2003 FIAT BARCHETTA remove seats

18
If the ignition switch has
been tampered with (e.g.
someone has tried to steal your
car), get a Fiat Dealership to make
sure it is still functioning properly
before you start driving again.
WARNING
Always remove the ignition
key when you get out of the
car. This will prevent anyone from
accidentally working the controls.
Remember to apply the handbrake
and, if the car is pointing uphill, first
gear. Put the car into reverse if it
is pointing downhill. Never leave
children in the car by themselves.
WARNING
STEERING COLUMN LOCK
To engage the lock: remove the
ignition key from either theSTOP or
PARKposition, and turn the steering
wheel until it locks.
To release: move the steering
wheel slightly as you are turning the
ignition key to MAR.INDIVIDUAL
SETTINGS
All seat adjustments must
be made when the car is
stationary.
WARNING
SEATS fig. 12
Moving the seat backwards
or forwards
Lift lever Aand push the seat for-
wards or backwards: you are in the
correct position for driving when your
hands are resting on the steering
wheel rim and your arms are slightly
bent.
fig. 12
P5S00627m
Never remove the ignition
key while the car is moving.
The steering wheel would auto-
matically lock as soon as you tried
to turn it. This also applies when
the vehicle is being towed.
WARNING

70
PARKING
Turn off the engine, pull up the hand-
brake, put the car in gear (1st if the car
is pointing uphill, reverse if downhill)
and turn the wheels. If the car is on a
steep incline, you should put a stone
or wedge under the wheels to block
them.
Do not leave the ignition key at
MAR because it drains the battery.
Always remove the key when you
leave the car.IMPORTANTIf this is not the
case, have the handbrake adjusted at
a Fiat Dealership.
When the hand brake is on and the
ignition key is at MAR, panel indica-
tor light xcomes on.
To release the handbrake:
1) Slightly lift the handbrake and
press release button A.
2) Keep the button pressed in and
lower the lever. Instrument panel in-
dicator light xwill go out.
3) To prevent the vehicle acciden-
tally moving, carry out this manoeuvre
with the brake pedal pressed. HANDBRAKE fig. 1
The handbrake lever is situated be-
tween the two front seats.
To operate the handbrake pull the
lever upwards until the car is pre-
vented from moving: pulling the lever
through four or five “clicks” is gener-
ally enough on level ground while nine
or ten might be necessary on a steep
incline and with a load in the car.
fig. 1
P5S00678mDo not leave children
unsupervised in the car.
WARNING

134
If the stain does not come out, use
a special cleaning compound being par-
ticularly careful to follow the instruc-
tions for use.
IMPORTANTNever use alcohol
or alcohol-base products.
PLASTIC PARTS INSIDE
THE CAR
Use special products designed not to
alter the appearance of the compo-
nents.
IMPORTANT Do not use alcohol
or petrol for cleaning the glass of the
instrument panel. CLEANING THE SEATS AND
FABRIC UPHOLSTERY
– Remove the dust with a soft brush
or a vacuum cleaner.
– Rub the seats with a rag moistened
in a solution of water and neutral de-
tergent.
CLEANING LEATHER SEATS
– Remove the dry dirt with a buck-
skin or very slightly moist cloth with-
out exerting too much pressure.
– Remove liquid or grease stains with
a dry absorbent cloth without rubbing.
Then wipe with a buckskin or soft
cloth moistened with water and neu-
tral soap.
Do not keep aerosol cans in
the car. There is the risk
they might explode. Aerosol cans
must never be exposed to a tem-
perature above 50°C. The temper-
ature inside the car might go well
beyond that figure if the car is ex-
posed to the sun.
WARNING

155
HARD TOP
The hard top is fitted with a heated
rear window and can be installed in
place of the hood to provide maxi-
mum comfort during winter.
The hard top is not only on offer as
an optional extra, but is also part of
the Lineaccessori Fiat line, and is
therefore available even after the car
has been purchased.
When the hard top is bought from
Lineaccessori Fiat, pin seats and fixing
screws are also supplied.The seats must be fixed to the rear
pillars that have 2 threaded holes and
can be left in place even when the hard
top is no longer used.
When the hard top is mounted for
the first time, it is necessary to adjust
the rear tie rods.You should have these operations
carried out at a Fiat Dealership.
See the chapter “Getting to know
your car” for instructions on how to
fit and remove the hard top correct-
ly.