where this is pos- sible. Disarming Disarming of the function is accom- panied by an audible signal and themessage "Automatic lighting of
the headlamps deactivated" on the
multifunction display. When driving, if this function is
switched off when the headlampswould switch on in automatic mode,the lights remain on. It is however possible to disarm this
function and switch off the lights by:
Ð manually switching off the lights using the lights stalk,
Ð switching off the engine.
YOUR 406 IN DETAIL 125
If the brightness sensor does not function correctly , the system acti-
vates the function (the lights come on).The driver is alerted by the flashing ofthe ''dipped beam'' warning light on theinstrument panel.
Contact a PEUGEOT dealer to have the system checked. Follow me Home When there is a low level of bright- ness or at night, if you leave yourvehicle, the side lights and thedipped beam lights may remain onfor approximately one minute.
To do this: place the lights stalk in the AUTO
position,
 place the key in the accessories position (first notch),
 press the end of the lights stalk for
more than two seconds,
 place the lights stalk in the 0posi-
tion,
 flash the headlamps,
 get out of the car and lock it.

17-02-2003
HORN Press one of the spokes or the centre of the steeringwheel.
HEADLAMP ADJUSTMENT Depending on the load in your vehicle, it is recommended that theheadlamp beam is adjusted.0 1 or 2 people in the front seats.
Ð 3 people.
1 5 people.
2 5 people + maximum authorised load.
3 Driver + maximum authorised load.
Initial setting is position 0. Hazard warning lights Press the button, the direction indi- cators flash. They can operate with the ignition
off.
STEERING WHEEL HEIGHT
AND DEPTH ADJUSTMENT
When the vehicle is stationary, unlock the steering wheel by pullinghandle
A.
Adjust the height and depth of thesteering wheel, then lock it by pushinghandle Adown fully.
YOUR 406 IN DETAIL
144
Automatic lighting of hazard warning lights*
When braking in an emergency, depending on the force of decelera-tion, the hazard warning lights come
on automatically. They switch offautomatically the first time youaccelerate.
It is also possible to switch them off by pressing the button.* According to destination.

17-02-2003
Automatic operation Automatic changing of thefour
gears :
 Select function Din the gate.
The gearbox always selects the most suitable gear on the basis of the fol-lowing parameters:
Ð driving style,
Ð road characteristics,
Ð the vehicle's load.The gearbox operates in auto-
adaptive mode without any action
on your part.
Moving off
With the engine running, to move off with the selector lever in position
P:
 It is essential to press the brakepedal to exit position P (shift
lock),
 Select the required function ( R, D,
3 , 2 or 1) then gradually release
the pressure on the brake pedal;the vehicle will move offimme-
diately.
You can also move off with the se-lector lever in position N:
 Release the handbrake with yourfoot on the brake,
 Select the required function ( R,D ,
3 , 2 or 1) then gradually release
the pressure on the brake pedal;the vehicle will move offimme-
diately.
DRIVING Y0UR 406 149
When the engine is idling, with the brakes not ap-plied, if function R,D, 3, 2
or 1is selected, the ve-
hicle will move even if you are notaccelerating. For this reason, do not leave
children unsupervised inside the vehicle, when the engine isrunning. When maintenance operations need to be carried out with theengine running, apply the hand-brake and select function P.
Never select function Nwhen the
vehicle is moving. Never select functions Por R
unless the vehicle is stationary.Do not change from one position to another to improve braking effi-ciency on a slippery surface.
With the selector lever in position P , it will be impossible to change
to another position if your batteryis flat.
Remarks:
To obtain maximum acceleration
without touching the gear lever,press the accelerator pedal down as
far as it will go (kickdown). The gear-box will change down automaticallyor stay in the gear selected, up tomaximum engine speed. When braking, the gearbox changes down automatically so as to provide
efficient engine braking.
If you take your foot off the accele-
rator suddenly, the gearbox will not
change up, so as to improve safety.

17-02-2003
DRIVING Y0UR 406
150
Sport and Snow programmes In addition to the auto-adaptive pro- gramme, you have a choice of two
specific programmes. The pro-gramme selected is displayed on theinstrument panel. Sport Programme Press button S, once the vehicle
has started and function D has
been selected.
The gearbox automatically favours dynamic driving. Snow programme This programme favours starting operations and drive to improvetraction.  Press button , once the vehicle
has started and function Dhas
been selected.
The gearbox adapts to driving on slippery roads. Note:
You can return to the auto-adaptive programme at any time.  Press button Sor again to can-
cel the programme selected. Difficulties in operationAny disruption of the system is sig- nalled by the alternate flashing of theSport and Snow lights on the instru-ment panel. In this case, the gearbox will operate in downgrade mode (locked in 3rd
gear). You may feel a substantialknock when reverse is selected fromP
to Ror from Nto R (without any
risk of damage to the gearbox). Do not exceed 60 m.p.h. (100 km/h), speed restrictions permitting.
Contact a PEUGEOT dealer without
delay.
MANUAL GEARBOX Reverse*
To change to reverse gear, lift the ring under the gear lever knob andpush the gear lever to the left then tothe front. Reverse gear can only be engaged when the vehicle is stationary withthe engine idling.
* According to engine.

17-02-2003
DRIVING Y0UR 406
150
Sport and Snow programmes In addition to the auto-adaptive pro- gramme, you have a choice of two
specific programmes. The pro-gramme selected is displayed on theinstrument panel. Sport Programme Press button S, once the vehicle
has started and function D has
been selected.
The gearbox automatically favours dynamic driving. Snow programme This programme favours starting operations and drive to improvetraction.  Press button , once the vehicle
has started and function Dhas
been selected.
The gearbox adapts to driving on slippery roads. Note:
You can return to the auto-adaptive programme at any time.  Press button Sor again to can-
cel the programme selected. Difficulties in operationAny disruption of the system is sig- nalled by the alternate flashing of theSport and Snow lights on the instru-ment panel. In this case, the gearbox will operate in downgrade mode (locked in 3rd
gear). You may feel a substantialknock when reverse is selected fromP
to Ror from Nto R (without any
risk of damage to the gearbox). Do not exceed 60 m.p.h. (100 km/h), speed restrictions permitting.
Contact a PEUGEOT dealer without
delay.
MANUAL GEARBOX Reverse*
To change to reverse gear, lift the ring under the gear lever knob andpush the gear lever to the left then tothe front. Reverse gear can only be engaged when the vehicle is stationary withthe engine idling.
* According to engine.