2003 FIAT PALIO tow

IN AN EMERGENCY
People who find themselves in an emergency situ-
ation need immediate and concrete help.
The following pages have been written to help you
if the need arises.
As you will see, a host of little snags have been taken
into account and, for each of them, the measures you
yourself can take are suggested. If the problems are
more serious however, you should have the car seen
at a Fiat Dealership.
With regard to this, we would like to remind you
that, in addition to the Owners Handbook you have
also been provided with the Warranty Booklet
where you will find details of all the services Fiat can
provide should you find yourself in difficulty.
We nevertheless recommend you read these
pages. If in need you will be able to find the informa-
tion you require much more quickly.
In addition to this you have also been provided
with 24 hours service assistance booklet, where in
you can find nearest contact number and address for
24 hour service assistance.JUMP STARTING ...................................................... PAGE 81
BUMP STARTING .................................................... PAGE 82
IF A TYRE IS PUNCTURED .................................. PAGE 82
IF A BULB BURNS OUT ........................................ PAGE 86
IF AN EXTERIOR LIGHT BURNS OUT ............ PAGE 88
IF AN INTERIOR LIGHT BURNS OUT ............. PAGE 92
IF A FUSE BLOWS ................................................... PAGE 93
IF THE BATTERY IS FLAT ..................................... PAGE 98
IF THE CAR NEEDS TO BE RAISED .................. PAGE 99
IF THE CAR NEEDS TO BE TOWED ................. PAGE 101
IF AN ACCIDENT OCCURS ................................. PAGE 102
80
80-103 03/03/2003 06:49 PM Page 80

82
BUMP STARTING IF A TYRE IS
PUNCTURED
Follow the instructions on this and
the following pages to use the jack and
spare wheel correctly.
Remember that until
the engine has started the
brake booster and power
steering systems will not work
and a greater effort will therefore
be required to depress the brake
pedal or turn the steering wheel.
An incorrectly posi-
tioned jack may cause the
car to fall.
Do not use the jack to lift loads
exceeding that indicated on the
label attached to the jack itself.
The jack should only be used to
change a wheel on the car for
which it is designed. It should not
be put to other uses or employed
to raise other models of cars. Un-
der no circumstances should it be
used when carrying out repairs
under the car.
Do not lubricate the bolt
threads before fitting them back:
they could come loose.
Never start the engine,
when the car is raised on
a jack. Never tamper with
the inflation valve. Never place
tools between the rim and tyre.
Check the tyre and spare wheel
pressure regularly. The tyre in-
flation pressure is shown in the
“Technical specifications” chap-
ter.
Never bump start the
engine (by pushing, tow-
ing or coasting downhill).
This could cause fuel to flow in-
to the catalytic exhaust system
and damage it beyond repair.
If the car is fitted with al-
loy rims, a specific spare
wheel is provided. It is dif-
ferent from the one provided for
the cars fitted with steel rims. In
the event of successive purchase
of alloy rims, replacing the steel
rims, we suggest you to keep at
disposal 4 genuine bolts, which
will be used only with the spare
wheel. Danger of damaging the
wheel hubs
80-103 03/03/2003 06:49 PM Page 82

83
1. STOP THE CAR
– Stop the car in a position that is not
dangerous for oncoming traffic where
you can change the wheel safely. The
ground should be flat and adequately
firm. If you have to change the wheel
at night, choose a lit area if possible.
– Turn the engine off and pull up the
handbrake.
– Engage first or reverse gear.
– Alert other drivers that the car is
stationary in compliance with local
regulations: hazard warning lights,
warning triangle etc.
Any passenger should get out and
wait as far away as possible from the
dangers of traffic.
If the road is sloping or bumpy, place
wedges or other suitable material un-
der the wheels to prevent the car from
moving.
2. TAKE OUT THE TOOLS,
JACK AND SPARE WHEEL
They are in the boot.
The tool bag is secured to the inter-
nal boot wall by proper belts,
fig. 2;
to take it out, lift the adhesive strip of
the belts. The bag contains: the jack
A-
fig. 3
, the jack operating handle B, the
wheel bolt wrench
C, the tow hitch D
and the screwdriver E.
fig. 2
P4E02373
fig. 4
P4E02375
fig. 3
P4E02374
– Lift the carpet covered flap.
– Loosen the fastener
A-fig. 4and
take the spare wheel.
80-103 03/03/2003 06:49 PM Page 83

