2003 NISSAN X-TRAIL washer fluid

ENGINE MAINTENANCE (YD22DDTI)
MA-33
C
D
E
F
G
H
I
J
K
MA
B
MA

Changing Engine OilELS000CH
WARNING:

Be careful not to burn yourself, as the engine oil is hot.

Prolonged and repeated contact with used engine oil may cause skin cancer: try to avoid direct
skin contact with used engine oil. If skin contact is made, wash thoroughly with soap or hand
cleaner as soon as possible.
1. Warm up engine, put vehicle horizontally and check for engine oil leakage from engine components.
2. Stop engine and wait for 10 minutes.
3. Loosen oil filter cap and then remove drain plug.
4. Drain engine oil.
5. Install drain plug with new washer. Refer to EM-147, "
OIL PAN
AND OIL STRAINER" .
CAUTION:
Be sure to clean drain plug and install with new washer.
6. Refill with new engine oil.
Engine oil specification and viscosity:
Refer to MA-17, "
RECOMMENDED FLUIDS AND LUBRICANTS" .
Engine oil capacity (Approximate):
Unit: (lmp qt)
CAUTION:

The refill capacity depends on the engine oil temperature and drain time. Use these specifica-
tions for reference only.

Always use the dipstick to the determine when the proper amount of engine oil is in the engine.
7. Warm up engine and check area around drain plug and oil filter for oil leakage.
8. Stop engine and wait for 10 minutes.
9. Check the engine oil level.
Changing Oil Filter (TYPE A)ELS000CI
REMOVAL
1. Open oil filter installation/ removal cover on RH engine undercover.
2. Using the oil filter wrench, remove the oil filter.
CAUTION:

Be careful not to get burned when the engine and engine oil are hot.

When removing, prepare a shop cloth to absorb any engine oil leakage or spillage.

Do not allow engine oil to adhere to the drive belts.

Completely wipe off any engine oil that adhere to the engine and the vehicle.Oil pan drain plug:
: 34 N·m (3.5 kg-m, 25 ft-lb)
PBIC0527E
Drain and refill With oil filter change 5.2 (4-5/8)
Without oil filter change 4.9 (4-3/8)
Dry engine (Overhaul)6.3 (5-1/2)
PBIC0249E

WW-8
FRONT WIPER AND WASHER SYSTEM

Terminal and Reference Values for Combination SwitchEKS0032P
Removal and Installation for Front Wiper Arms, Adjustment for Wiper Arms
Stop Location
EKS0032Q
1. Prior to front wiper arm installation, turn on wiper switch to oper-
ate front wiper motor and then turn it “OFF” (Auto Stop).
2. Lift the blade up and then set it down onto glass surface to set
the blade center to clearance “L1” & “L2” immediately before
tightening nut.
3. Eject washer fluid. Turn on front wiper switch to operate front
wiper motor and then turn it “OFF”.
4. Ensure that front wiper blades stop within clearance “L1” & “L2”.

Tighten front wiper arm nuts to specified torque.

Before reinstalling front wiper arm, clean up the pivot area as
illustrated. This will reduce possibility of front wiper arm loose-
ness.
TERMINAL
NO.WIRE
COLORITEM CONDITION
DATA (DC Voltage)
IGNITION
SWITCHCONDITION OR OPERATION
13 L/YWiper auto
Stop signalONWiper is moving Approx. 0V
Wiper while the vehicle is stopped Battery voltage
14 LWiper motor
Operation signal (LO)ON Wiper switchOFF Battery voltage
LO Approx. 0V
15 Y/G Ignition ON signal ON — Battery voltage
16 L/BWiper motor
Operation signal (HI)ON Wiper switchOFF Battery voltage
HI Approx. 0V
17 B/W Ground OFF — —
18 G Washer switch signal ON Wiper switchWASH Approx. 0V
OFF Battery voltage
PKIA5548E
Clearance “L1”: 49.2 - 64.2 mm (1.937 - 2.528 in)
Clearance “L2”: 39.3 - 54.3 mm (1.547 - 2.138 in)
Front wiper:
23.6 N-m (2.4 kg-m, 17 ft-lb)
PKIA5763E
SEL024J

WW-16
REAR WIPER AND WASHER SYSTEM

Terminal and Reference Values for Combination SwitchEKS00330
Removal and Installation for Rear Wiper Arms EKS00331
WIPER ARMS
1. Turn on wiper switch to operate wiper motor and then turn it
“OFF” (Auto Stop).
2. Lift the blade up and then set it down onto glass surface. Set the
black center to clearance “L” immediately before tightening the
nut.
3. Eject washer fluid. Turn on wiper switch to operate wiper motor
and then turn it “OFF”.
4. Ensure that wiper blades stop on the lowest heat wire.

Center to clearance "L".

Tighten rear wiper arm nuts to specified torque.

Before reinstalling wiper arm, clean up the pivot area as
illustrated. This will reduce possibility of wiper arm
looseness.
TERMINAL
NO.WIRE
COLORITEM CONDITION
DATA(DC Voltage)
IGNITION
SWITCHCONDITION OR OPERATION
21 WWiper motor
Operation signal
(ON)ON Wiper switchOFF Battery voltage
ON Approx. 0V
22 LG/BWasher switch sig-
nalON Wiper switchWASH Approx. 0V
OFF Battery voltage
23 BR/YWiper motor
Operation signalON Wiper switch: INT
24 B/W Ground OFF — —
SKIA0083J
"L" : 63.1±7.5 mm (2.484±0.295 in)
: 15.2 N-m (1.5 kg-m, 11 ft-lb)SKIA0077E
SEL024J

