Page 142 of 321
142 Controls in detailLoadingTightening partition netInstallation behind the front seats1Tie-down hook
2Ring
Installation behind the rear seats1Tie-down hook
2Ring
3Tensioner
Insert tie-down hook1 in rings2.
Pull on loose ends of tie-down straps
until net is tight.
After driving a short distance, check
the tension on the net and retighten if
necessary.Removing partition net
Lift tensioner3 upward to a horizontal
position to release tensioning of the
strap.
Disengage tie-down hooks1 from
rings2.
Remove mounting hooks2
(page 141) from holder1
(page 141).
Roll up and close the partition net.
Store partition net behind rear seat
bench.
iBefore tightening the partition net, re-
move the cargo floor plates.
Page 143 of 321
143 Controls in detail
Loading
Cargo area cover blind*
1Handle
2Holder
Closing blind
Pull blind on handle1 across the cargo
area.
Guide blind into holders2.Opening blind
Disengage blind and guide retraction
by its handle.
Removing blind
3Button
4Mounting sleeve
Roll the blind up.
Push mounting sleeve4 inward against
spring pressure until it engages.
Remove blind from mounts.Installing blind
Place left side of blind in left mount.
Position right side of blind over right
mount.
Push button3, releasing mounting
sleeve to slide into mount.
Warning!
G
Passenger use of third row seats with cargo
area cover blind installed is restricted.
Page 144 of 321
144 Controls in detailLoadingCargo floor plates
Removing cargo floor plates
Lift cargo floor plate at rear edge (ar-
row).
Cargo floor plate unhinges automati-
cally.
Remove cargo floor plate by pulling it
rearwards.Storing cargo floor plates
1Hook and loop strip
Fold the left cargo floor plate together.
Open the hook and loop strip at the
bottom of backrest of the third row
seats* and insert cargo floor plate.
Close the hook and loop strip. Installing cargo floor plates
1Opening
2Pins
3Attachment opening
4Latch
Grip into opening1 and guide pins2
into attachment opening3.
The center pin must snap into place in
latch4.
iBefore you can remove the cargo floor
plates, it is possible that the third row
seats* (
page 96) must be removed.