2003 FIAT PALIO key

Once you have released the lever,
check that the seat is firmly locked in
the runners by trying to move it back
and forth. Failure to lock the seat in
place could result the seat moving sud-
denly and the driver losing control of
the car.
Adjusting the reclining seat
back
Turn knob B-fig. 3until the back
reaches the reclination you desire.
Do not remove the seats
nor carry out mainte-
nance and/or repair oper-
ations on them. Improper oper-
ations can compromise safety de-
vice operation. Always go to a Fi-
at Dealership.
22
Moving the seat backwards or
forwards
Lift the lever A-fig. 3and push the
seat forwards or backwards; you are
in the correct position for driving
when your hands are resting on the
steering wheel rim and your arms are
slightly bent.
Only make adjustments
when the car is station-
ary.
STEERING COLUMN LOCK
Engagement:
After turning the key
to position STOP or PARK remove it
and turn the steering wheel till it locks .
To release: Gently move the steer-
ing wheel from side to side as you turn
the ignition key to
MAR.
Never remove the igni-
tion key while the car is
moving. The steering
wheel will automatically lock as
soon as you turn it. This also ap-
plies when the car is being towed.
INDIVIDUAL SET-
TINGS
FRONT SEATS fig. 3
fig. 3
P4E01989
20-63 03/03/2003 06:02 PM Page 22

35
WARNING
LIGHTS
The warning lights come on in the
following circumstances:
BATTERY NOT
CHARGING PROPER-
LY (red)
When there is
a fault in the current gen-
erating system.
Go to a
Fiat Dealershipand pre-
vent deploying the battery.
When the key is turned to
MAR the
light comes on but should go out the
moment the engine is started.
LOW ENGINE OIL
PRESSURE (red)
When
the engine oil pressure
drops under the normal
value.
When the key is turned to
MARthe
light comes on but should go out the
moment the engine is started.
A delay in the light going out is ac-
ceptable only when the engine is idling.
If the engine has been heavily taxed,
the light may flash when the engine re-
turns to idle. The light should howev-
er go out when you accelerate slight-
ly.
v
w
If the vwarning light
comes on while the car is
moving, stop the engine
immediately and contact a Fiat
Dealership.
INJECTION SYSTEM
FAILURE (red) (petrol
version)
When there is a
fault in the injection system.
When the ignition key is turned to
the
MAR position, the light comes on
but should go out after a few seconds.
The warning light will stay on or
come on when travelling to indicate
imperfect operation of the injection
system with possible loss of perfor-
mance, poor handling and higher con-
sumption.
g
In these conditions, you can contin-
ue driving but you should avoid de-
manding efforts from the engine or
high speeds. Contact a
Fiat Dealer-
ship
as soon as possible.
Using the car for long periods when
the warning light is on may cause dam-
age especially when the engine is run-
ning irregularly or misfiring. The car
should only be used for short periods
at low speeds.
Occasional and brief lighting of the
warning light is meaningless.
HANDBRAKE EN-
GAGED / LOW
BRAKE FLUID (red)
In
two cases:
1.When the handbrake is applied.
2. when the brake fluid level falls be-
low the minimum level.
x
20-63 03/03/2003 06:02 PM Page 35

ABS (WHEEL AN-
TILOCKING SYS-
TEM) FAILURE (am-
ber)
When there is a fail-
ure in the ABS system.
In this case, the normal braking sys-
tem continues to work although with-
out the ABS assistance. Hence, have
the car seen to at a
Fiat Dealership
as soon as possible.
The warning light should come on
when the key is turned to
MARand
go out after approximately 2 seconds.
DIRECTION INDICA-
TORS (green) (flash-
ing)
When the direction
indicator control stalk is
operated (arrows).
PARKING LIGHTS
(green)
When the
side/tail lights are switched
on.
RE
3
MAIN BEAM HEAD-
LIGHTS (blue)
When main beam head-
lights are switched on
1
AIR BAG FAILURE
(red)
When there is an
airbag system failure.
If the xwarning light
comes on when travel-
ling, check whether the
handbrake is engaged. If the
warning light stays on and the
handbrake is not engaged, stop
immediately and contact a Fiat
Dealership.
>
Warning light >, with
the engine running, nor-
mally indicates a fault in
the ABS system only. In this case,
the braking system is still effi-
cient, though without the an-
tilocking device. You are advised
to go immediately to the nearest
Fiat Dealership, driving in a man-
ner to avoiding sharp braking and
get the system checked.
û
The warning light should
come on when the key is
turned to MAR and go
out after approximately 4 sec-
onds. If the warning light either
does not come on or comes on
when travelling, stop immedi-
ately and go to a Fiat Dealership.
The warning light should come on
when the key is turned to
MARand
go out after approximately 2 seconds.
36
INJECTION SYSTEM
FAILURE (red) (diesel
versions)
When there is a fault in the injection
system.
The warning light should come on
when the ignition key is turned to
MARand go out after a few seconds.
The warning light will stay on or
come on when travelling to indicate
imperfect operation of the injection
system with possible loss of perfor-
mance, poor handling and higher con-
sumption.
In these conditions, you can contin-
ue driving but you should avoid de-
manding efforts from the engine or
high speeds. Contact a
Fiat Dealer-
ship
as soon as possible.
Prolonged use of the car with warn-
ing light can cause damage to the en-
gine, specially in the event of misfir-
ing. The car can only be driven for a
short period of time at low ratios.
Occassional and brief lighting of the
warning light is meaningless.
20-63 03/03/2003 06:02 PM Page 36

