2003 FIAT BARCHETTA key

18
If the ignition switch has
been tampered with (e.g.
someone has tried to steal your
car), get a Fiat Dealership to make
sure it is still functioning properly
before you start driving again.
WARNING
Always remove the ignition
key when you get out of the
car. This will prevent anyone from
accidentally working the controls.
Remember to apply the handbrake
and, if the car is pointing uphill, first
gear. Put the car into reverse if it
is pointing downhill. Never leave
children in the car by themselves.
WARNING
STEERING COLUMN LOCK
To engage the lock: remove the
ignition key from either theSTOP or
PARKposition, and turn the steering
wheel until it locks.
To release: move the steering
wheel slightly as you are turning the
ignition key to MAR.INDIVIDUAL
SETTINGS
All seat adjustments must
be made when the car is
stationary.
WARNING
SEATS fig. 12
Moving the seat backwards
or forwards
Lift lever Aand push the seat for-
wards or backwards: you are in the
correct position for driving when your
hands are resting on the steering
wheel rim and your arms are slightly
bent.
fig. 12
P5S00627m
Never remove the ignition
key while the car is moving.
The steering wheel would auto-
matically lock as soon as you tried
to turn it. This also applies when
the vehicle is being towed.
WARNING

20
DRIVING MIRROR fig. 15
You can adjust the mirror by moving
lever A:
1) normal position
2) anti-dazzle positionDOOR MIRRORS fig. 16
Adjustment by hand
Move the mirror at the four points
as shown in the figure to adjust its po-
sition.
If the mirror makes it
difficult to get through
narrow gaps, fold it from
position 1 to position 2.Electric adjustment
(where fitted)
The mirrors can only be adjusted
electrically when the ignition key is at
MAR.
All you need to do is press the four
directions on switch Ato perform this
operation.
Switch Bselects the mirror (right or
left) to be adjusted.
You are advised to position the mir-
ror when the car is stationary and the
handbrake is on.
fig. 16
P5S00631m
fig. 15
P5S00630m

21
SEAT BELTS
HOW TO USE THE SEAT
BELTS fig. 17When the driver’s seat belt is not fas-
tened, instrument panel indicator light
turned to MAR.
Press button Cto unfasten the belts.
Keep holding the belt as it rewinds to
prevent it from getting twisted.The seat belt retractor will adapt the
belt to the body of the person wear-
ing it to give him/her freedom of
movement. The retractor could lock
when the vehicle is parked on a steep
slope, but this should be considered
normal.
In addition, the reel mechanism
blocks the belt when it is jerked or if
the car brakes sharply, is in a collision
or when taking bends at high speed.
To fasten the seat belts, take the
tongue of fastener Aand push it into
buckle Buntil you hear it click.
If the belt jams, let it rewind for a
short stretch, then pull it out again
without jerking.
Before fastening the seat
belts, check they pass
through the slots at the top of the
seat back behind the shoulder.
WARNING
For maximum safety, keep
the back of your seat up-
right, lean back into it and make
sure the seat belt fits closely across
your chest and hips.
WARNING
fig. 17
P5S00632m

ENGINE CONTROL
SYSTEM FAILURE
(EOBD) (amber)
In normal conditions, the warning
light will come on when the ignition
key is turned to MARand should go
out as soon as the engine is started.
The initial lighting up shows that the
warning light is working properly.
If the warning light either stays on or
comes on while travelling:
1.Fixed light - warning of a fuel
feed/ignition system failure which may
increase emissions in exhaust or cause
possible drops in performance, poor
handling and high consumption. In such
conditions, you can continue driving
but you should not tax the engine and
you should moderate the speed. Pro-
longed use with the warning light on
can cause damage. Contact aFiat
Dealershipas soon as possible.
The warning light will go out when
the failure disappears. In any case, the
system will store the error. ENGINE OIL
PRESSURE TOO
LOW (red)
When the pressure of the oil in the
engine falls below the normal level.
The light comes on when you turn
the ignition key to MARbut it should
go out when the engine starts.
A delay in the light going out is ac-
ceptable only when the engine is idling.
If the engine has been taxed heavily,
the light might flash when idling but
should go out on accelerating slightly.
30
v
U
INDICATOR AND
WARNING LIGHTS
These light up in the following cas-
es:2.Flashing light - warning that the
catalyser may be damaged (see
“EOBD system” in this chapter). If the
warning light starts flashing, release the
accelerator pedal and slow the engine
until the warning light stops flashing.
Continue driving at moderate speed,
preventing the warning light from
coming on again. Contact a Fiat Deal-
ership as soon as possible.
Contact a Fiat Dealer-
ship as soon as possible if
the
Uwarning light ei-
ther does not come on when the
key is turned to MAR or comes
on, with fixed or flashing light,
when travelling.
If the warning light comes
on when the vehicle is mov-
ing, switch off the engine and con-
tact a Fiat Dealership.
WARNING

