Page 295 of 370

301 Practical hints
Flat tire
Wheel cover on vehicles with steel rims
(Canada only)
On wheel to be changed, remove wheel
cover by reaching into two openings of
the wheel cover and pulling away from
the wheel.
On whee l to b e change d, loos en b ut do
not yet remove the wheel bolts (ap-
proximately one full turn with wrench). The jack take-up brackets are located di-
rectly behind the front wheel housings and
in front of the rear wheel housings.
Place jack on firm ground.
Position jack1 under the take-up
bracket2 so that it is always vertical
(plumb-line) as seen from the side,
even if the vehicle is parked on an in-
cline.
Jack up the vehicle until the wheel is a
maximum of 1.2 in (3 cm) from the
ground. Never start engine while vehi-
cle is raised.
always vertical (plumb line) when in use, es-
pecially on hills. Always try to use the jack
on level surface. Make sure that the jack
arm is fully seated in the jack take-up brack-
et. Always lower the vehicle onto sufficient
capacity jackstands before working under
the vehicle.
S203 MY03_A.book Page 301 Tuesday, January 28, 2003 2:22 PM
Page 296 of 370
302 Practical hintsFlat tireRemoving the wheel
1Alignment bolt
Unscrew upper-most wheel bolt and re-
move.
Replace this wheel bolt with the align-
ment bolt1 supplied in the tool kit.
Remove the remaining bolts.
Remove the wheel.Mounting the new wheel
1Wheel bolt for light alloy rims
2Wheel bolt for Minispare wheel or other
steel rims
Clean contact surfaces of wheel and
wheel hub.
Guide the spare wheel onto the align-
ment bolt and push it on.
Insert wheel bolts and tighten them
slightly.
!Do not place wheel bolts in sand or dirt.
This could result in damage to the bolt
and wheel hub threads.
!Wheel bolts2 must be used when
mounting steel rims or the Minispare
wheel. The use of any wheel bolts other
than wheel bolts2 for steel wheel rims
or Minispare wheel can cause physical
damage to the vehicle.!To avoid paint damage, place wheel flat
against hub and hold it there while in-
stalling first wheel bolt.
S203 MY03_A.book Page 302 Tuesday, January 28, 2003 2:22 PM
Page 297 of 370

303 Practical hints
Flat tire
Unscrew the alignment bolt, install last
wheel bolt and tighten slightly.Minispare wheel
In the case of a flat tire, you may tempo-
rarily use the Minispare wheel when ob-
serving the following restrictions:
Do not exceed a vehicle speed of
50 mph (80km/h).
Drive to the nearest tire repair facility
to have the flat tire repaired or re-
placed as appropriate.
Do not operate vehicle with more than
one spare wheel mounted.
Warning!
G
Always replace wheel bolts that are dam-
aged or rusted.
Never apply oil or grease to wheel bolts.
Damaged wheel hub threads should be re-
paired immediately. Do not continue to drive
under these circumstances! Contact an au-
thorized Mercedes-Benz Center or call
Roadside Assistance.
Incorrect mounting bolts or improperly
tightened mounting bolts can cause the
wheel to come off. This could cause an acci-
dent. Be sure to use the correct mounting
bolts.
Warning!
G
Use only genuine equipment
Mercedes-Benz wheel bolts. They are identi-
fied by the Mercedes star. Other wheel bolts
may come loose.
Do not tighten the wheel bolts when the ve-
hicle is raised. Otherwise the vehicle could
tip over.
Warning!
G
The dimensions of the Minispare wheel are
different from those of the road wheels. As
a result, the vehicle handling characteristics
change when driving with a Minispare wheel
mounted.
The spare wheel should only be used tempo-
rarily, and replaced with a regular road
wheel as quick as possible.
S203 MY03_A.book Page 303 Tuesday, January 28, 2003 2:22 PM
Page 298 of 370

304 Practical hintsFlat tireLowering the vehicle
Lower vehicle by turning crank coun-
terclockwise until vehicle is resting ful-
ly on its own weight.
Remove the jack.
1-5 Wheel bolts
Tighten the five wheel bolts evenly, fol-
lowing the diagonal sequence illustrat-
ed (1 to5), until all bolts are tight.
Observe a tightening torque of 80 ft lb
(110 Nm).
Before storing the jack in the cargo
compartment, it should be fully col-
lapsed, with handle folded in.
Wheel cover on vehicles with steel rims
(Canada only)
Position small wheel cover opening
over tire valve and press wheel cover
against wheel rim.
Now press (do not hit) opposite side of
wheel cover against wheel rim until
seated.
Make certain that the springs of the
wheel cover are firmly seated in the
outer rim of the steel wheel.
Warning!
G
Have the tightening torque checked after
changing a wheel. The wheels could come
loose if they are not tightened to a torque of
80 ft lb (110 Nm).
S203 MY03_A.book Page 304 Tuesday, January 28, 2003 2:22 PM
Page 317 of 370

