2003 Peugeot 307 CC warning

22-09-2003
INSTRUMENTS AND CONTROLS
32
Low fuel level warning light
The warning light comes on for three seconds when the ignition isswitched on. When this light comes on with the engine running, it is accompanied byan audible signal and the message"Fuel level low" on the multi-function
display. When the warning light comes on, you have enough fuel to driveapproximately 30 miles (50 km) .
The tank capacity is approximately
60 litres. This light flashes to indicate a mal- function of the fuel gauge.
Contact a PEUGEOT dealer. Coolant temperature indicator When the needle is in zone
A, the
temperature is correct. When the needle is in zone B, the
temperature is too high. The central
STOP warning light flashes, accom-
panied by an audible signal and themessage "Engine coolant temper-
ature high" on the multi-function
display.
You must stop immediately.
Warning: wait for the engine to cool
before topping up the level.The cooling system is pressurised.In order to avoid any risk of scalding, unscrew the cap two turns to allowthe pressure to drop. When the pressure has dropped, remove the cap and top up the level.
Contact a PEUGEOT dealer. Engine oil temperature indicator When the engine is running, this indicates the oil temperature. The temperature is too high if the maximum graduation is reached.The central
STOPwarning light
flashes, accompanied by an audiblesignal.
You must stop immediately.
Contact a PEUGEOT dealer.
Seat belt not fastened warning light
With the engine running, this indica- tor light comes on when the driver'sseat belt is not fastened.

22-09-2003
YOUR 307 CC IN DETAIL35
MULTI-FUNCTION SCREENS Presentation Monochrome screen B This enables the following information to be displayed:
Ð the time,
Ð the date,
Ð the outside temperature (the
¡C
symbol flashes when there is a risk of ice),
Ð the radio displays,
Ð the status of the openings (doors, bonnet...),
Ð the warning messages (e.g. "Bat- tery charge fault") or information messages (e.g. "Passenger airbag deactivated") displayedtempo-rarily can be cleared bypressing button 1or 2,
Ð the trip computer (see corres- ponding section). Monochrome screen CT andcolour screen DT These two systems are controlled by the
RT3 audio/telephone keypad.
They enable the following informa-tion to be displayed:
Ð the time,
Ð the date,
Ð the outside temperature (a message warns you when there is a risk of ice),
Ð the audio source displays (radio, CD, ...),
Ð the telematic system displays (telephone, services, ...),
Ð the status of the openings (doors, bonnet, ...),
Ð the warning messages (e.g. "Fuel level low") and vehicle functionsstatus messages (e.g. "Passengerair bag deactivated") displayed
temporarily,
Ð the trip computer display (see cor- responding section),
Ð the satellite navigation system displays (see corresponding sec-tion).
Note: to enable you to use all of your
system's functions, you have twoCD ROMs: one, "Configuration",
contains the software and the various
display and spoken information lan-
guages, the other, "Navigation",contains the satellite navigation sys-tem map data. Monochrome screen CT Main menu
Press the RT3 audio/telephone "MENU"
button to access the main
menu and select one of the following
applications:
Ð navigation - guidance (see section "Satellite navigation system"),
Ð trip computer (see corresponding section),
Ð directory (see "RT3 audio/tele- phone" section),
Ð telematics (see "RT3 audio/tele- phone" section),
Ð configuration (see corresponding section).

22-09-2003
YOUR 307 CC IN DETAIL
62
Inputting the PIN code Input your PIN code using the alphanumeric keypad and validate by pressing button Gor but-
ton #to access the network. Connection to the network is validated by the appearance of a sym-
bol on the screen.
Warning: if you make three errors in succession when inputting your PIN code, your SIM card
will be blocked. To unblock it, you will need to input the PUK code. The PUK code will be sup- plied to you by the person selling your SIM card (input of the PUK code allows for 10 errors insuccession; after this the SIM card becomes permanently unusable). Note: the PIN code is required each time the ignition is switched on, unless the PIN code has
been stored in the memory or protection by PIN code is not activated on the SIM card.
Cancelling of PIN code request In the menu "Telephone functions" select "Security" , then "Process the PIN code" , then validate the "Cancel"function.
Warning: in this case, do not lose your SIM card. Losing it would mean anyone who finds it would be able to make un-limited
calls.
Telephone function screens
Not in use This screen indicates the presence of voice messages or text messages (SMS) not lis- tened to/read, the cumulatve time in use since the last zero reset and the status of yourtelephone. In use This screen indicates the time elapsed since the start of the conversation, as well as the number* or name of the person to whom you are speaking (if recorded in the index)and the status of your telephone.
* If this option and service are available.

YOUR 307 CC IN DETAIL
84
FRONT SEATS
1 - Forwards-backwards
adjustment Lift the control and slide the seat forwards or backwards.
2 - Access to rear seats Pull the handle to fold the seatback and move the seat for-wards. On repositioning, the seatreturns to its initial position. Note: you can also use control 3.
Then adjust the angle.
Warning: no person or object
must prevent the seat slide from returning to its initial position;return to this position is neces-sary for the seat to lock in place.
3 - Seat back angle adjustment Push the handle towards the
rear.
22-09-2003

22-09-2003
YOUR 307 CC IN DETAIL91
SEAT BELTS
To lock the seat belts 
Pull the strap, then insert the buckle into the stalk. Pre-tensioning and force-limiting front seat belts Safety in the event of a frontal impact has been improved by the introduc-tion of pre-tensioning and force-limit-ing front seat belts. Depending onthe seriousness of the impact, thepre-tensioning system instantly tight-ens the seat belt firmly against thebody of the occupant. The pre-tensioning seat belts are armed when the ignition is on. The force-limiting device reduces the pressure of the seat belt against thebody of the occupant in the event ofan accident.
Rear seat belts The two rear seats are both fitted with three-point inertia reel seat beltswith force-limiting devices. Slide the straps in the guides
1to
prevent fluttering of the rear seat belts in cabriolet mode.
To be effective, a seat belt must be tightened as close to the body as possible. Depending on the nature and the seriousness of the impact, the pre- tensioners may be triggered before and independently of the air bags.
In all cases of triggering, the air bag warning light on the instrument panelcomes on.
After an impact, have the system checked by a PEUGEOT dealer.

