2003 Mercury Mountaineer engine

[x] Cancel search: engine

Page 224 of 264

Mercury Mountaineer 2003  Owners Manuals When this occurs the vehicle will still operate. However:
•The engine power will be limited.
•The air conditioning system will be disabled.
Continued operation will increase the engine temperature

Page 226 of 264

Mercury Mountaineer 2003  Owners Manuals •Avoid getting fuel liquid in your eyes. If fuel is splashed in the eyes,
remove contact lenses (if worn), flush with water for 15 minutes and
seek medical attention. Failure to seek proper medical

Page 227 of 264

Mercury Mountaineer 2003  Owners Manuals Flexible fuel components and standard unleaded gasoline fuel
components are not interchangeable. If your vehicle is not
serviced in accordance with flexible fuel vehicles procedures, damage
may occur

Page 228 of 264

Mercury Mountaineer 2003  Owners Manuals Octane recommendations
Do not be concerned if your engine
sometimes knocks lightly. However,
if it knocks heavily under most
driving conditions while you are
using fuel with the recommended
octane rat

Page 229 of 264

Mercury Mountaineer 2003  Owners Manuals in the United States) because it may cause these problems to become
more pronounced. If the problems persist, see your dealer or a qualified
service technician.
FFV engine (if equipped)
Your FFV will

Page 230 of 264

Mercury Mountaineer 2003  Owners Manuals 4. To install the cap, align the tabs on the cap with the notches on the
filler pipe.
5. Turn the filler cap clockwise 1/8 of a turn until it stops.
If the“Check Fuel Cap”indicator comes on and st

Page 231 of 264

Mercury Mountaineer 2003  Owners Manuals Filling the tank
The advertised fuel capacity of the fuel tank on your vehicle is equal to
the rated refill capacity of the fuel tank as listed in theRefill capacities
section of this chapter.
The adv

Page 232 of 264

Mercury Mountaineer 2003  Owners Manuals 3. After at least three to five tank fill-ups, fill the fuel tank and record
the current odometer reading.
4. Subtract your initial odometer reading from the current odometer
reading.
5. Follow one of