323 Technical data
Rims and Tires
Rims and Tires
Use only tires and rims which have been
specifically developed for your vehicle and
tested and approved by Mercedes-Benz.
Other tires and rims can have detrimental
effects, such as
poor handling characteristics
increased noise
increased fuel consumption
Same size tires
!Moreover, tires and rims not approved
by Mercedes-Benz may, under load, ex-
hibit dimensional variations and differ-
ent tire deformation characteristics
under load that could cause them to
come into contact with the vehicle
body or axle parts. Damage to the tires
or the vehicle may be the result.
iFurther information on tires and rims is
available at any authorized
Mercedes-Benz Center. A tire inflation
pressure table is located on the fuel fill-
er cap of the vehicle. The tire pressure
should be checked regularly and
should only be adjusted on cold tires.
Follow tire manufacturer’s mainte-
nance recommendation included with
vehicle.
C 240
C 320
C 240 4MATIC
C 320 4MATIC
Rims (light alloy*)
7J x16 H2
7J x16 H2
Rims (steel – Canada only)
7J x16 H2
Wheel offset
1.46 in (37 mm)
1.46 in (37 mm)
All season tires (radial-ply tires)
205/55 R16 91 H
205/55 R16 91 H
Winter tires (radial-ply tires)
205/55 R16 91 H M+S
205/55 R16 91 H M+S
S203 MY03_A.book Page 323 Tuesday, January 28, 2003 2:22 PM
Page 332 of 370

338 Technical dataConsumer informationTemperature
The temperature grades are A (the high-
est), B, and C, representing the tire’s resis-
tance to the generation of heat and its
ability to dissipate heat when tested under
controlled conditions on a specified indoor
laboratory test wheel. Sustained high tem-
perature can cause the material of the tire
to degenerate and reduce tire life, and ex-
cessive temperature can lead to sudden
tire failure. Grade C corresponds to a level
of performance which all passenger car
tires must meet under the Federal Motor
Vehicle Safety Standard No. 109. Grades B
and A represent higher levels of perfor-
mance on the laboratory test wheel than
the minimum required by law.
Warning!
G
The temperature grade for this tire is estab-
lished for a tire that is properly inflated and
not overloaded. Excessive speed, underin-
flation, or excessive loading, either sepa-
rately or in combination, can cause
excessive heat build-up and possible tire
failure.
S203 MY03_A.book Page 338 Tuesday, January 28, 2003 2:22 PM
Page 339 of 370

345 Index
A
ABS 23, 73, 339
ABS control 74
Malfunction indicator lamp 255
Messages in display 261
Warning lamp 255
Accelerator position, automatic
transmission 140
Accident
In case of 50
Activating
Air circulation mode 148
Air conditioning (cooling) 150, 159
Air recirculation mode 148, 156
Anti-theft alarm system 79
Automatic climate control 153
Central locking (control system) 125
Climate control 145
Defrost 147, 156
Easy-entry/exit feature 126
ESP 77
Exterior headlamps 47
Exterior lamps 99
Exterior rear view mirror parking
position 142
Hazard warning flasher 101Headlamps 47
High beams 101
Ignition 31
Immobilizer 52, 79
Rear fog lamp 99
Rear window defroster 149, 158
Residual heat 159
Seat heater 94
Tow-away alarm 80
Windshield wipers 48
Adding
Coolant 238
Engine oil 236
Additional turn signals 292
Adjustable air vents, rear passenger
compartment 151, 160
Adjusting 32
Air distribution 147, 155
Air volume 147, 155
Backrest tilt 33, 35
Exterior rear view mirror 39
Head restraint height 33, 35, 36
Head restraint tilt 34, 35, 36
Head restraints 36
Inside rear view mirror 38
Instrument cluster illumination 104Manual seat 33
Mirrors 38
Multicontour seat* 93
Power seat 34
Rear seat head restraints 35
Seat cushion depth 93
Seat cushion tilt 33, 35
Seat fore and aft adjustment 33, 34
Seat height 33, 35
Seats 32
Steering column height 38
Steering column length 38
Steering wheel 37
Air conditioning (cooling)
Turning off 150, 159
Turning on 150, 159
Air conditioning refrigerant 330
Air distribution
Adjusting 147, 155
Air pressure see Tire inflation
pressure 242
Air recirculation mode 148, 156
Activating 148, 156
Deactivating 148, 157
Air vents, rear passenger compartment
Adjustable 151, 160
S203 MY03_A.book Page 345 Tuesday, January 28, 2003 2:22 PM
Page 342 of 370

348 IndexButton
Audio system 164
C
CAC (Customer assistance center) 339
California
Important notice 11
Calling up
Range (distance to empty) 130
Service indicator 247
CAN system 339
Capacities
Fuels, coolants, lubricants, etc. 328
Cargo area see Cargo compartment 87
Cargo compartment
Auxiliary fuse box 315
Lighting 103
Parcel net 196
Storage compartment inside 197
Tailgate 87
Tie-down rings 202
Cargo tie-down rings 202
Casette mode
Playing cassettes 170
Cassette player
Operating 114
Catalytic converter 230CD changer* 174
CD mode 174
CD player
Operating 113
Center console 25
AIRBAG OFF indicator lamp 259
Lower part 26
Upper part 25
Centigrade
Setting temperature units 119
Central locking
Automatic 88
From inside 89
Switch 89
Switching on/off (control
system) 125
Unlocking from inside 89
Central locking switch 89
Certification label 320
Changing
Batteries (SmartKey) 287
Key setting 126
Changing CDs 174
Charcoal filter 157
Charging
Vehicle battery 306CHECK ENGINE malfunction indicator
lamp 23, 258
Checking
Coolant level 233, 238
Oil level 233, 235
Tire inflate pressure 233
Vehicle lighting 233
Child safety 65
Airbags 58
Infant and child restraint systems 62,
65
LATCH child seat anchors 70
Child safety switch see Blocking of rear
door window operation 71
Child seat anchors see LATCH child seat
anchors 70
Cigarette lighter 208
Cleaning
Cup holder 251
Gear selector lever 251
Hard plastic trim items 252
Headlamps 143
Headliner 252
Instrument cluster 251
Leather upholstery 252
Light alloy wheels 251S203 MY03_A.book Page 348 Tuesday, January 28, 2003 2:22 PM