Page 23 of 376
23 At a glance
Center console
Center console
Upper part
Item
Page
1
Central locking switch
92
2
Hazard warning flasher 
on/off switch
105
3
Central unlocking switch
92
4
Center and side air vent 
adjustment
147
5
COMAND system, see 
separate operating in-
structions
113
6
Automatic climate control
149
7
Right cup holder
190
8
KEYLESS-GO* start/stop 
button
30
9
Ashtray
Cigarette lighter
196
197
10
Left cup holder
190 
     
        
        Page 30 of 376

30 Getting startedUnlockingUnlocking with KEYLESS-GO*
The functions of the KEYLESS-GO card are 
nearly identical to those of the key, except 
that it cannot be used to open the retract-
able hardtop. When using the key and the 
card at the same time, the key overrules 
the card.
Grasp the door handle.
The turn signal lamps blink once. The 
locking knobs on the doors move up.Pressing the KEYLESS-GO start/stop but-
ton on the selector lever corresponds to 
turning the key to the various starter 
switch positions.
1KEYLESS-GO start/stop button
Before you press the KEYLESS-GO 
start/stop button, the vehicle’s on-board 
electronics have the status0 (as with key 
removed).
Make sure the gear selector lever is set 
toP.
Do not depress the brake pedal.
iThe KEYLESS-GO card must be outside 
the vehicle to unlock it.
Warning!
G
When leaving the vehicle, always take the 
key and the KEYLESS-GO card with you, and 
lock the vehicle. Do not leave children unat-
tended in the vehicle, or with access to an 
unlocked vehicle. Unsupervised use of vehi-
cle equipment may cause an accident 
and/or serious personal injury.iThe SBC brake system is activated. 
     
        
        Page 31 of 376
31 Getting started
Unlocking
Position 1
Press the KEYLESS-GO start/stop but-
ton once.
Power supply for some electrical con-
sumers, such as seat adjustment.Ignition (or Position 2)
Press the KEYLESS-GO start/stop but-
ton twice.
Power supply for all electrical consum-
ers. All the lights in the instrument 
cluster light up.
More information can be found in the 
“Controls in detail” section (
page 84). 
For information on starting the engine us-
ing the KEYLESS-GO start/stop button, 
see Starting with KEYLESS-GO 
(
page 40).
iIf you now press the KEYLESS-GO 
start/stop button twice, the power 
supply is again switched off.
iIf you now press the KEYLESS-GO 
start/stop button once, the power sup-
ply is again switched off. 
     
        
        Page 33 of 376

33 Getting started
Adjusting
The seat adjustment switch is located in 
the door.
1Seat fore and aft adjustment
2Seat height
3Seat cushion tilt
4Backrest tilt
5Seat cushion depth
6Head restraint height
Switch on the ignition by turning the 
key in the starter switch to position2 
or pressing the KEYLESS GO* 
start/stop button twice.Seat fore and aft adjustment 
Press the switch forward or backward 
in the direction of arrow1. 
Seat height 
Press the switch up or down in the di-
rection of arrow2. 
Seat cushion tilt
Press the switch up or down in the di-
rection of arrow3 until your upper legs 
are lightly supported.
Backrest tilt
Press the switch forward or back in the 
direction of arrow4.Seat cushion depth
Press the switch forward or back in the 
direction of arrow5.
Head restraint height
Press the switch up or down in the di-
rection of arrow6.
!When moving the seat, be sure that 
nothing is in the auxiliary cup holder 
and that there are no items in the foot-
well or behind the seats. Otherwise the 
seats could be damaged. 
Warning!
G
For your protection, drive only with properly 
positioned head restraints.
Adjust head restraint to support the back of 
the head approximately at ear level.
Do not drive the vehicle without the seat 
head restraints. Head restraints are intend-
ed to help reduce injuries during an acci-
dent. 
     
        
        Page 40 of 376
40 Getting startedDrivingStarting with the SmartKey
Turn the key in the starter switch to 
position3 and hold until the engine 
starts (
page 29).
Depress the brake pedal. 
The selector lever lock is released.
For information on turning off the engine 
with the key, see “Turning off engine with 
the key” (
page 48).Starting with KEYLESS-GO*
You can start your vehicle without a key 
using the KEYLESS-GO start/stop button 
on the gear selector lever.
1KEYLESS-GO start/stop button
Depress the brake pedal during the 
starting procedure. Do not depress ac-
celerator.
The selector lever lock is released.
Press the KEYLESS-GO start/stop 
button1 once.
The engine starts automatically.
For information on turning off the engine 
with KEYLESS-GO, see “Turning off engine 
with KEYLESS-GO*” (
page 49).
iYou can also use the “touch-start” 
function. Turn the key to position3 and 
release it again immediately. The en-
gine then starts automatically. 
     
