2003 HONDA CIVIC HATCHBACK Owners Manual

The rotating switch on the lef t lever
controls the lights. Turning this
switch to the ‘‘ ’’ position turns
on the parking lights, taillights,
instrument panel lights, side-marker
lights, and rear license plate lights.
Turning the switch to the ‘‘ ’’
position turns on the headlights.If you leave the lights on with the
ignition switch in ACCESSORY (I)
or LOCK (0), you will hear a
reminder beeper when you open the
driver’s door.
To change f rom low beams to high
beams, push the turn signal lever
f orward until you hear a click. The
blue high beam indicator will light
(see page ). To return to low
beams, pull the turn signal lever
back.59
Headlights
Controls Near the Steering Wheel
Inst rument s and Cont rols
66

To f lash the high beams, pull the
turn signal lever back lightly, then
release it. The high beams will come
on and go off.
The high beams will stay on f or as
long as you hold the lever back, no
matter what position the headlight
switch is in.The daytime running lights come on
automatically when the ignition
switch is turned to the ON (II)
position. They go out automatically
when the light switch is ON.
Theknobontheinstrumentpanel
controls the brightness of the instru-
ment panel lights. Turn the knob to
adjust the brightness.
Controls Near the Steering Wheel
Inst rument s and Cont rols
Daytime Running L ights Instrument Panel Brightness
(Canadian Model)
67

Signal a turn or lane change with this
lever. Push down on the lever to
signal a lef t turn, and up to signal a
right turn. If you push it up or down
all the way, the turn signal continues
to blink even when you release the
lever. It shuts off automatically as
you complete the turn.To signal a lane change, push lightly
on the turn signal lever in the proper
direction and hold it. The lever will
return to the center position as soon
as you release it.
The right lever controls the wind-
shield wipers and washers. The
rotary switch at the end of the lever
has f ive positions;MIST: mist
OFF: off
INT: intermittent
LO: low speed
HI: high speed
Controls Near the Steering Wheel
Inst rument s and Cont rols
T urn Signals
Windshield Wipers
68

In intermittent, the wipers operate
every f ew seconds. In low speed and
high speed, the wipers run continu-
ously.
To operate the wipers in mist mode,
push the control lever up f rom the
OFF position. The wipers run at high
speed until you release the lever.
This gives you a quick way to clear
the windshield.To clean the windshield, pull back on
the wiper control lever. The washers
spray until you release the lever.
The wipers run at low speed while
you’re pulling the lever, then
complete one more sweep of the
windshield af ter you release it.
Therotatingswitchontheright
lever controls the rear window wiper
and washer.
To turn on the rear window wiper,
rotate the switch to ‘‘ON’’. The
wiper will complete two sweeps to
clear the window, then operate every
7 seconds. When you turn the wiper
switch to the ‘‘OFF’’ position or turn
of f the ignition switch, the wiper
returns to its parked position.
CONT INUED
Controls Near the Steering Wheel
Inst rument s and Cont rols
Windshield Washers
Rear Window Wiper and Washer
69

To clean the rear window, rotate and
hold the switch one position up f rom
‘‘ON’’, or rotate and hold it one
position down f rom ‘‘OFF’’. The
washer sprays while you hold the
switch. The wiper operates while you
hold the switch, then completes two
more sweeps af ter you release it.Pushtheredbuttontoturnonthe
hazard warning lights (f our-way
flashers). This causes all four
outside turn signals and both
indicators in the instrument panel to
f lash. Use the hazard warning lights
if you need to park in a dangerous
area near heavy traffic, or if your car
is disabled.The rear window def ogger will clear
fog,frost,andthinicefromthe
window. Push the def ogger button to
turn it on and of f . The light in the
button lights to show the def ogger is
on. If you do not turn it of f , the
def ogger will shut itself of f af ter
about15minutes.Italsoshutsoff
when you turn of f the ignition. You
have to turn it on again when you
restart the car.
Rear Window Def ogger
Hazard Warning
Controls Near the Steering Wheel
Inst rument s and Cont rols
70

Make sure the rear window is clear
and you have good visibility bef ore
starting to drive.Make any steering wheel adjustment
bef ore you start driving.
To adjust the steering wheel upward
or downward:Push the lever under the steering
column all the way down.
Thedefoggerwiresontheinsideof
the rear window can be accidentally
damaged. When cleaning the glass,
always wipe side to side.
Move the steering wheel to the
desired position, making sure the
wheel points toward your chest,
not toward your f ace. Make sure
you can see the instrument panel
gauges and the indicator lights.
Push the lever up to lock the
steering wheel in that position.
Make sure you have securely
locked the steering wheel in place
by trying to move it up and down.
1.
4.
3.
2.
See page f or important saf ety
inf ormation about how to properlyposition the steering wheel. 17
Inst rument s and Cont rols
Controls Near the Steering Wheel
Steering Wheel A djustment
71
Adjusting the steering wheel
position while driving may
cause you to lose control of the
vehicle and be seriously injured
inacrash.
Adjust the steering wheel only
when the vehicle is stopped.

Youshouldhavereceivedakey
number plate with your set of keys.
You will need this key number if you
ever have to get a lost key replaced.
Keep the plate stored in a saf e place.
When replacing keys, use only
Honda-approved key blanks.The ignition switch is on the right
side of the steering column. It has
f our positions:
LOCK(0)
 ACCESSORY (I)
 ON (II)
 START (III)
Your car comes with two identicalkeys.
Your car also comes with two remote
transmitters; see page for an
explanation of the operation.
They f it all the locks on your car:
 Ignition
 Doors
Hatch 76
Inst rument s and Cont rols
Keys and Locks
Keys Ignition Switch
Remote Transmitter
72KEY
NUMBER
PLATE
MASTER
KEYS
VALET
KEY

µ
µ
µµ Use this position
only to start the engine. The switch
returns to ON (II) when you let go of
the key.
The engine will not start if the
Immobilizer System does not
recognize the key’s coding (see page ).
You will hear a reminder beeper if
you leave the key in the ignition
switch in the LOCK (0) or
ACCESSORY (I) position and open
thedriver’sdoor.Removethekeyto
turn of f the beeper.
You can insert or
remove the key only in this position.
To switch f rom ACCESSORY to
LOCK, you must push the key in
slightly as you turn it. The anti-thef t
lock will lock the steering column
when you remove the key.
If the f ront wheels are turned, the
anti-thef t lock may sometimes make
it difficult to turn the key from
LOCK to ACCESSORY. Firmly turn
the steering wheel to the lef t or to
the right as you turn the key.
This is the normal key
position when driving. All f eatures
and accessories on the vehicle are
usable. Several of the lights on the
instrument panel come on as a test
when you turn the ignition switch
f rom ACCESSORY to ON. In this position,
you can operate the audio system
and the accessory power socket. 74
ST A RT (III)
LOCK (0)
ON (II)
A CCESSORY (I)
Keys and Locks
Inst rument s and Cont rols
73
Removing the key from the
ignition switch while driving
locks the steering. This can
cause you to lose control.
Remove the key from the
ignition switch only whenparked.