2003 FORD MUSTANG Door

REMOVAL AND INSTALLATION
Window Glass —
Door
Removal 1. Remove the door trim panel. For additional information, refer to Section 501 - 05 .
2. Remove the interior weatherstrip.
3. Remove the bolts and the stabilizers.
4. Remove the bolts and the upstop brackets.
5. Remove the rivet and the exterior weatherstrip.
SECTION 501-
11: Glass, Frames and Mechanisms 2003 Mustang Workshop Manual Klj . 1 ba
22003 Mustang Workshop Manual
18. 11. 2011file:///C:/Ford/2000 - 2004/tsocache/SHEF_5108/S3B~us~en~ ...

6. Remove the rivets.
7. Tip the front of the glass down to clear the door filler and remove the door window glass.
Installation 1. To install, reverse the removal procedure. Klj . 2 ba
22003 Mustang Workshop Manual
18. 11. 2011file:///C:/Ford/2000 - 2004/tsocache/SHEF_5108/S3B~us~en~ ...

REMOVAL AND INSTALLATION
Motor —
Window Regulator
Removal 1. Remove the door trim panel. For additional information, refer to Section 501 - 05 .
2. Remove the screws and the speaker.
3. Disconnect the electrical connector.
4. Remove the screws and the window regulator motor.
Installation 1. To install, reverse the removal procedure.
SECTION 501-
11: Glass, Frames and Mechanisms 2003 Mustang Workshop Manual Klj . 1 ba
22003 Mustang Workshop Manual
18. 11. 2011file:///C:/Ford/2000 - 2004/tsocache/SHEF_5108/S3B~us~en~ ...

REMOVAL AND INSTALLATION
Window Regulator —
Power
Removal 1. Remove the door window glass. For additional information, refer to Window Glass — Door in this
section.
2. Disconnect the electrical connector.
3. Remove the channel.
4. Remove the regulator.
Installation 1. To install, reverse the removal procedure. SECTION 501-
11: Glass, Frames and Mechanisms 2003 Mustang Workshop Manual Klj . 1 ba
22003 Mustang Workshop Manual
18. 11. 2011file:///C:/Ford/2000 - 2004/tsocache/SHEF_5108/S3B~us~en~ ...

10.
CAUTION: Open a window to prevent the windshield glass from being pushed out
by air pressure when a door is closed.
Using the alignment marks install the windshield glass.
11. After the glass is set, check for water leaks and add urethane adhesive where needed.
12. Install the cowl grille.
13. Install the cowl grille weatherstrip.
14. Install the two windshield wiper pivot arms. zPosition the arms.
z Install the windshield wiper pivot arms.
15. Install the headliner.
Coupe 16. Install the sun visors and clips. Klj . 7 ba
102003 Mustang Workshop Manual
18. 11. 2011file:///C:/Ford/2000 - 2004/tsocache/SHEF_5108/S3B~us~en~ ...

REMOVAL AND INSTALLATION
Door Glass Run Retainer
Removal
1. Remove the door trim panel. For additional information, refer to Section 501 - 05 .
2. Remove the watershield.
3. Position the door window glass in the full up position.
4. Remove the nuts and the door glass run.
Installation 1. To install, reverse the removal procedure.
SECTION 501-
11: Glass, Frames and Mechanisms 2003 Mustang Workshop Manual Klj . 1 ba
12003 Mustang Workshop Manual
18. 11. 2011file:///C:/Ford/2000 - 2004/tsocache/SHEF_5108/S3B~us~en~ ...

DESCRIPTION AND OPERATION
Instrument Panel
The instrument panel consists of the following components:
zinstrument cluster
z instrument panel finish panels
z audio unit
z A/C controls
z glove compartment door
z passenger air bag module
z glove compartment
z instrument panel steering column cover
z instrument panel reinforcement
z instrument panel defroster grille
SECTION 501-
12: Instrument Panel and Console 2003 Mustang Workshop Manual Klj . 1 ba
12003 Mustang Workshop Manual
18. 11. 2011file:///C:/Ford/2000 - 2004/tsocache/SHEF_5108/S3B~us~en~ ...

DESCRIPTION AND OPERATION
Console —
Floor
The floor console consists of the following components:
zconsole glove compartment
z console glove compartment door
z beverage holder
z cigar lighter knob and element
z power point
z glove compartment hinge
z console finish panel
z coin holder
z convertible top control switch (if equipped)
SECTION 501-
12: Instrument Panel and Console 2003 Mustang Workshop Manual Klj . 1 ba
12003 Mustang Workshop Manual
18. 11. 2011file:///C:/Ford/2000 - 2004/tsocache/SHEF_5108/S3B~us~en~ ...