22-09-2003
YOUR 307 CC IN DETAIL
92
THE KEYS
You have two identical keys. They allow you to switch on the ignitionand operate the passenger air bagdisarming switch and the boot open-ing button disarming switch as wellas to
independently operate the
lock on the driver's door, the fuel fillercap and the glove box. Central locking/Unlocking
From the driver's door, the keys allow you to:
Ð lock the doors and boot simultane- ously, as well as fold back the exterior mirrors,
Ð unlock the driver's door. Opening this door unlocks the passenger
door.
The boot can only be unlocked bypressing the locking/unlocking but-ton from inside the vehicle, with thekey in the switch (refer to the corre-sponding section). The remote control This permits remote locking, dead- locking and unlocking of the vehicle,locating of the vehicle, folding of theexterior mirrors and partial openingof the boot. Locking Press button
Ato lock the vehicle.
This is confirmed by fixed lighting of the direction indicators for approxi-mately two seconds.
Vehicles fitted with deadlocking
Warning: deadlocking renders the
internal and external door locking controls inoperative. Pressing button Adeadlocks the
vehicle. This is confirmed by fixed lighting of the direction indicators for approxi-mately two seconds. A second press
on button Awithin
five seconds of deadlocking changesthis to normal locking. This is confirmed by fixed lighting of the direction indicators for approxi-mately two seconds. Unlocking Press button Bto unlock the vehicle.
This is confirmed by rapid flashing of the direction indicators. Note: if the vehicle is locked and
unlocking is activated inadvertently, unless one of the doors or the boot isopened within 30 seconds, the vehi-
cle will lock automatically. Partial opening of the boot Press and hold button Bto partially
open the boot, in addition to unlock- ing the vehicle. Locating your vehicle
To locate your vehicle, if you have locked it, in a car park:  press button A, the courtesy
lights come on and the direction indicators flash for a few sec-onds.

22-09-2003
YOUR 307 CC IN DETAIL93
Confidential card The confidential card contains the identification code necessary for anywork carried out by a PEUGEOTdealer on the electronic immobiliser
system. This code is hidden by afilm, which should be removed only
if necessary. Keep your card in a safe place, never inside the vehicle. Key in ignition
A buzzer sounds on opening the dri-
ver's door, if the key has been left inthe ignition. Changing the battery of the remote control
Warning that the battery is flat is given by an audible signal accompa-nied by the message
''Remote con-
trol battery low'' on the multifunc-
tion display.
To replace the battery, remove the screw then unclip the casing using acoin at the ring (CR 2016/3 volt bat-tery). If the remote control does not work after the battery has been changed,reprogramme the remote control. Programming the remote control  Switch off the ignition.
 Switch the ignition on again.
 Press button Aimmediately.
 Switch off the ignition and remove the remote control key
from the ignition lock. The remotecontrol is now working again.
ELECTRONIC ENGINE IMMOBILISER This locks the engine control system as soon as the ignition has been
switched off and therefore preventsstarting of the vehicle by anyone
who does not have the key. The ignition key has an electronic chip which has a special code.When the ignition is switched on, thecode must be recognised for startingto be possible. If the system does not function correctly , the central locking button
indicator light, situated in the centreof the fascia, flashes rapidly whenthe ignition is switched on (2ndnotch), accompanied by an audiblesignal and the message ''Anti-theft
device faulty'' on the multi-function
display. In this case your vehicle will not start.
Contact a PEUGEOT dealer as soon as possible.

22-09-2003
YOUR 307 CC IN DETAIL93
Confidential card The confidential card contains the identification code necessary for anywork carried out by a PEUGEOTdealer on the electronic immobiliser
system. This code is hidden by afilm, which should be removed only
if necessary. Keep your card in a safe place, never inside the vehicle. Key in ignition
A buzzer sounds on opening the dri-
ver's door, if the key has been left inthe ignition. Changing the battery of the remote control
Warning that the battery is flat is given by an audible signal accompa-nied by the message
''Remote con-
trol battery low'' on the multifunc-
tion display.
To replace the battery, remove the screw then unclip the casing using acoin at the ring (CR 2016/3 volt bat-tery). If the remote control does not work after the battery has been changed,reprogramme the remote control. Programming the remote control  Switch off the ignition.
 Switch the ignition on again.
 Press button Aimmediately.
 Switch off the ignition and remove the remote control key
from the ignition lock. The remotecontrol is now working again.
ELECTRONIC ENGINE IMMOBILISER This locks the engine control system as soon as the ignition has been
switched off and therefore preventsstarting of the vehicle by anyone
who does not have the key. The ignition key has an electronic chip which has a special code.When the ignition is switched on, thecode must be recognised for startingto be possible. If the system does not function correctly , the central locking button
indicator light, situated in the centreof the fascia, flashes rapidly whenthe ignition is switched on (2ndnotch), accompanied by an audiblesignal and the message ''Anti-theft
device faulty'' on the multi-function
display. In this case your vehicle will not start.
Contact a PEUGEOT dealer as soon as possible.