Page 10 of 386
Power Seat
If your vehicle has this feature, there will be controls
located on the inboard side of the driver’s seat.
Manual Lumbar
To raise or lower the front of the seat cushion, raise or
lower the lever located toward the front of the vehicle.
To raise or lower the rear of the seat cushion, raise
or lower the lever located toward the rear of the vehicle.
To move the entire seat backwards, forward, or up or
down, move the center knob.
If your vehicle has this feature, there will be a knob
located on the inboard side of the driver’s and
passenger’s bucket seats.
Turn the knob toward the front of the vehicle
to increase
lumbar support. Turn the knob toward the rear of the
vehicle to decrease lumbar support.
1 -3
Page 305 of 386

Aluminum Wheels
Keep your wheels clean using a soft clean cloth
with mild soap and water. Rinse with clean water.
After rinsing thoroughly, dry with a
soft clean towel.
A wax may then be applied.
The surface of these wheels is similar
to the painted
surface of your vehicle. Don’t use strong soaps,
chemicals, abrasive polishes, abrasive cleaners,
cleaners with acid, or abrasive cleaning brushes on
them because you could damage the surface.
Do not use chrome polish on aluminum wheels.
Don’t take your vehicle through an automatic car wash
that has silicone carbide tire cleaning brushes. These
brushes can also damage the surface of these wheels.
Tires
To clean your tires, use a stiff brush with tire cleaner.
Nofice: When applying a tire dressing, always take
care to wipe
off any overspray or splash from all
painted surfaces
on the body or wheels of the
vehicle. Petroleum-based products may damage
the paint finish and tires.
Sheet Metal Damage
If your vehicle is damaged and requires sheet metal
repair or replacement, make sure the body repair shop
applies anti-corrosion material to parts repaired or
replaced
to restore corrosion protection.
Original manufacturer replacement parts will provide the
corrosion protection while maintaining the warranty.
Finish Damage
Any stone chips, fractures or deep scratches in the
finish should be repaired right away. Bare metal
will corrode quickly and may develop into major
repair expense.
Minor chips and scratches can be repaired with touch-up
materials avaliable from your dealer or other service
outlets. Larger areas
of finish damage can be corrected
in your dealer’s body and paint shop.
5-88
Page 375 of 386

Loading Your Vehicle ....................................... 4-29
Locks Door
........................................................... 2-7
Front Doors
.................................................. 2-8
Leaving Your Vehicle
.................................... 2-10
Power Door
.................................................. 2-8
Programmable Automatic Door Locks
............... 2-9
Long Trip/Highway Definition
.............................. 6-6
Long Trip/Highway Intervals
............................... 6-6
Long Trip/Highway Scheduled Maintenance
........ 6-1 8
Loss
of Control ............................................... 4-1 3
Low Fuel Warning Light
................................... 3-37
Lumbar
Luggage
Carrier
.............................................. 2-44
Manual Controls
............................................ 1-3
M
Maintenance. Normal Replacement Parts .......... 5-1 01
Maintenance Schedule At Each Fuel Fill
......................................... 6-26
At Least Once a Month
................................ 6-26
At Least Once a Year
.................................. 6-27
At Least Twice a Year
.................................. 6-26
Brake System Inspection
.............................. 6-31
Engine Cooling System Inspection
................. 6-30
Fuel System Inspection
................................ 6-30
How This Section is Organized
....................... 6-3
Exhaust System
Inspection
........................... 6-30 Maintenance Schedule (cont.)
Introduction
.................................................. 6-2
Long Trip/Highway Scheduled Maintenance
..... 6-18
Maintenance Requirements
............................. 6-2
Part A
. Scheduled Maintenance Services ......... 6-4
Part B
. Owner Checks and Services ............. 6-26
Part C
. Periodic Maintenance Inspections ...... 6-30
Part D
- Recommended Fluids and
Lubricants
............................................... 6-32
Part E
. Maintenance Record ........................ 6-34
Selecting the Right Schedule
.......................... 6-5
Short Trip/City Scheduled Maintenance
............. 6-7
Steering, Suspension and Front Drive Axle
Boot and Seal Inspection
.......................... 6-30
Using Your
................................................... 6-4
Your Vehicle and the Environment
................... 6-2
Maintenance When Trailer Towing
..................... 4-40
Throttle
System Inspection
............................ 6-31
Making Turns
................................................. 4-38
Malfunction Indicator Light
................................ 3-30
Manual Lumbar Controls
.................................... 1-3
Manual Seats
................................................... 1-2
Manual Windows
........................................ 2-16
Mirrors Manual Rearview Mirror
................................ 2-32
Outside Convex Mirror
................................. 2-33
Outside Manual Mirrors
................................ 2-32
Outside Power Mirrors
.................................. 2-32
Model Reference
............................................ vi
8