2003 MITSUBISHI SPYDER Service Repair Manual

AC101825
FRONT WIRING
HARNESS (RH)
AB
INJECTOR WIRING
HARNESSINSTRUMENT PANEL
WIRING HARNESSROOF WIRING
HARNESS
LIFTGATE WIRING
HARNESS
REAR BUMPER
WIRING HARNESS
FLOOR WIRING
HARNESS
FUEL WIRING
HARNESS
DOOR WIRING
HARNESS*
FRONT WIRING
HARNESS (LH) CONTROL WIRING
HARNESS BATTERY WIRING
HARNESS

AC101824
FRONT WIRING
HARNESS (RH)
AB
INJECTOR WIRING
HARNESSINSTRUMENT PANEL
WIRING HARNESSROOF WIRING
HARNESSTRUNK LID
WIRING HARNESS
REAR
BUMPER
WIRING
HARNESS
FLOOR WIRING
HARNESS
FUEL WIRING
HARNESS
DOOR WIRING
HARNESS*
FRONT WIRING
HARNESS (LH) CONTROL WIRING
HARNESS BATTERY WIRING
HARNESS

AC003056
Denotes connector No.
The same connector No. is used throughout the circuit diagrams to facilitate connector location searches.
The first alphabetical symbol indicates the location site of the connector and a number that follows is the unique number.
Numbers are usually assigned to parts in clockwise order on the diagram.
Example: A-19
Number specific to connector (serial number)
Connector location site symbol
A: ENGINE COMPARTMENT
B: ENGINE AND TRANSAXLE
C: DASH PANEL
D: FLOOR AND ROOF
D: FLOOR AND WINDSHIELD APERTURE
E: DOOR
F: LUGGAGE COMPARTMENT
Denotes ground point.
Same ground number is used throughout circuit
diagrams to facilitate search of ground point.
Refer to GROUP 70 SINGLE PART INSTALLATION
POSITION - GROUND MOUNTING LOCATIONS
for details of ground points.
Denotes the color of the corrugated
tube (If not specified, it is black.)
R: Red
Y: Yellow
The number of connector pins and the connector color
(except milk white)* are shown for ease of retrieval.
Example: (2-B)
Connector color
(milk white if no color is indicated)
Number of connector pins
*: Typical connector colors
B: Black BR: Brown
Y: Yellow V: Violet
L: Blue O: Orange
G: Green GR: Gray
R: Red NONE: Milk white
A-15 (2) FOG LIGHT (RH)
A-16 (2-GR) HORN (LOW)
A-17 (2-B) HEADLIGHT (RH)
A-18 (2-B) WINDSHIELD WASHER MOTOR
A-19 (2-GR) DUAL PRESSURE SWITCH
Indicates the device to which the
connector is connected.
The mark shows the
standard mounting position
of wiring harness.
AE
A-17
A-16
A-15 A-18 A-19
YDenotes a section covered by a
corrugated tube.
FRONT
WIRING
HARNESS
(RH)
Denotes harness name.