        
        Page 47 of 376

47 Getting started
Parking and locking
Parking and locking
You have now completed your first drive. 
You have properly stopped and parked 
your vehicle. End your drive as follows:
Parking brake
1Parking brake
2Release handle
Step firmly on the parking brake1.
When the engine is running, the indica-
tor lamp 
; 
(USA only) or 
3 
(Can-
ada only) in the speedometer dial will 
be illuminated
Warning!
G
Wait until the vehicle is stationary before re-
moving the key from the starter switch. The 
vehicle cannot be steered when the key is 
removed.Warning!
G
With the engine not running, there is no 
power assistance for the steering system. In 
this case, it is important to keep in mind that 
a considerably higher degree of effort is nec-
essary to steer the vehicle.
Warning!
G
Do not park this vehicle in areas where com-
bustible materials such as grass, hay or 
leaves can come into contact with the hot 
exhaust system, as these materials could be 
ignited and cause a vehicle fire.
To reduce the risk of personal injury as a re-
sult of vehicle movement, before
 turning off 
the engine and leaving the vehicle always:
Keep right foot on brake pedal.
Firmly depress parking brake pedal.
Move the selector lever to positionP.
Slowly release brake pedal.
When parked on an incline, turn front 
wheel against road curb.
Turn the key to starter switch position0 
and remove, or press start / stop button 
(vehicles with KEYLESS-GO
*).
Take the key and the KEYLESS-GO
* 
card (vehicles with KEYLESS-GO
*) and 
lock vehicle when leaving. 
     
        
        Page 49 of 376

49 Getting started
Parking and locking
After exiting the vehicle, press the lock 
button 
‹
 on the remote control 
(
page 28).
The locking knobs on the doors move 
down.
More information can be found in the 
“Controls in detail” section (
page 80).
Turning off engine with KEYLESS-GO* 
Place the gear selector lever inP.
Press the KEYLESS-GO start/stop but-
ton until the engine shuts off.
With the driver's door closed, the start-
er switch is now in the position1. With 
the driver's door opened, the starter 
switch is set to position0, same as key 
removed from starter switch 
(page 29). 
Press the seat belt release button 
(page 37).
!If you hear a warning signal you have ei-
ther
forgotten to turn off the lights, or
not put the gear selector lever inP 
before opening the driver’s door.
Turn off the lights or place the gear se-
lector lever inP.
Warning!
G
To prevent possible personal injury, always 
keep hands and fingers away from the door 
openings when closing the doors. Be espe-
cially careful when small children are 
around.
Before closing doors, make sure that there 
is no possibility of someone getting caught 
in a door during closing.
!If you hear a warning signal you have ei-
ther
forgotten to turn off the lights, or
not put the gear selector lever inP 
before opening the driver’s door.
Turn off the lights or place the gear se-
lector lever inP.
Warning!
G
To prevent possible personal injury, always 
keep hands and fingers away from the door 
openings when closing the doors. Be espe-
cially careful when small children are 
around.
Before closing doors, make sure that there 
is no possibility of someone getting caught 
in a door during closing. 
     
        
        Page 50 of 376
50 Getting startedParking and locking1Lock button on the door handle
After exiting the vehicle, press the lock 
button1 on the door handle.
The locking knobs on the doors move 
down.
More information can be found in the 
“Controls in detail” section (
page 80).
Emergency engine shut-down
If the engine cannot be turned off as de-
scribed, you may use the following backup 
procedure.
Open the main fuse box (
page 329).
Pull out the two fuses labeled “ENGINE 
EMERGENCY STOP” (
page 329).
Warning!
G
When leaving the vehicle, always remove the 
key from the starter switch, take the 
KEYLESS-GO
* card (if so equipped) with 
you, and lock your vehicle. Do not leave chil-
dren unattended in the vehicle, or with ac-
cess to an unlocked vehicle. Unsupervised 
use of vehicle equipment may cause an ac-
cident and/or serious personal injury.