ABS (ANTI-LOCK
BRAKING SYSTEM)
INEFFICIENT
(amber) (where fitted)
When the ABS device is faulty.
The normal braking system contin-
ues to work but you should have the
car seen to at a Fiat Dealership.
When the key is turned toMARthe
warning light will come on but should
go out after about 2 seconds. HANDBRAKE ON/
BRAKE FLUID
LEVEL LOW (red)
In two cases:
1. When the handbrake is applied.
2. When the brake fluid level falls be-
low the minimum.BATTERY NOT
RECHARGED
PROPERLY (red)
When there is a malfunction in the
current generating system.
The light comes on when you turn
the ignition key to MARbut it should
go out when the engine starts.
FRONT BRAKE
WEAR (red)
When the front brake
pads have worn out. When having
them replaced, have the rear brakes
checked, too.
31
w>
d
x
If the xwarning light
comes on while travelling,
check that the handbrake is not en-
gaged. If the warning light stays on
when the handbrake is disengaged,
stop immediately and contact a Fi-
at Dealership.
WARNING
The car is fitted with an
electronic braking device
(EBD). If the >and xwarning
light turn on at the same time, this
means that there is an EBD system
fault. In this case violent braking
may be accompanied by early rear
wheel locking with the possibility of
skidding. Drive the car extremely
carefully to the nearest Fiat Deal-
ership to have the system checked.
WARNING

HAZARD LIGHTS
(red) (flashing)
When the hazard lights
are on.AIRBAG OR
PRETENSIONER
FAILURE (red)
When the system is not working
properly or has been triggered.
SEAT BELTS NOT
FASTENED (red)
When the driver’s seat
belt is not fastened properly. CATALYTIC
CONVERTER HOT
(red) (where fitted)
When the temperature of the cat-
alytic converter is extremely high: the
warning light will go out as soon as the
temperature drops to normal.
32
<
f¬
r
When you turn the ignition
key to the MAR position
this light comes on. It should, how-
ever, go out after about four sec-
onds. If the light stays on or comes
on while the car is moving, stop at
once and have the car seen to at a
Fiat Dealership.
WARNING
The lighting of warning
light >when the engine is
running normally indicates a fault
in the ABS system only. In this case,
the braking system will still be ef-
fective without the anti-lock device.
In these conditions EBD system op-
eration can be reduced. Also in this
case we recommend immediately
taking the car to a Fiat Dealership
avoiding sudden braking to have
the system checked.
WARNING

MAIN-BEAM
HEADLIGHTS (blue)
When the main-beam
headlights are turned on.OUTSIDE LIGHTS
(green)
When the side and tail-
lights are turned on.
DIRECTION
INDICATORS
(green) (flashing)
When the direction indicator control
stalk is used.FUEL RESERVE
(amber)
When about 5 litres of
fuel are left in the fuel tank.PASSENGER
SIDE AIRBAG
DEACTIVATED
(amber) (where fitted)
When the passenger side airbag is
deactivated. FIAT CODE (amber)
In three cases (with igni-
tion key at MAR):
1. A single flash - indicates that the
key code has been recognised. The en-
gine can be started.
2. A constant light - indicates that the
key code has not been recognised. To
start the engine, follow the emergency
start-up procedure described in the
“In an emergency” section.
3. A flashing light - indicates that the
car is not protected by the immobilis-
er system. The engine can however be
started.
33
°
RE
3
1
¢F

38
STEERING
COLUMN STALKS
LEFT-HAND STALK
The left-hand stalk brings together
the outside light and direction indica-
tor controls.
The outside lights can only come on
if the ignition key is at MAR.
When the outside lights are turned
on, the instrument panel and the var-
ious controls mounted on the dash-
board light up.Side and taillights fig. 35
These come on when you turn
knurled switch from O to 6. Instru-
ment panel indicator light 3comes
on.
Dipped beam headlights fig. 36
These come on when you turn the
knurled switch from 6to 2.Main-beam headlights fig. 37
These come on when you press the
stalk towards the dashboard while the
knurled switch is at 2.
Instrument panel indicator light 1
comes on.
To turn off the main-beam headlights,
pull the stalk back towards the steer-
ing wheel
fig. 35
P5S00644m
fig. 36
P5S00645m
fig. 37
P5S00646m