2003 HONDA CIVIC COUPE dead battery

µYou can store the
f requencies of your f avorite radio
stations in the six preset buttons.
Each button will store one f requency
on the AM band, and two
f requencies on the FM band.
To store a f requency:
Select the desired band, AM or
FM. FM1 and FM2 let you store
two f requencies with each preset
button.
Pick the Preset button you want
for that station. Press the button
and hold it until you hear a beep.
Repeat steps 1 to 3 to store a total
of six stations on AM and twelve
on FM. Once a station’s f requency is stored,
simply press and release the proper
Preset button to tune to it.
The preset f requencies will be lost if
your car’s battery goes dead, is
disconnected, or the radio f use is
removed.
UsetheTUNE,SEEK,orSCAN
function to tune the radio to a
desired station.
1. 2. 3.4.
Audio System
Comf ort and Convenience Feat ures
Preset
120
SCAN INDICATOR
AM/FM BUTTON
PWR/VOL KNOB SEEK BAR PRESET BUTTONS
TUNE KNOBSCAN BUTTON
A.SEL BUTTON
ST INDICATOR
——y
y
(%y
y

You can use the instrument panel
brightness control dial to adjust the il-
lumination of the audio system (see
page ). The audio system
illuminates when the parking lights
are on, even if the radio is turned of f .
Theaudiosystemalsodisplaysthe
time. To set the time, the ignition
switch must be in ACCESSORY (I)
or ON (II), and you must wait about
f ive seconds af ter perf orming any
other operations with the system.For example:
1:06 would RESET to 1:00.
1:52 would RESET to 2:00.
Adjust the minutes by pressing and
holding the CLOCK button, then
pressing the M (Preset 5) button.
Adjust the hours by pressing and
holding the CLOCK button, then
pressing the H (Preset 4) button.
You can quickly set the time to the
nearest hour. If the displayed time is
bef ore the half hour, the clock is set
back to the previous hour by
pressing and holding the CLOCK
button, then pressing the R (Preset
6) button. If the displayed time is
af ter the half hour, the clock is set
f orward to the beginning of the next
hour.If your car’s battery is disconnected
or goes dead, the time setting will be
lost. To set the time again, f ollow the
setting procedure.
74
Audio System
Comf ort and Convenience Feat ures
A udio System L ighting
Digital Clock
123
CLOCK BUTTON
H BUTTON M BUTTON
R BUTTON
——y


y
(%y
y

µ
Repeat steps 1 to 3 to store a total
of six stations on AM and twelve
on FM.
Pick the Preset button you want
for that station. Press the button
and hold it until you hear a beep.
Select the desired band, AM or
FM. FM1 and FM2 let you store
two f requencies with each preset
button.
To store a f requency:
Once a station’s f requency is stored,
simply press and release the proper
preset button to tune to it.
The preset f requencies will be lost if
your car’s battery goes dead, is
disconnected, or the radio f use is
removed.
You can store the
f requencies of your f avorite radio
stations in the six preset buttons.
Each button will store one f requency
on the AM band, and two
f requencies on the FM band.
UsetheTUNE,SEEK,orSCAN
function to tune the radio to a
desired station.
1. 2. 3.4.
Audio System
Comf ort and Convenience Feat ures
Preset
132
SCAN
BUTTON
TUNE KNOB A.SEL
BUTTON
SCAN INDICATOR
AM/FM BUTTON
PWR/VOL KNOB SEEK BARPRESET BUTTONS
ST INDICATOR
——y
y
(%y
y

You will have to store your favorite
stations in the Preset buttons after
the system begins working. Your
original settings were lost when
power was disconnected.
If your car’s battery is disconnected
or goes dead, or the radio f use is
removed, the audio system will
disable itself . If this happens, you
will see ‘‘ ’’ in the f requency
display the next time you turn on the
system. Use the Preset buttons to
enter the f ive-digit code. If it is
entered correctly, the radio will start
playing.
If you make a mistake entering the
code, do not start over or try to
correct your mistake. Complete the
f ive-digit sequence, then enter the
correct code. You have ten tries to
enter the correct code. If you are
unsuccessful in ten attempts, you
must then leave the system on for
one hour bef ore trying again.
Youshouldhavereceivedacardthat
lists your audio system’s code
number and serial number. It is best
tostorethiscardinasafeplaceat
home. In addition, you should write
the audio system’s serial number in
this Owner’s Manual. If you should
happen to lose the card, you must
obtain the code number f rom your
Honda dealer. To do this, you will
need the system’s serial number.
Your car’s audio system will disable
itself if it is disconnected f rom
electrical power f or any reason. To
make it work again, the user must
enter a specif ic f ive-digit code in the
Preset buttons. Because there are
hundreds of number combinations
possible f rom f ive digits, making the
system work without knowing the
exact code is nearly impossible.
CONT INUED
Standard f or HX, LX and EX models in
the U.S., and LX and Si models inCanada
Audio System
Comf ort and Convenience Feat ures
Thef t Protection
149
——y
y
(%y
y

µ
If the terminals are severely cor-
roded, clean them with baking soda
and water. Then use a wrench to
loosen and remove the cables f rom
the terminals. Always disconnect the
negative ( ) cable f irst and recon-
nect it last. Clean the battery termi-
nals with a terminal cleaning tool or
wire brush. Reconnect and tighten
the cables, then coat the terminals
with grease. If you need to connect the battery to
a charger, disconnect both cables to
prevent damage to the car’s
electrical system.
If your car’s battery is disconnected
or goes dead, the audio system will
disableitself.Thenexttimeyouturn
on the radio you will see ‘‘ ’’ in
the f requency display. Use the
Preset buttons to enter the five-digit
code (see page ).149
Standard f or HX, LX and EX models in
the U.S., and LX and Si models inCanada
Battery
Maint enance225
The battery gives off explosive
hydrogen gas during normaloperation.
A spark or flame can cause the
battery to explode with enough
force to kill or seriously hurt you.
Wear protective clothing and a
face shield, or have a skilled
mechanic do the batterymaintenance. Charging the battery with the cables
connected can seriously damage your
car’s electronic controls. Detach the
battery cables bef ore connecting the
battery to a charger.
——y
y
(%yy

