INSTRUMENT CLUSTER
Always check the Owner’s Manual for more operating information and safety features
GAUGES
1. Tachometer
2. Speedometer
3. Fuel gauge
15-gallon/57-liter tank (2.0 I-4),
16-gallon/61-liter tank (3.0 V6)
4. Odometer/trip odometer
selector
Press to toggle between
odometer and trip odometer
Tip: Press and hold for more
than 1 second to reset trip
odometer
5. Odometer
6. Gearshift indicator (A/T)*
7. Coolant temperature
gauge
If above normal range, stop
vehicle and turn off engine,
check coolant level when safe
WARNING LIGHTS
8. Cruise control on*
9. Coolant level low*
10. Air bag readiness
Front or side air bag malfunction,
dealer inspection required
11. Always fasten
safety belts
12. Turn signals/hazard
warning on
13. High beams on
14. 4 wheel drive
locked*, see Transmission
15. Low fuel
Refuel as soon as possible
16. Overdrive off
indicator*, see Transmission17. Brake system
Parking brake on/low brake fluid
18. Anti-theft on*
19. Engine oil pressure
warning light
20. Charging system
warning light
Dealer inspection required
21. Check fuel cap
Fuel filler cap not properly
installed
22. Door ajar
23. Anti-lock Brake
System (ABS)*
ABS malfunction, normal brakes
only, dealer inspection required
24. Service engine soon
Dealer inspection required
Instrument
Cluster
Instrument
Cluster
Quick Tips Mazda 2003 Tribute page 4
page 5
Revised September 25, 2002
1311224212
10 2020 406080mph x1000r/min
100
120
140
160
180
3040 8 7 6
5
4
3
2
15060
80
90
100
110
F
E120 70CH
723361817192120225
8
9
1011
16
15
14
4
ODO
*Denotes optional equipment
DRIVER CONTROLS
Always check the Owner’s Manual for more operating information and safety features
Turn signal/lighting
control lever
OFF= Lights off
= Tail, side marker, instrument,
license plate and parking
lights on: Rotate knob (1)
to first notch
= Tail, parking, instrument,
license plate and head-
lights on: Rotate knob
(1) to second notchHigh beams on/off: Push lever
forward to detent/pull back
to detent
To flash high beams: Pull lever
back slightly and release
Turn signals right/left: Move lever
up/down
Wiper/washer control lever
Ignition switch must be in ACC or
ON position
To activate interval wipers: Push
lever down to first detent and
rotate knob (1) to desired speed
To activate wiper normal or
low speed: Push down to
second detent
To activate high speed: Push
lever down to third detentTo activate washer: Pull
lever toward you
To activate mist: Push lever
up and release
To activate rear interval wiper:
Rotate knob (2) up to INT
To activate rear normal speed
wipe: Rotate knob (2) up to ON
To activate rear wash: Rotate
knob (2) to and release
To set speed: Press and release
SET ACC (3) at desired speed;
hold (3) to accelerate
To decelerate: Press and hold
CST (4), release at desired speed;
or tap brake pedal, press and
release (3) at desired speed
Incremental deceleration: Press and
release (4), each tap = minus 1 mphIncremental acceleration: Press and
release (3), each tap = plus 1 mph
To cancel: Tap brake/clutch*
pedal or press OFF button (5)
Return to preset speed (after
braking): Press and release RSM
button (2)
Overhead console*
1. Map/reading light switches
To turn on/off: Press
2. Map/reading light
3. Moonroof switch*
To open: Press and hold
rear of switch
To close: Press and hold
front of switch
To tilt (panel closed):
Press and hold front/rear
of switch to open/close4. Storage compartment*
To open: Press button, then
pull to full open position
5. Garage door opener
button/compartment*
See Owner’s Manual for
installation Cruise control*
Operates above 30 mph
Press and release ON (1)
Driver
Controls
Overhead
Console
Quick Tips Mazda 2003 Tribute page 6
page 7
Revised September 25, 2002
ON
OFF SET
ACC
CSTRSM1
5
2
3
4
1
21
12
321
4
4
5
*Denotes optional equipment