IDX-7
A
C
D
E
F
G
H
I
J
K
L B
IDX
ALPHABETICAL INDEX
Park/neutral position switch (A/T) .................... AT-100
Park/neutral position switch (M/T) ..................... MT-13
PCV (positive crankcase ventilation) . EC-478, EC-870
PGC/V - Wiring diagram .................................. EC-267
PHASE - Wiring diagram ................... EC-255, EC-648
Pilot bushing replacement - See Pilot
converter(QR20DEQR25DE) ........................... EM-82
Piston assembly(QR20DEQR25DE) .............. EM-103
Piston pin inspection(QR20DEQR25DE) ......... EM-99
Piston pin inspection(YD22DDTi) .................... EM-222
Piston ring inspection(QR20DEQR25DE) ...... EM-100
Piston ring inspection(YD22DDTi) ................... EM-227
Piston to bore clearance(QR20DEQR25DE) . EM-103
Piston to bore clearance(YD22DDTi) .............. EM-230
PNP/SW - Wiring diagram EC-375, EC-727, EC-1183,
EC-1480
PNPSW1 - Wiring diagram .............................. EC-817
POS - Wiring diagram ........................ EC-248, EC-640
POWER - Wiring diagram .................................... PG-3
Power antenna .................................................. AV-41
Power door lock .................................................. BL-22
Power seat ......................................................... SE-10
Power socket ................................................... WW-29
Power steering fluid level ......................... PS-6, MA-44
Power steering gear .......................................... PS-13
Power steering oil pressure switch EC-1186, EC-1483
Power steering oil pump .................................... PS-24
Power steering pressure (PSP) sensor .......... EC-274,
EC-656
Power supply routing ........................................... PG-2
Power window .................................................. GW-40
Precations for Leak detection dye ................... ATC-12
Precautions (General) .......................................... GI-4
Pre-delivery inspection ........................................ MA-4
Pressure plate - See Clutch cover ..................... CL-14
PRGVLV - Wirng diagram ............................... EC-810
Propeller shaft ..................................................... PR-3
Propeller shaft on vehicle service ........................ PR-3
PS/SEN - Wiring diagram .................. EC-275, EC-657
PST/SW - Wiring diagram ............. EC-1187, EC-1484
Q
Quick-glow system ........................ EC-1169
, EC-1457
R
R/FOG - Wiring diagram ..................................... LT-56
Radiator(QR20DEQR25DE) ................ CO-12, CO-14
Radiator(YD22DDTi) ............................ CO-34, CO-38
Radio - See Audio ............................................... AV-4
Rear air spoiler .................................................... EI-30
Rear bumper ........................................................ EI-17
Rear disc brake ................................................. BR-32
Rear door ............................................................ BL-18
Rear fog lamp ..................................................... LT-56
Rear panel finisher .............................................. EI-31
Rear seat ........................................................... SE-31
Rear seat belt ...................................................... SB-4
Rear side window ............................................. GW-13
Rear suspension ............................................... RSU-5
Rear washer .................................................... WW-14
Rear window defogger ...................................... GW-17
Rear wiper ....................................................... WW-14
Refrigerant connection precaution ..................... ATC-5
Refrigerant discharging evacuating charging ATC-141
Refrigerant general precaution .......................... ATC-5
Refrigerant lines ............................................. ATC-141
Refrigerant pressure sensor EC-451, EC-843, ATC-18,
ATC-94
, ATC-157
Refrigeration cycle ........................................... ATC-18
Release bearing (clutch) .................................... CL-12
Removal and installation (A/T) ......................... AT-413
Removal and installation (Transfer) ................... TF-55
Reverse idler shaft (M/T) ...................... MT-20, MT-25
Reverse lamp switch (M/T) - See Back-up lamp switch
(M/T) .................................................................. MT-13
Reverse main gear (M/T) ...................... MT-20, MT-25
Rocker cover(QR20DEQR25DE) .................... EM-42
Rocker cover(YD22DDTi) ............................... EM-168
Room lamp ......................................................... LT-76
Room lamp - See Interior lamp ........................... LT-76
ROOM/L - Wiring diagram .................................. LT-76
RP/SEN - Wiring diagram .................. EC-452, EC-844
RRO2 - Wiring diagram ..................... EC-777, EC-793
S
S/LOCK - Wiring diagram ....................... BL-24
, BL-45
S/SIG - Wiring diagram .................. EC-1199, EC-1496
SCTC/V - Wiring diagram ............. EC-1095, EC-1129,
EC-1136
, EC-1141, EC-1146, EC-1384, EC-1418,
EC-1424
, EC-1429, EC-1434
SEAT - Wiring diagram ...................................... SE-11
Seat belt inspection .......................................... MA-45
Seat belt pre-tensioner disposal ..................... SRS-42
Seat belt, front ..................................................... SB-3
Seat belt, rear ...................................................... SB-4
Seat, front .......................................................... SE-24
Seat, rear ........................................................... SE-31
Self-diagnosis (Transfer) ................................... TF-30
SEN/PW - Wiring diagram ................. EC-369, EC-721
Sheft warning system ...................................... BL-104
SHIFT - Wiring diagram ................................... AT-399
Shift control components (M/T) ............. MT-22, MT-27
Shift fork (M/T) ...................................... MT-22, MT-27
Shift lever ........................................................... MT-14
Shift lock system .............................................. AT-398
Shift schedule .................................................. AT-530
Shift solenoid valve A (A/T) ............................. AT-128
Shift solenoid valve B (A/T) ............................. AT-128
Side air bag (satellite) sensor ......................... SRS-39
Side window - See Rear side window ............... GW-13
Spark plug replacement(QR20DEQR25DE) ... MA-26
Spark plug(QR20DEQR25DE) ........................ EM-30
Specification value ............................. EC-119, EC-566
Speedometer ........................................................ DI-4
Spiral cable ..................................................... SRS-33