ÎÎ
Your car has certain ‘‘readiness
codes’’ that are part of the on-board
diagnostics f or the emissions
systems. In some states, part of the
emissions testing is to make sure
these codes are set. If they are not
set, the test cannot be completed.
If your car’s battery has been
disconnected or gone dead, these
codes are erased. It takes several
days of driving under various
conditions to set the codes again. If possible, do not take your car f or a
state emissions test until the
readiness codes are set. To check if
they are set, turn the ignition ON (II),
but do not start the engine. The
Malf unction Indicator Lamp will
come on f or 20 seconds. If it then
goes of f , the readiness codes are set.
If it blinks 5 times, the readiness
codes are not set. See State
Emissions Testing on page .
The Brake System Indicator
normallycomesonwhenyouturn
the ignition switch ON (II). It is a
reminder to check the parking brake.
It comes on and stays lit if you do not
f ully release the parking brake.
297
CONT INUED
Readiness Codes
Brake System Indicator
T aking Care of t he Unexpect ed
Malf unction Indicator L amp, Brake System Indicator
275
U.S. indicator shown
BRAKE SYSTEM INDICATOR
U.S.: HX, LX, EX Canada : LX, Si
——y
y
(%yy

CONT INUED
If the testing f acility determines that
the readiness codes are not set, you
will be requested to return at a later
date to complete the test. If you must
get the vehicle re-tested within the
next two or three days, you can
condition the vehicle for re-testing
by doing the f ollowing.Make sure the gas tank is nearly,
but not completely, f ull (around
3/4).
Make sure the vehicle has been
parked with the engine of f f or 8
hours or more.
Make sure the ambient
temperature is between 20° and
95°F. Without touching the accelerator
pedal, start the engine and let it
idle f or 20 seconds.
Keep the vehicle in Park
(automatic transmission) or
Neutral (manual transmission).
Increase the engine speed to 2,000
rpm and hold it there until the
temperature gauge rises to at least
1/4of thescale(approximately3
minutes).
If you take your car for a state
emissions test shortly af ter the
battery has been disconnected or
gone dead, it may not pass the test.
This is because of certain ‘‘readiness
codes’’ that must be set in the on-
board diagnostics f or the emissions
systems. These codes are erased
when the battery is disconnected,
and set again only after several days
of driving under a variety of
conditions.
T echnical Inf ormation
St at e Emissions T est ing
T esting of Readiness Codes
297
——y

y
(%yy

Î
CONT INUED
................................
Maintenance . 47
......
Reminder Light and Beeper . 64
...................
System Components . 45
...............
Use During Pregnancy . 19
...
Wearing a Lap/Shoulder Belt . 16
........................
Seats, Adjusting the . 90
...............................
Serial Number . 286
...........................
Service Intervals . 192
...........................
Service Manual . 309
.........
Service Station Procedures . 157
..................
Setting the Clock . 123, 135
.....
Shif t Lever Position Indicator . 174
........................
Shif t Lock Release . 178
..............................
Side Airbags . 10, 51
....................
Cutof f Indicator . 53, 64
Side Marker Lights, Bulb .................
Replacement in . 242, 244
...............................
Signaling Turns . 75
.....................................
Snow Tires . 237
...................
Solvent-type Cleaners . 250
........................
Sound System . 118, 130
Spare Tire
......................................
Inf lating . 258
............................
Specif ications . 289
................
Spark Plugs, Replacing . 221
....................
Specif ications Charts . 288 ................................
Speed Control . 151
...................................
Speedometer . 69
.......................................
Spotlights . 106
..........
SRS, Additional Inf ormation . 49
...
Additional Safety Precautions . 54
.............................
Airbag Service . 54
How the Passenger Airbag
CutoffIndicator Light ...................................
Works . 53
How the SRS Indicator .......................................
Works . 52
How Your Front Airbags .........................................
Work . 49
...
How Your Side Airbags Work . 51
........................
SRS Components . 49
.............................
SRS Indicator . 52, 64
....
START (Ignition Key Position) . 83
........
Testing of Readiness Codes . 297
.......................
Starting the Engine . 171
In Cold Weather at High ..................................
Altitude . 171
................
With a Dead Battery . 267
..............
State Emissions Testing . 297
........
Steam Coming f rom Engine . 269
Steering Wheel
..................................
Adjustment . 79 .............
Anti-theft Column Lock . 82
...........
Stereo Sound System . 118, 130
...........................
Storing Your Car . 248
Supplemental Restraint
................................
System . 10, 49
......................................
Servicing . 54
.........................
SRS Indicator . 52, 64
...................
System Components . 49
..................................
Synthetic Oil . 204
.....................................
Tachometer . 69
Taillights, Changing
......................................
Bulbs in . 242
.
Taking Care of the Unexpected . 257
...........................
Tape Player . 124, 145
Technical Descriptions
......
DOT Tire Quality Grading . 290
.....
Emissions Control Systems . 294
.....................
Oxygenated Fuels . 292
Three Way Catalytic
...............................
Converter . 296
.......................
Temperature Gauge . 71
Index
T
VII
——y
y
(%y
y