2003 FIAT PALIO open bonnet

16
ENGINE BONNET
To open: pull lever A-fig. 22.
Press lever
Band lift the bonnet.
Insert the end of rod
A-fig. 23in
the recess
Bon the bonnet.
To close: remove rod
Afrom
recess
Band refit it in its clip. Lower
the bonnet until it is about 20 cm
above the engine compartment and
let it fall. Make sure the bonnet is
locked.
fig. 22
P4E02124
Open the boot only
when the car is station-
ary.
EXTENDING THE BOOT
For extending the boot space by
adjusting the rear seat refer to the
chapter on “Getting to know your
car”.
fig. 21
P4E01944
BOOT
From outside the car: use ignition
key to open.
From inside the car: pull lever
A-
fig. 21
.
Improper use of the
electrical windows can be
dangerous.
Before and during their opera-
tion ensure that passengers are
not at risk from the moving glass
either by personal objects getting
caught in the mechanism or by
being injured by it directly.
Always remove the ignition key
when you get out of the car to
prevent the electric windows be-
ing operated accidentally and
constituting a danger to the peo-
ple left in the car.
fig. 20
P4E01791
MANUAL WINDOWS fig. 20
To wind down/up the door win-
dows operate the command
Ahan-
dles.
1-19 03/03/2003 05:44 PM Page 16

17
DOORS
Turn the keyfig. 24:
1- door locked.
2- door unlocked
Pull the handle to open.
From inside:
– to open - pull handle
A-fig. 25;
– safety lock - with the door closed
press the lever
A.
It is possible to insert the safety
lock with open door only on the pas-
senger side on versions without cen-
tralized locking.
fig. 24
P4E01367
fig. 25
P4E02015
CENTRAL DOOR LOCKING
SYSTEM
To lock/unlock all the doors at the
same time:
– from outside the car, turn the key
in the lock;
– from inside the car, with closed
door, press (to lock) or pull(to
unlock) one of the front door open-
ing lever.
The bonnet should be
opened only when the
car is stationary.
fig. 23
P4E01365
1-19 03/03/2003 05:44 PM Page 17

54
When the engine is run-
ning, do not put hands
near moving elements.
Be very careful that scarves, ties
or loose clothing do not acciden-
tally get caught in moving parts;
this can be extremely dangerous.BONNET
To open the bonnet:
1) Pull lever A-fig. 63.
fig. 64
P4E02273
fig. 65
P4E01365
Before lifting the bonnet
check that the wind-
screen wiper arms are
not raised from the windscreen.
Important. Improper
positioning of the support
rod could cause the bon-
net fall violently.
This should only be done
when the car is station-
ary.
2)Press lever A-fig. 64.
3)Lift the bonnet and release the
support rod
A-fig. 65from its clip.
4)Insert the end of the rod in its re-
cess
Bon the bonnet.
fig. 63
P4E02037
20-63 03/03/2003 06:03 PM Page 54

55
To close the bonnet:
1) Hold the bonnet up with one hand
and with the other remove the rod
A-
fig. 65
from the recess Band replace
it in its clip.
2)Lower the bonnet until it is about
20 cm above the engine compartment.
3) Let it fall: the bonnet closes au-
tomatically.
ROOF RACK
Move the door weather strips aside
in the points shown in
fig. 66to reach
the fasteners.
When the engine is hot,
be very careful not to burn
yourself when operating
inside the engine compartment.
Keep your hands away from the
electric fan as it may switch on at
any time, even with the key re-
moved from the ignition switch.
Wait until the engine cools down.
Always make sure the
bonnet is closed properly
so it will not open whilst
the car is moving.
After travelling a few
kilometers, check that
the securing screws are
tight.
Never exceed the per-
mitted weight (see
“Technical specifications”
chapter).
Be careful not to dam-
age the objects on the
roof rack opening the tail-
gate.
20-63 03/03/2003 06:03 PM Page 55