2003 HONDA CIVIC Front

[x] Cancel search: Front

Page 869 of 1139

HONDA CIVIC 2003 7.G Workshop Manual Connectors and Harnesses
Connector to Harness Index (contd)
Roof Wire Harnsss
Connector or TerminalCavitiestocationConnectstoNotesMoonroofclose relayMoonrool control unitMoonroof motorMoonroot open r

Page 873 of 1139

HONDA CIVIC 2003 7.G Workshop Manual Gonnectors and Harnesses
Connector to Harness lndex {contdl
OPDS Unit Harness
Connoctor orTorminalCavitiosLocationConnectstoNotesOPDS unit21IIn front passengers seatUnder front passengers seatFloor

Page 877 of 1139

HONDA CIVIC 2003 7.G Workshop Manual Power Distribution
Fuse to Components lndex
Under-hood Fuse/Relay Box
Fuse
Number
AmpsWire ColorComponent(sl or Circuit(s) Protected
I204BLUI/ELCondenser fan motor
BLU/REDAyC compressor clutch
15AWH

Page 879 of 1139

HONDA CIVIC 2003 7.G Workshop Manual Ground Distribution
Ground to Components Index
GroundComponent or circuit qrounded
Batterv, Transmission housinq
E ngine
G 101ECM (PG is BLK; LG is BRN/YEL)
BLK: IAC valve, lgnition coils, Vehicle spe

Page 897 of 1139

HONDA CIVIC 2003 7.G Workshop Manual Gauges
9.
10.
Vehicle Speed Signal Circuit Troubleshooting (contdl
Turn the ignition switch OFF.
Connect the other test harness connector (A) to the
VSS (B),
11.Raise the front of the vehicle, and ma

Page 899 of 1139

HONDA CIVIC 2003 7.G Workshop Manual Exterior Lights
Gomponent Location Index
UNDER.HOODFUSE/RELAY BOX
\/
HEADLIGHTSReplacement, page 22 79Adjustment. page 22-78Eulb Replacement, page 22-81
HEADLIGHT RELAY 1Test, page 22-51
HEADLIGHT REL

Page 910 of 1139

HONDA CIVIC 2003 7.G Workshop Manual 5
Turn the low beams on.
Determine ifthe headlights are aimed properly.
Vertical adjustment:
Measure the height ofthe headlights (A). The lights
should reflect 52 mm (2.1 in.) below headljght
height

Page 912 of 1139

HONDA CIVIC 2003 7.G Workshop Manual Bulb Replacement
Headlight:
1. Disconnect the 3P connector (A) from the headlight.
Headlight {high/low): 60/55 W
f-rI--+lA- )/
Remove the rubber cover (B).
Pull the retaining spring (C) away from the