101
Do not tow the car by
using flexible elements
(metallic cables, ropes or
strings); only the use of a rigid
bar, with the ends supplied with
adequate joints, is allowed. Make
sure to fix the joint to the car in
order not to damage the near el-
ements.
Before starting to tow, turn the
ignition key to MAR and then to
STOP. Do not remove the key. If
the key is removed, the steering
lock engages automatically which
prevents the wheels being turned.
While the car is being towed
with the engine off, remember
that the brake pedal and steering
will require more effort as you no
longer have the benefit of the
brake booster and the power
steering.
The towing vehicle must be dri-
ven as evenly and softly as possi-
ble to prevent counterblows.IF THE CAR
NEEDS TO BE
TOWED
The tow hitch is supplied as standard
with the car. It is in the tool kit at-
tached to the spare wheel.
To fasten the tow hitch:
1)Take the tow ring.
2) Remove the cover from the rear
bumper
fig. 40or from the front
bumper
fig. 41by lever with a screw-
driver in the point shown by the ar-
row.
fig. 40
P4E02196
fig. 41
P4E02197
When towing the car,
you must comply with the
specific traffic regulations
regarding the tow hitch and how
to tow on the road.
3)Fasten the ring on the threaded
pin, rear
fig. 40or front fig. 41.
80-103 03/03/2003 06:49 PM Page 101

147
Spark plugs ................................... 121
Speedometer................................. 33
Starter (specifications) ............... 137
Starting the engine ...................... 65
- Jump starting ......................... 81
- bump starting ........................ 66-82
- ignition switch ....................... 21
- turning off the engine .......... 66
- starting procedure ................ 65
- engine warm up (just
started) ................................... 66
Steering column lock .................. 11-22
Steering column stalks ............... 13-41
Steering........................................... 135
Storing the car ............................. 78
Sun visors ...................................... 47
Suspensions .................................. 134
Symbols .......................................... 4
Technical specifications ........... 128
Third brake light ......................... 91Towing the car ........................... 101
Transmission ................................. 133
Transporting children in
safety .......................................... 29
Tubing ............................................ 123
Tyre pressure ......................... 121-143
Tyres
- specifications........................... 136
- Correct reading .................... 136
- maintenance .......................... 121
- inflation pressure ............ 121-143
- changing the wheel................ 82
Useful accessories ................... 79
Ventilation.................................. 40
Warning lights
- injection system failure ....... 35
- air bag failure ......................... 36- engaged handbrake .............. 35
- direction indicators ............. 36
- low brake-clutch fluid level 35
- low engine oil pressure........ 35
- low battery recharge ......... 35
- main beam headlights .......... 36
- Exterior lights ......................... 36
- unserviceable ABS ................. 36
Weights .......................................... 138
Wheel rims.................................... 136
- correct reading of the rim .. 136
Wheels
- wheel geometry ..................... 136
- specifications........................... 136
- maintenance .......................... 121
- replacement ........................... 82
Windows
- electric window winder .... 15-49
- manual window winder ...... 16-50
- cleaning operation ................. 126
Windscreen washer
- control .................................... 13-42
144-152 03/03/2003 07:30 PM Page 147

Specially designed for petrol and diesel en-
gines, the
VS MAXproducts guarantee fast,
complete engine lubrication and excellent
protection from wear.
GENERAL
PERFORMANCE
DETERIORATION
STANDARD OIL
IDEAL OIL
DISTANCE TRAVELLED
VS MAX
GENERAL PERFORMANCE
DETERIORATIONYOUR CAR
HAS CHOSEN VS
MAX
VS MAXis the result of combining tradition
with the experience of the A
FL Group lab-
oratories, which has been built up over the
years by experimental research on the
VS
line products. Its formula places it at the top
of the mineral. multi-grade oil classification.
Multi-purpose additives combined with se-
lect mineral bases ensure complete engine
protection and limit the oxidation processes
on the lubricant, and wear on the more del-
icate mechanical parts of the engine.
These characteristics are particularly im-
portant when driving the vehicle around
town where the lubricant is constantly un-
der stress due to continual stopping and
starting.
P4E02076
144-152 03/03/2003 07:30 PM Page 152