2003 HONDA CIVIC HYBRID ABS

If you are changing the bulb on
the driver’s side, start the engine,
turn the steering wheel all the way
to the right, and turn off the
engine. If you are changing the
bulb on the passenger’s side, turn
the steering wheel to the left.
(Driver’s side) Turn on the headlights to test the
new bulb. Insert the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place and clip the end into
the slot.
Install the rubber seal over the
back of the headlight assembly.
Make sure it is right side up; it is
marked ‘‘TOP.’’
Remove the electrical connector
f rom the bulb by pulling the
connector straight back.
Remove the rubber weather seal
by pulling on the tab.
Unclip the end of the hold-down
wire f rom its slot. Pivot it out of
the way and remove the bulb. Push the electrical connector onto
the new bulb. Make sure it is
connected securely.
Reinstall the upper part of the
windshield washer reservoir.
Install the holding clip on the stay
and lock it by pushing on the
center of clip.
3.
4. 5.
6.
7.
8.
1.
2.
CONT INUED
Replacing the Front Side Marker/
Turn Signal and Parking L ight
Bulbs
Lights
Maint enance235
BULB WEATHER SEAL
HOLD-DOWN WIRE CONNECTOR

Turn on the parking lights and
check that the new bulb is
working.
Reinstall the socket. Turn it
clockwise until it locks. Make sure
the new bulb is working.
Reinstall the socket back in place
by pushing it in until it latches.
Open the trunk.
Remove the socket f rom the light
assembly by squeezing the tabs on
both sides of the socket.
Pull the bulb straight out of its
socket. Push the new bulb in until
it bottoms in the socket.
2. 1.
3.
4.
5.
3.
Replacing a Rear License Plate
Bulb
Lights
Maint enance239

Although the ceiling light and
spotlights come apart the same way,
theydonotusethesametypeof
bulbs.Removethelensbycarefully
prying on the edge of the lens with
a f ingernail f ile or a small f lat-tip
screwdriver. Do not pry on the
edge of the housing around the
lens. Ceiling light:Pry on the side edge of the lens in
the middle. Remove the bulb by pulling it
straight out of its metal tabs.
Push the new bulb into the metal
tabs. Snap the lens back in place.
2.
3.
1.
CONT INUED
Replacing Bulbs in the Interior
Lights
Lights
Maint enance241
CEILING LIGHT

Two f actors normally contribute to
causing corrosion in your car:Moisture trapped in body cavities.
Dirtandroadsaltthatcollectsin
hollows on the underside of the
car stays damp, promoting
corrosion in that area.
Removal of paint and protective
coatings f rom the exterior and
underside of the car. Many corrosion-preventive measures
are built into your Honda. You can
help keep your car f rom corroding
by perf orming some simple periodic
maintenance:
Repair chips and scratches in the
paint as soon as you discover them.
Inspect and clean out the drain
holes in the bottom of the doors
and body.
Check the f loor coverings f or
dampness. Carpeting and f loor
mats may remain damp f or a long
time, especially in winter. This
dampness can eventually cause
the f loor panels to corrode. Use a high-pressure spray to clean
the underside of your car. This is
especially important in areas that
useroadsaltinwinter.Itisalsoa
good idea in humid climates and
areas subject to salt air. Cars
equipped with ABS have a sensor
and wiring at each wheel. Be
caref ul not to damage them.
Have the corrosion-preventive
coatings on the underside of your
car inspected and repaired
periodically.
1.
2.
Corrosion Prot ect ion
Appearance Care252

Î
ÎSlow down by shif ting to a lower
gear, and pull to the side of the road
when it is saf e. Because of the
longer distance needed to stop, it is
hazardous to drive the car. You
should have it towed, and repaired as
soon as possible. (See on page .)
If you must drive the car a short
distance in this condition, drive
slowly and cautiously.
If it comes on at any other time, it
indicates a problem with the car’s
brake system. In most cases, the
problem is a low f luid level in the
brake f luid reservoir. Press lightly on
the brake pedal to see if it f eels
normal. If it does, check the brake
f luid level the next time you stop at a
service station (see page ). If the
fluid level is low, take the car to your
dealer and have the brake system
inspected f or leaks or worn brake
pads.
However, if the brake pedal does not
f eel normal, you should take
immediate action. Because of the
brake system’s dual-circuit design, a
problem in one part of the system
will still give you braking at two
wheels. You will f eel the brake pedal
go down much f arther bef ore the car
begins to slow down, and you will
have to press harder on the pedal.
The distance needed to stop will be
much longer.
The Brake System Indicator
normallycomesonwhenyouturn
the ignition switch ON (II). It is a
reminder to check the parking brake.
It comes on and stays lit if you do not
f ully release the parking brake.
If the ABS indicator comes on with
this indicator, have the vehicle
inspected by your Honda dealer
immediately.
209
282
On models equipped with ABS
Emergency
Towing
Brake System Indicator
T aking Care of t he Unexpect ed275
BRAKE SYSTEM INDICATOR
U.S. indicator shown

All the electrical circuits in your car
have fuses to protect them from a
short circuit or overload. These
f uses are located in three f use boxes.The under-hood f use box is located
in the engine compartment on the
driver’s side. To open it, push the
tabs as shown.The secondary f use box is located in
the engine compartment. To open it,
pushthetabsasshown.
Fuses
T aking Care of t he Unexpect ed276
TAB
TAB
UNDER-HOOD FUSE BOX
SECONDARY FUSE BOX

µµ
No.Circuits Protected
Amps.
Circuits Protected
Amps.
No.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20 Condenser Fan
IMA
Small Light
Cooling Fan
Hazard
FI ECU
Horn, Stop
ABS F/S
Back Up
ABS Motor
Rear Defroster
Heater Motor
Power Window
Option
Lef t Headlight
Door Lock
Right Headlight
EPS
Battery
Ignition 1
Spare Fuses
20 A
10 A
10 A
20 A
10 A
15 A
15 A
20 A
10 A
40 A
30 A
40 A
40 A
40 A
15 A
20 A
15 A
60 A
80 A
50 A
Cooling Fan
20 A1
21 257.5A 30A
T aking Care of t he Unexpect ed
Fuses
280
UNDER-HOOD AND SECONDARY FUSE BOXES

µµ
Î Î
Î
Î
Î
No. Amps. No.
Circuits Protected Amps. Circuits Protected
1
2
3
4
5
15 A
20 A
(10 A) 10 A 6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
Ignition Coil IN
LAF Heater
(Daytime running lights )
FI-ECU
Not Used 7.5 A
7.5 A
15 A
7.5 A
7.5 A
(7.5 A) 10 A
10 A
(10 A) 7.5 A 15 A
15 A
7.5 A 20 A
7.5 A 20 A
20 A
20 A
20 A
7.5 A Power Window Relay
Not Used
Accessory, Radio
Ignition Coil EX
Meter
ABS
(Daytime running lights )
SRS
Remote Control Mirrors
(SCTY )
IMA
Fuel Pump
Accessory Power Socket
Turn Signal Lights
Front Wiper
STS (Steering Switch)
Front Right Power Window
Front Left Power Window
Rear Lef t Power Window
Rear Right Power Window
Cooling Fan Relay
1 : On Canadian models
2 : Optional Security System
1
2
Fuses
T aking Care of t he Unexpect ed281
INTERIOR FUSE BOX