37
HEATING /CLIMATE CONTROL SYSTEM
1 -Windscreen defroster/demister
vents.
2 -Front side window
defroster/demister vents.
3 -Central and side directional vents.
4 -Side vents for sending air to
footwell.
P4E02020
fig. 27
WATER IN DIESEL
FUEL FILTER versions
(amber) (diesel version)
When there is water in the diesel fu-
el filter. have the condense drained
out by a Fiat Dealership.
GLOW PLUGS
(amber)
(diesel version)
When the ignition key is turned to
the
MARposition. The warning light
will go out when the glowplugs reach
the correct temperature.
The warning light has a diagnostic
function to signal pre-heating system
failures (cut-off or short-circuited
glow plugs, blown pre-heating control
unit power fuse, tripped pre-heating
control unit circuit surge and current
protections).
If the warning light flashes for 60 sec-
onds just before the engine is started,
the vehicle can still be started but a
Fiat Dealershipshould be contact-
ed as soon as possible to have the
anamoly rectified.
20-63 03/03/2003 06:02 PM Page 37

41
STEERING COL-
UMN STALKS
RIGHT -HAND STALK
This stalk groups together the out-
side lights and direction indicators.
Parking lights can only be switched
on when the ignition key is at
MAR.
When the parking lights are turned
on, the instrument panel and the var-
ious controls located on the dash-
board light up.
Side/taillights fig. 31
They come on when the ring is
moved from
Oto 3. On the in-
strument panel the relevant indicator
will come on
3.
Dipped beam headlights fig. 32
They come on turning the ring from
3to 2.
Main beam headlights fig. 33
They come on when the ring is at 2position, and the stalk is pushed for-
ward towards the dashboard.
Instrument panel indicator
1will-
light up.
Pull the stalk back towards the steer-
ing wheel to switch the beam head-
lights off.
fig. 32
P4E02025
fig. 33
P4E02026
fig. 31
P4E02024
20-63 03/03/2003 06:02 PM Page 41

42
fig. 36
P4E01686
To flash head lights fig. 34
Pull the stalk towards the steering
wheel (temporary position).
Direction indicators fig. 35
Move the stalk as follows:
downwards - to switch the right-
hand indicators on;
upwards - to switch the left-hand
indicators on.
Instrument panel warning light
y
will flash.
The direction indicators will auto-
matically be switched off when the
steering wheel is straightened.
If you want the indicator to flash
briefly to show that you are about to
change lane, move the stalk up or
down without clicking into position.
When you let it go it will return to its
original position.
LEFT-HAND STALK
This stalk groups together all the
washer/wiper controls.
Windscreen washer/wiper
fig. 36
The device will only work when the
ignition key is at
MAR.
A- Windscreen wiper off.
B- Flick wipe.
C- Slow continuous wipe.
D- Fast continuous wipe.
E- Temporary continuous wipe:
when released the stalk returns to po-
sition
Aand automatically stops the
windscreen wiper.
fig. 35
P4E02028
fig. 34
P4E02027
20-63 03/03/2003 06:02 PM Page 42

43
Pull the stalk towards the steering
wheel
fig. 37 to operate the wind-
screen washer.
The use of hazard lights
is governed by the High-
way Code of the country
you are in. Keep to the rules
CONTROLS
HAZARD LIGHTS fig. 39
Press switchA, regardless of the po-
sition of the ignition key.
The symbol
Aon the switch will flash
when the device is on.
Press the switch again to switch the
lights off.
fig. 37
P4E01687
fig. 38
P4E01688
fig. 39
P4E02286
Rear window wiper/washer
fig. 38
This function can only be used when
the ignition key is at
MAR.
Controls:
1)turn the control from Oto ' ';
2)When you push the stalk for-
wards (temporary position), the rear
window washer will send a jet of flu-
id onto the window and the wiper will
be operated at the same time. The de-
vice will be switched off when the stalk
is released.
20-63 03/03/2003 06:02 PM Page 43

44
fig. 41
P4E02029
fig. 40
P4E02287
CONTROLS
fig. 40
The buttons located above the cen-
tral air vents.
The controls can only be operated
when the ignition key is at
MAR.
When a function is activated the LED
on the respective button will light up.
Press the button again to switch the
control off.
Heated rear window
Button A: to switch on /off the ther-
mal rear window.
Rear fog light
Button B: These lights can only be
switched on when the dipped beam
headlights or the front foglights are
switched on.
Fog lights
ButtonB: These lights can only be
switched on when the parking lights
are on.
Climate control system
Button C: to switch on/off the air
conditioner.
FUEL CUT-OFF SWITCH
fig. 41
This is a safety cut-off switch which
comes into operation in the case of an
accident to block the supply of fuel
thereby stopping the engine.
If, after an accident, you
can smell petrol or see
that the fuel feed system
is leaking, to avoid the risk of fire,
do not reset the switch.
If you cannot see any fuel leaks and
the car is in a fit state to continue its
20-63 03/03/2003 06:03 PM Page 44